Краткое содержание страницы № 1
Hardware Replacement Guide
Lenovo 3000 J Series
Types 8252, 8253, 8254, 8257, 8258, 8259
Краткое содержание страницы № 2
Краткое содержание страницы № 3
Lenovo 3000 J Series
Краткое содержание страницы № 4
First Edition (December 2005) © Copyright Lenovo 2005. Portions © Copyright International Business Machines Corporation 2005. All rights reserved. U.S. GOVERNMENT USERS – RESTRICTED RIGHTS: Our products and/or services are provided with RESTRICTED RIGHTS. Use, duplication or disclosure by the Government is subject to the GSA ADP Schedule contract with Lenovo Group Limited, if any, or the standard terms of this commercial license, or if the agency is unable to accept this Program under t
Краткое содержание страницы № 5
Contents Overview . . . . . . . . . . . . . .v Chapter 2. Replacing hardware . . . . .7 Safety information for replacing CRUs . . . . . .v Removing the cover . . . . . . . . . . . .7 Safety information for replacing FRUs . . . . . .v Replacing a memory module . . . . . . . . .8 Additional information resources . . . . . . .v Replacing a PCI adapter . . . . . . . . . .9 Tools required . . . . . . . . . . . . .vi Replacing a keyboard . . . . . . . . . . .10 Handling static-sensitive
Краткое содержание страницы № 6
iv Hardware Replacement Guide
Краткое содержание страницы № 7
Overview This guide is intended to be used by customers who are replacing Customer Replaceable Units (CRUs) as well as trained service personnel who are replacing Field Replaceable Units (FRUs). In this document, CRUs and FRUs will be referred to as parts. Note: Trained service personnel should refer to the Hardware Maintenance Manual(HMM) for parts ordering information.″ This guide does not include procedures for all parts. It is expected that cables, switches, and certain mechanical
Краткое содержание страницы № 8
Tools required To replace some parts in your computer, you might need a flat-blade or Phillips screwdriver. Additional tools might be needed for certain parts. Handling static-sensitive devices Static electricity, although harmless to you, can seriously damage computer components and parts. When replacing a part, do not open the static-protective package containing the new part until the defective part has been removed from the computer and you are ready to install the new part. When
Краткое содержание страницы № 9
Chapter 1. Locations This chapter provides illustrations to help locate the various connectors, controls and components of the computer. To open the computer cover, see “Removing the cover” on page 7. Locating the connectors on the front of your computer The following illustration shows the location of connectors on the front of the computer. 1 Headphone connector 3 USB connector 2 Microphone connector 4 USB connector © Lenovo 2005. Portions © IBM Corp. 2005. 1
Краткое содержание страницы № 10
Locating the connectors on the rear of your computer The following illustration shows the location of connectors on the rear of the computer. 1 Power connector 9 Ethernet connector 2 Voltage switch 10 USB connectors 3 Mouse connector 11Microphone connector 4 Keyboard connector 12Audio line out connector 5 Serial connector 13Audio line in connector 6 Parallel connector 14AGP connector 7 VGA monitor connector 15PCI connectors 8 USB connectors 2 H
Краткое содержание страницы № 11
Locating components The following illustration will help you locate the various components in your computer. 1Microprocessor and heat sink 4PCI connectors 2Memory modules 5PCI adapter 3AGP connector 6Power supply Chapter 1. Locations 3
Краткое содержание страницы № 12
Identifying parts on the system board The system board (sometimes called the planar or motherboard) is the main circuit board in your computer. It provides basic computer functions and supports a variety of devices. The following illustration shows the locations of parts on the system board for some models. 1 Microprocessor and heat sink 10SATA connectors (2) 2 Microprocessor fan connector 11Clear CMOS/Recovery jumper 3 Memory connector 1 12Power LED connector 4 M
Краткое содержание страницы № 13
The following illustration shows the locations of parts on the system board for some models. 1 Microprocessor and heat sink 11Front panel connector 2 Microprocessor fan connector 12Power LED connector 3 Memory connector 1 13Clear CMOS/Recovery jumper 4 Memory connector 2 14Front USB connectors (2) 5 Power connector 15Battery 6 Diskette drive connector 16PCI connectors 7 Primary IDE connector 17Front audio connector 8 Secondary IDE connector 18AGP
Краткое содержание страницы № 14
6 Hardware Replacement Guide
Краткое содержание страницы № 15
Chapter 2. Replacing hardware Attention Do not open your computer or attempt any repair before reading the “Important safety information” in the Quick Reference that was included with your computer or in the Hardware Maintenance Manual (HMM) for the computer. To obtain copies of the Quick Reference or HMM, go to http://www.lenovo.com/support. Note: Use only the parts provided by Lenovo. Removing the cover Important Turn off the computer and wait 3 to 5 minutes to let the
Краткое содержание страницы № 16
4. Remove the two screws at the rear of the left side cover and slide the cover to the rear to remove. Replacing a memory module Attention Do not open your computer or attempt any repair before reading the “Important safety information” in the Quick Reference that was included with your computer or in the Hardware Maintenance Manual (HMM) for the computer. To obtain copies of the Quick Reference or HMM, go to http://www.lenovo.com/support. This section provides instructions
Краткое содержание страницы № 17
2. Remove the memory module being replaced by opening the retaining clips as shown. 3. Position the replacement memory module over the memory connector. Make sure that the notch 1on the memory module aligns correctly with the connector key2 on the system board. Push the memory module straight down into the memory connector until the retaining clips close. 4. Go to “Completing the parts replacement” on page 12. Replacing a PCI adapter Attention Do not open your c
Краткое содержание страницы № 18
This section provides instructions on how to replace a PCI adapter. 1. Remove the computer cover. See “Removing the cover” on page 7. 2. Remove screw from adapter. 3. Remove the adapter by pulling it straight out of the adapter connector. 4. Remove the new adapter from its static-protective package. 5. Install the new adapter into the appropriate slot on the system board. 6. Secure adapter with the screw as shown. 7. Go to “Completing the parts replacement” on page 1
Краткое содержание страницы № 19
3. Locate the keyboard connector. Note: Your keyboard might be connected to a standard keyboard connector 1or a USB connector 2. Depending on where your keyboard is connected, see “Locating the connectors on the rear of your computer” on page 2 or “Locating the connectors on the front of your computer” on page 1. 4. Disconnect the failing keyboard cable from the computer. 5. Connect the new keyboard to the appropriate connector on the computer. 6. Go to “Completing t
Краткое содержание страницы № 20
5. Connect the new mouse to the appropriate connector on the computer. 6. Go to “Completing the parts replacement.” Completing the parts replacement After working with parts, you need to replace the computer cover and reconnect any cables, including telephone lines and power cords. Also, depending on the part that was replaced, you might need to confirm the updated information in the Setup Utility program. 1. Ensure that all components have been reassembled correctly and that no to
