Краткое содержание страницы № 1
Installation instructions
and User guide
Freestanding cooker
OR60 & OR90 models
NZ
Краткое содержание страницы № 2
Краткое содержание страницы № 3
1 Contents Safety and warnings 2 Installation instructions - OR60 models 6 Installation instructions - OR90 models 14 Using your oven 24 Cooking functions 26 Using your gas cooktop 27 Cooktop troubleshooting 31 Care and cleaning 32 Warranty and service 40 Important! SAVE THESE INSTRUCTIONS The models shown in this User Guide may not be available in all markets and are subject to change at any time. For current details about model and specification availability in your countr
Краткое содержание страницы № 4
2 Safety and warnings Installation WARNING! Electrical Shock Hazard Always disconnect the cooker from the mains electricity supply before carrying out any maintenance operations or repairs. Failure to follow this advice may result in death or electrical shock. WARNING! Cut Hazard Take care - panel edges are sharp. Failure to use caution could result in injury or cuts. Important safety instructions General To avoid hazard, follow these instructions carefully before installing or using this
Краткое содержание страницы № 5
3 Safety and warnings The appliance must be connected to the mains electricity supply, checking that the voltage corresponds to the value given in the rating plate and that the electrical cable sections can withstand the load specified on the plate. A suitable disconnection switch must be incorporated in the permanent wiring, mounted and positioned to comply with the local wiring rules and regulations. The switch must be of an approved type installed in the fixed wiring and provide a 3 m
Краткое содержание страницы № 6
4 Safety and warnings Operation Your freestanding cooker has been carefully designed to operate safely during normal cooking procedures. Please keep the following guidelines in mind when you are using it: WARNING! Explosion Hazard Do not store flammable materials such as gasoline near the cooktop. Do not store flammable material in the oven, drawer or storage compartment. Do not spray aerosols near the cooktop during use. Failure to follow this advice may result in death or serious inju
Краткое содержание страницы № 7
5 Safety and warnings Important safety precautions Never leave the appliance unattended when in use. Boilover causes smoking and greasy spillovers that may ignite. Isolating switch: make sure this cooker is connected to a circuit which incorporates an isolating switch providing full disconnection from the power supply. Household appliances are not intended to be played with by children. Children, or persons with a disability which limits their ability to use the appliance, should have
Краткое содержание страницы № 8
6 I Installa nstallation instruc tion instructions tions Dimensions and clearances Installation clearances and protection of combustible surfaces shall comply with the current local regulations eg. AG 601 (AS5601/NZS5261) Gas Installations code. Installation shall comply with the dimensions in Fig. 1, bearing in mind the following requirements: Overhead Clearances In no case shall the clearance above the highest part of the cooker be less than 600 mm or, for an overhead exhaust fan, 750 mm. A
Краткое содержание страницы № 9
7 Installation instructions Levelling the cooker Important! Using the supplied adjustable feet is MANDATORY. For safety reasons and to ensure adequate ventilation, the cooker chassis MUST NOT sit directly on the floor, a plinth, or other support surface. To fit the adjustable feet: 1 Rest the rear of the cooker on a piece of packaging, exposing the base for fitting the feet. 2 Screw the four feet to the cooker. 3 Stand the cooker and level it by screwing or unscrewing the feet Fig.
Краткое содержание страницы № 10
365 235 600 mm (Cavity width) 8 Installation instructions Fitting the anti-tilt bracket Important! To restrain the appliance and prevent it tipping accidentally, fit a bracket to its rear to fix it securely to the wall. Make sure you also fit the supplied lock pin to the anti-tilt bracket. To fit the anti-tilt bracket: 1 After you have located where the cooker is to be positioned, mark on the wall the 0 place where the two screws of the anti-tilt + 15 + 15 bracket have to be fitted. Please
Краткое содержание страницы № 11
9 Installation instructions Connecting the cooker to the gas supply The gas connection must be carried out by an authorised person according to the relevant standards. Before connecting the appliance to the gas main, mount the brass conical adaptor onto the gas inlet pipe, upon which the washer has been placed (see Figs. 4-5 following). Conical adaptor and washer are supplied with the appliance (packed with conversion kit for use with Natural gas or LPG). This appliance is suitable f
Краткое содержание страницы № 12
10 Installation instructions It is important that the hose does not come in contact with the metal of the appliance and is secured as per appropriate gas installation codes. A chain 80% of the length of the flexible gas hose must be used to prevent stress being applied to the hose. The chain should be attached securely to the product where shown (see Fig.7), and on the wall. Flexible hose assemblies should be AS/NZS 1869 Class B or Class D certified. The thread connection shall be Rp ½
Краткое содержание страницы № 13
11 Installation instructions Converting to a different gas type This appliance is suitable for use with Natural gas or LPG (check the “gas type” sticker attached to the appliance). To convert from one gas type to another, you need to replace the injectors, and then adjust the minimum burner setting. Replacing the injectors 1 Remove the trivets and burners from the cooktop. 2 Using a spanner, remove the injector (shown in Figs. 8-9 following) and replace it with one according to the gas type
Краткое содержание страницы № 14
12 Installation instructions Adjusting the minimum burner setting Check whether the flame spreads to all burner ports when the burner is lit with the gas valve set to the minimum position. If some ports do not light, increase the minimum gas rate setting. Check whether the burner remains lit even when the gas valve is turned quickly from the maximum to the minimum position. If the burner does not remain lit, increase the minimum gas rate setting. To adjust the minimum gas rate setting: 1
Краткое содержание страницы № 15
13 Installation instructions Wiring diagram Cod. 1131682 OR60 MODELS
Краткое содержание страницы № 16
14 I Installa nstallation instruc tion instructions tions Dimensions and clearances Installation clearances and protection of combustible surfaces shall comply with the current local regulations eg. AG 601 (AS5601/NZS5261) Gas Installations code. Installation shall comply with the dimensions in Fig. 11, bearing in mind the following requirements: Overhead Clearances In no case shall the clearance above the highest part of the cooker be less than 600 mm or, for an overhead exhaust fan, 750 mm.
Краткое содержание страницы № 17
15 Installation instructions Dotted line showing the Locating the area for gas and electrical connection position of the cooker when installed Area for gas and electrical connections Fig. 12 Area for gas and electrical connections Fitting the adjustable feet Important! Using the supplied adjustable feet is MANDATORY. For safety reasons and to ensure adequate ventilation, the cooker chassis MUST NOT sit directly on the floor, a plinth, or other support surface. Fit the adjustable feet bef
Краткое содержание страницы № 18
16 I Installa nstallation instruc tion instructions tions Moving the cooker Important! To prevent damaging the adjustable feet, ensure the cooker is always lifted by two people. Do not lift the cooker by the door handle. DO NOT DRAG the cooker. Lift the feet clear of the floor. Fig. 16 Correctly lifting the cooker Fig. 17 Incorrectly moving the cooker Fig. 18 Incorrectly lifting the cooker Fixing the backguard C B Before installing the cooker, assemble the backguard “C” . The backguard “C”
Краткое содержание страницы № 19
450 450 900 mm 17 Installation instructions Fitting the anti-tilt bracket Important! To restrain the appliance and prevent it tipping accidentally, fit a bracket to its rear to fix it securely to the wall. Make sure you also fit the supplied lock pin to the anti-tilt bracket. To fit the anti-tilt bracket: 1 After you have located where the cooker is to be positioned, mark on the wall the place where the two screws of the anti-tilt 0 bracket have to be fitted. Please follow the + 25 indica
Краткое содержание страницы № 20
18 Installation instructions Connecting the cooker to the gas supply The gas connection must be carried out by an authorised person according to the relevant standards. Before connecting the appliance to the gas main, mount the brass conical adaptor onto the gas inlet pipe, upon which the washer has been placed (see Figs. 21-22 following). Conical adaptor and washer are supplied with the appliance (packed with conversion kit for use with Natural gas or LPG). This appliance is suitable
