Краткое содержание страницы № 1
2-Line Intercom Speakerphone
DECT6.0 Cordless Handset
Telephone Answering System
User’s Guide
Please read this manual
before operating product
for the first time.
Model 25210
Краткое содержание страницы № 2
Important Information Important Information NOTICE: This product meets the applicable Industry Canada technical specifications. Operation is subject to the following two conditions: (1) This device may not cause interference, and (2) This device must accept any interference, including interference that may cause undesired operation of the device. The equipment must be installed using an acceptable method of connection. The customer should be aware that compliance with the above conditions
Краткое содержание страницы № 3
Important Information Telephone Network Information Should your equipment cause trouble on your line which may harm the telephone network, the telephone company, where practicable, may notify you that temporary discontinuance of service may be required. Where prior notice is not practicable and the circumstances warrant such action, the telephone company may temporarily discontinue service immediately. The telephone company may make changes in its communications facilities, equipment, opera
Краткое содержание страницы № 4
Table of Contents Iantmport ItInforma on ............................2 Schingwit Between the SPeakerPhone , Interference ItInforma on .........................2 h anDSet , anD h eaDSet m oDe ............ 21 t elephone n etwork ItInforma on ..............3 BS a e .................................................. 21 l IcensIng ................................................3 c orDSS le h anDSet ............................. 21 h Iear ng a Id c Itaomp bIlIty .......................3 m ute .....
Краткое содержание страницы № 5
Table of Contents m emory l og and p hone b ook (d Ioryrect ) m emory ............................................28 a DDing Phone Book e ntrieS ................... 29 s orIt ng r ecord In o ne -t ouch d IalIng (o ynl Iappl cable for base ) ...........................29 r eviewing Phone Book r ecorDS ............ 29 e Diting a Phone Book r ecorD ................ 30 c oPying a Phone Book r ecorD .............. 30 Deleting a Phone Book r ecorD ............. 31 Dialing a Phone Book r D ecor .....
Краткое содержание страницы № 6
Connections & Setup Introduction CAUTION: When using telephone equipment, there are basic safety instructions that should always be followed. Refer to the IMPORTANT SAFETY INSTRUCTIONS provided with this product and save them for future reference. IMPORTANT: Because cordless phones operate on electricity, you should have at least one phone in your home that isn’t cordless, in case the power in your home goes out. Parts Checklist Make sure your package includes the following items: Base Batt
Краткое содержание страницы № 7
Connections & Setup Installation Digital Security System Your cordless phone uses a digital security system to protect against false ringing, unauthorized access, and charges to your phone line. INSTALLATION NOTE: Some cordless telephones operate at frequencies that may cause or receive interference with nearby TVs, microwave ovens, and VCRs. To minimize or prevent such interference, the base of the cordless telephone should not be placed near or on top of a TV, microwave ovens, or VCR. If
Краткое содержание страницы № 8
Connections & Setup Handset Layout Visual Indicator display 3 Soft keys DND/Privacy Spk (button) (Speaker button) Exit (button) CID (button) VOL +/- Off (buttons) (button) DIR (button) Talk #Pause (button) (button) Redial *Tone (button) (button) Mute/Del (button) Int/Hold Menu/Flash (button) (button)
Краткое содержание страницы № 9
Connections & Setup Base Layout Privacy (button) DND Voice mail1 (button) CID (button) (button) Delete DIR (button) Voice mail2 (button) (button) Vol +/- (buttons) One Touch Exit 3 Soft Keys (1-10) (button) buttons #Pause Charge (button) LED Line 1 & 2 Mute Speaker (buttons) (button) Headset (button) (button) Intercom Flash (button) (button) Page Hold (button) (button) Redial (button)
Краткое содержание страницы № 10
Connections & Setup Installing the Phone Installing the Handset Battery NOTE: You must connect the handset battery before use. CAUTION: To reduce the risk of fire or personal injury, use only the Thomson Inc. approved Nickel-metal Hydride (Ni- MH) battery model 5-2734, which is compatible with this unit. 1. Locate battery which is packaged inside a plastic bag and is separate from the handset. 2. Locate the battery compartment on the back of the handset. 3. Plug the battery pack cord into the
Краткое содержание страницы № 11
Connections & Setup Base Station The phone may be connected to two line (RJ14C) wall jacks to accommodate all two lines. 1. Choose an area near an electrical outlet and a telephone wall jack (RJ11C), and place your cordless telephone on a level surface, such as a desktop or tabletop, or you may mount it on the wall. 2. Plug the power supply cord into the power jack on the back of the base and the other end into an electrical outlet. CAUTION: To reduce risk of personal injury, fire, or damag
Краткое содержание страницы № 12
Connections & Setup 4. If you want to mount the telephone on the wall, you can plug the 2 lines such as the below drawing; Line 2 Line 1 -OR- Line 2 Line 1 -OR- Line 1 + 2 12
Краткое содержание страницы № 13
Programming the Telephone 5. Place the handset in the base cradle. The charge indicator illuminates, verifying the battery is charging. 6. Allow the phone to charge for 14 hours prior to first use. If you don’t properly charge the phone, battery performance is compromised. NOTE: If the model you bought is a RE2 version, there is one additional charger. Plug the power supply cord into the power jack on the back of the charger and the other end into an electrical outlet. Place handset in the
Краткое содержание страницы № 14
Programming the Telephone Phone Setting 1. Make sure your phone is OFF (not in Talk mode). 2. Press the Menu button on HS or the MENU soft key (left) on BS to go to the main menu. 3. Press VOL (+ or -) button to scroll to Phone Setting. 4. Press SELECT soft key (right) to confirm and you may program the following items: Date/Time (base only), Auto Answer (handset only), Auto Answer Intercom (both base and handset), Dial Mode (base only), Area Code (base only), Registration (handset only
Краткое содержание страницы № 15
Programming the Telephone Auto Answer (only applicable for handset) This option allows you to pick up the handset from base to answer an incoming call without pressing the Talk/Spk/L1/L2 button. When it is set to off, this function is disabled in this handset. From the Phone Setting Menu: 1. Press the VOL (+ or -) button to scroll to the Auto Answer. 2. Press SELECT soft key. Use the VOL (+ or -) button to scroll to your selection. The default setting is Off. 3. Press SELECT soft key to save
Краткое содержание страницы № 16
Programming the Telephone Registration (only applicable to handset) A cordless handset will not operate until it is registered to the base. During the registration process, keep the handset near the base. Up to 10 cordless handsets can be registered to one base. NOTE: If a handset has not been registered to the base, then the screen displays “PRESS “REG” TO INITIATE REGISTRATION” once the handset has been activated. Press the REG soft key to start the registration. From the Phone Setting Men
Краткое содержание страницы № 17
Programming the Telephone De-Register (Only applicable for base) From the Phone Setting Menu: 1. Press the VOL (+ or -) button to scroll to the Deregistration. 2. Press SELECT soft key. The list of all registered handsets will be dis- played, and use the VOL (+ or -) button to scroll to your selection. 3. Press the SELECT soft key. The screen displays “Remove handset?”. 4. Press YES soft key to confirm de-registration. The screen displays “Saved” and then displays “Press “REG” to initiate regi
Краткое содержание страницы № 18
Programming the Telephone From the Phone Setting Menu: 1. Press the VOL (+ or -) button to scroll to the Update HS List. 2. Press SELECT soft key. 3. The latest handset name list stored in the base will be sent to all regis- tered handsets. Display Setting 1. Make sure your phone is OFF (not in Talk mode). 2. Press the Menu button on HS or the MENU soft key on BS to go to the main menu. 3. Press VOL (+ or -) button to scroll to Display Setting. 4. Press SELECT soft key to confirm and you ma
Краткое содержание страницы № 19
Telephone Operation Ring Tone There are 8 tone levels for your selection. They are Melody 1 to 8 for line 1 and line 2 respectively. From the Sound Setting Menu: 1. Press the VOL (+ or -) button to scroll to the Ring Tone. 2. Press SELECT soft key. 3. Use the VOL (+ or -) button to scroll to your selection and use the DIR or CID button to toggle between L 1 and L 2. The default setting is Melody 1 for both lines. 4. Press SELECT soft key to save your selection and the screen displays “Saved
Краткое содержание страницы № 20
Telephone Operation Making Calls in the Speakerphone mode (from the base) 1. Press the Speaker button (in base), the unit will pick the available line for you. If both lines are available, Line 1 will be used first. -OR- Press Line 1 or Line 2 button on the base to select the line, and the base’s speaker will activate. 2. Wait for a dial tone then dial a phone number. 3. Press the Speaker button when finished. NOTE: After pick the line, the call timer starts to run until all the calls are
