Краткое содержание страницы № 1
HITACHI
CM650ET
!
E
is HITACHI’s On Screen Display function for easy operation.
KEEP THIS USER MANUAL FOR FUTURE REFERENCE.
/v
For future reference, record the serial number of your
.
The serial number is located on the rear of the monitor.
This monitor is
The E S TAR @ emblem does not represent EPA endorsement
As an E S TAR @ Partner, has determined that this
product meets the E
guidelines for energy efficiency. STARS NERGY
Hitachi.Ltd. NERGY
of any product or service.
N
Краткое содержание страницы № 2
NOTE: The manufacturer assumes no The information in this manual is subject to change without notice. responsibility for any errors that may appear in this manual. VGA is a registered trademark of International Business Machines Corporation. VESA is a trademark of a nonprofit Video Electronics Standard Association EMRGY is a trademark of Environmental Protection Agency (EPA). REMARQUE: Les informations dans ce manuel peuvent modifiees Le constructeur n’accepte aucune responsabilitb pour le
Краткое содержание страницы № 3
You have just purchased a approved and product! Your choice has provided you with a product developed for professional use. Your purchase has also contributed to reducing the burden on the environment and also to the further development of environmentally adapted electronics products. Why do we have environmentally computers? In many countries, environmental labelling has become an established method for encouraging adaptation of goods and services to the environment. The main problem, as fa
Краткое содержание страницы № 4
Below you will a brief summary of the environmental requirements met by this product. The complete environmental criteria document may be ordered from: TCO Development SE- 114 94 Stockholm, Sweden Fax: 8 782 92 07 Current information regarding approved and products may also be obtained via the Internet, using the address: Environmental requirements Flame retardants Flame retardants are present in printed circuit boards, cables, wires, casings and housings. Their purpose is to prevent, or at
Краткое содержание страницы № 5
FEATURES I-1 1-2 ’ CAUTIONS l-6 - INSTALLATION STANDARD SETTINGS.. 1 - 7 l-8 .......... AUTOMATIC SIGNAL CHECK.. I - POWER MANAGEMENT SYSTEM.. 1 - PLUG & 1 - 11 . The following features are provided by the Colour Monitor. Sharpest Focus and Highest Contrast Flat screen Enhanced Dot Pitch (EDP) CRT with FS double focus and AR-ASC coating gives the sharpest focus and highest contrast to minimise eye fatigue. Wide-range Multi-Scanning Automatic scanning and automatic adjustment to conform with a w
Краткое содержание страницы № 6
n NEVER REMOVE THE REAR COVER ! __ The rear cover MUST be removed only by authorised service personnel. This colour - monitor contains high voltage components. .: n THE POWER POINT SHOULD BE CLOSE TO THE MONITOR AND n INSTALL THE UNIT IN AN SUITABLE ENVIRONMENT ! DO NOT expose this monitor to rain or moisture to prevent electric shock or fire hazard. This unit is designed to be used in an office or business environment. DO NOT subject the unit to vibrations, dust, or corrosive gases. q KEEP IN A
Краткое содержание страницы № 7
n CAUTION for 200 - 240V operation only This equipment relies on the protective devices in the building installation for short-circuit and over-current protection. Refer to the following table for the suitable number and location of the protective devices which should be provided in the building installation. fl PROTECTIVE DEVICES IN SINGLE - PHASE EQUIPMENT OR SUB -ASSEMBLIES . Minimum number Location of fuses or circuit - breaker poles Both conductors Equipment to be connected to Earth faults
Краткое содержание страницы № 8
H FCC (Federal Communications Commission) STATEMENT WARNING WARNING : This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed - to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not _ installed and used in accordance with the instructions, may cause harmful interference t
Краткое содержание страницы № 9
n FOR THE CUSTOMERS IN THE U.K. THIS PRODUCT IS SUPPLIED WITH A TWO PIN MAINS PLUG FOR USE IN MAINLAND EUROPE. FOR THE U.K. PLEASE REFER TO THE NOTES ON THIS PAGE. - IMPORTANT FOR UNITED KINGDOM E WORDING FOR CLASS I EQUIPMENT INSTRUCTION BOOKS AND LABELS m The mains lead on this equipment is supplied with a moulded plug incorporating a fuse, Should the fuse need to be the value of which is indicated on the pin face of the plug. the same rating. If replaced, an ASTA or BSI approved BS 1362 fuse
Краткое содержание страницы № 10
Install the monitor in the following way, taking care to maintain safety FRONT VIEW REAR VIEW Signal Input Connector AC Inlet - Power Cord Tilt & Swivel Base v / 7J-J - to a receptacle of to the host computer - (for the optional USB HUB Module) the correct voltage Install the monitor on a horizontal base. 2. Power Cord Connection @ Make sure of using the power cord meeting the safety standard of the country in which you are using the monitor. @ Insert the connector of a power cord to the AC Inle
Краткое содержание страницы № 11
Microprocessor-based preset functions can store 26 sets of geometry settings including 1! the standard settings. The following industrial standard settings have been - programmed by the factory. - Video Mode No. Video Mode Name (with Resolution and Vertical Frequency) 1 VGA 640 x 400- 70 Hz 31.47 VGA 37.86 VESA 2 VESA 640 X 400- 85 Hz 3 VESA 800 X 600- 85 Hz 53.67 VESA 4 VESA 1024 x 768- 75 Hz 60.02 VESA 5 VESA 1024 X 768- 85 Hz 68.68 VESA 6 VESA 1152 X 864- 75 Hz 67.50 VESA NOTE : n signal. n
Краткое содержание страницы № 12
Switches Switches POWER Press the Power switch, to switch the power ON or OFF. n n After turning OFF the switch, wait at least 5 seconds before restarting the monitor. Otherwise the monitor may operate incorrectly. H If the picture doesn’t appear, turn OFF the power switch, make sure of the following and wait at least 30 seconds before restarting the monitor. Make sure the power switch of the computer, power cord connection, signal cable connection and the input sync. signal are correct. CONTR
Краткое содержание страницы № 13
Table-l - Function + PINCUSHION PIN BALANCE recalls the factory modes. When the Green reaches When the Blue or Red the upper limit, it makes the reaches the upper limit, it Blue and Red weaker. make the Green weaker. B makes the Red and Green makes the Blue stronger. stronger. When the Red or Green upper limit, it makes the reaches the upper limit, it Red and Green weaker. make the Blue weaker. l-9 When the Blue reaches the preset
Краткое содержание страницы № 14
Table-l (continued) - Function + B makes the operation of makes the operation of horizontal moire circuit horizontal moire circuit makes the operation of makes the operation vertical moire circuit weaker. LANGUAGE changes the changes the a language to the previous language to the next mode. mode. (French) ENGLISH 1 1 ITALIAN0 (Italian) DEUTSCH (German) 1 1 ESPANOL (Spanish) ESPANOL (Spanish) 1 1 DEUTSCH (German) ITALIAN0 (Italian) 1 1 ENGLISH (French) POWER disables (OFF) the Power enables
Краткое содержание страницы № 15
When the monitor has detected the change of the signal input condition, the monitor will II! indicate the condition automatically, as follows. - - the horizontal frequency Precision frequency, Horizontal mode. MANAGEMENT This monitor meets the EDGY STAR@, VESA DPMS (Display Power Management Signalling) standard specifications. The monitor has a built-in power management system that This power management APM State Signal Requirement Monitor Action Power Consumption Power LED 15W H.Sync. OFF Swit
Краткое содержание страницы № 16
= CRT 0.22 mm horizontal dot pitch - - (0.21 mm horizontal mask pitch) I- 100’ deflection, FS double focus, AR-ASC coating. : 0.7 Vp-p, analogue input Signal : Separate level Composite H/V, TTL level Horizontal : 31 - 69 : Horizontal : 1280 dots (max.) Resolution : 1024 lines (max.) 110 MHz (typical) Video Clock frequency 16.0 inches (406‘mm), diagonal (typical) Viewable Image Size Horizontal : 326 mm (typical) Vertical : 245 mm (typical) 9300K : Standard colour balance, 9300K Colour Tempera
