Краткое содержание страницы № 1
Dell™ PowerVault™
MD1220 Storage Enclosures
Getting Started
With Your System
Guide de mise en route
Introdução ao uso do sistema
Introducción al sistema
Краткое содержание страницы № 2
Краткое содержание страницы № 3
Dell™ PowerVault™ MD1220 Storage Enclosures Getting Started With Your System Regulatory Model Series E04J
Краткое содержание страницы № 4
Notes, Cautions, and Warnings NOTE: A NOTE indicates important information that helps you make better use of your computer. CAUTION: A CAUTION indicates potential damage to hardware or loss of data if instructions are not followed. WARNING: A WARNING indicates a potential for property damage, personal injury, or death. ____________________ Information in this document is subject to change without notice. © 2009 Dell Inc. All rights reserved. Reproduction of these materials in any manner w
Краткое содержание страницы № 5
Installation and Configuration WARNING: Before performing the following procedure, review the safety instructions that came with the system. Unpacking the System Unpack your system and identify each item. Installing the Rails and System in a Rack CAUTION: If installed in a closed or multi-unit rack assembly, the operating ambient temperature of the rack environment may be greater than room ambient. Therefore, consideration should be given to installing the equipment in an environment compa
Краткое содержание страницы № 6
Connecting the Power Cable(s) Ensure that the power switch is in the OFF position before connecting the power cable(s). Connect the system’s power cable(s) to the system. Securing the Power Cable(s) Bend the system power cable(s) as shown in the illustration and secure the cable(s) firmly to the bracket using the provided strap. Plug the other end of the power cable(s) into a grounded electrical outlet or a separate power source such as an uninterrupted power supply (UPS) or a power distribu
Краткое содержание страницы № 7
Turning On the System Press the power switch to the ON position. The power indicators should light. NOTE: Ensure that the storage enclosure is connected to the server and the mode switch is set to split or unified mode before turning on the system. Installing the Optional Bezel Install the bezel (optional). Getting Started With Your System 5
Краткое содержание страницы № 8
Other Information You May Need WARNING: See the safety and regulatory information that shipped with your system. Warranty information may be included within this document or as a separate document. � The rack documentation included with your rack solution describes how to install your system into a rack. �The Hardware Owner’s Manual provides information about system features and describes how to troubleshoot the system and install or replace system components. This document is available o
Краткое содержание страницы № 9
Technical Specifications Drives SAS hard drives Up to 24 2.5-inch SAS hot-swappable hard drives (3.0 Gbps and 6.0 Gbps) Enclosure Management Modules (EMMs) EMMs One or two hot-swappable modules with temperature sensors and an audio alarm Connectivity Configurations Support for either of the following configurations: � Unified mode for direct connectivity to 24 hard drives per enclosure. – Up to four daisy-chained storage enclosures for a total of 96 hard drives per controller port and 192
Краткое содержание страницы № 10
Redundant Array of Independent Disks (RAID) Controller Host-based RAID support using PowerEdge™ RAID controller H800. Management RAID management using Dell OpenManage™ Server Administrator 6.2 or later. Back-Plane Board Connectors � 24 SAS hard-drive connectors � Two power supply/cooling fan module connectors � Two sets of EMM connectors � One control panel connector for front LEDs and enclosure mode switch Sensors Two temperature sensors Back-Panel Connectors (per EMM) SAS connectors � One
Краткое содержание страницы № 11
LED Indicators (continued) EMM Three two-color LED status indicators, one each for the two EMM SAS ports and one for the EMM status Power supply/cooling fan Three LED status indicators for power supply status, power supply/cooling fan fault status, and AC status Switch System identification button Located on the front control panel. This button is used to locate a system within a rack. Mode switch Located on the front control panel. This switch is used to switch the system between unifi
Краткое содержание страницы № 12
Physical Height 8.68 cm (3.41 inches) Width 44.63 cm (17.57 inches) Depth 54.90 cm (21.61 inches) Weight (maximum configuration) 23.31 kg (51.4 lb) Weight (empty) 8.61 kg (19 lb) Environmental NOTE: For additional information about environmental measurements for specific system configurations, see www.dell.com/environmental_datasheets. Temperature Operating 10° to 35°C (50° to 95°F) with a maximum temperature gradation of 10°C per hour NOTE: For altitudes above 2950 feet, the maximum operatin
Краткое содержание страницы № 13
Environmental (continued) Maximum shock Operating One shock pulse in the positive z axis (one pulse on each side of the system) of 31 G for 2.6 ms in the operational orientation Storage Six consecutively executed shock pulses in the positive and negative x, y, and z axes (one pulse on each side of the system) of 71 G for up to 2 ms Altitude Operating –16 to 3048 m (–50 to 10,000 ft) NOTE: For altitudes above 2950 feet, the maximum operating temperature is derated 1ºF/550 ft. Storage –16 t
Краткое содержание страницы № 14
12 Getting Started With Your System
Краткое содержание страницы № 15
Boîtiers de stockage Dell™ PowerVault™ MD1220 Guide de mise en route Modèle réglementaire Série E04J
Краткое содержание страницы № 16
Remarques, précautions et avertissements REMARQUE : une REMARQUE indique des informations importantes qui peuvent vous aider à mieux utiliser votre ordinateur. PRÉCAUTION : une PRÉCAUTION indique un risque d'endommagement du matériel ou de perte de données en cas de non respect des instructions. AVERTISSEMENT : un AVERTISSEMENT vous avertit d’un risque d'endommagement du matériel, de blessure corporelle ou de mort. ____________________ Les informations que contient ce document sont sujette
Краткое содержание страницы № 17
Installation et configuration AVERTISSEMENT : avant de commencer, lisez les consignes de sécurité fournies avec le système. Déballage du système Sortez le système de son emballage et identifiez chaque élément. Installation des rails et du système dans un rack PRÉCAUTION : si le système est installé dans un rack clos ou multi-unités, la température ambiante du rack lors du fonctionnement du système peut être plus élevée que celle de la pièce. Il importe donc de veiller à installer l'équipeme
Краткое содержание страницы № 18
Branchement du ou des câbles d'alimentation Avant de connecter les câbles d'alimentation, assurez-vous que le commutateur d'alimentation est en position OFF (ÉTEINT). Branchez le ou les câbles d'alimentation sur le système. Fixation du ou des câbles d'alimentation Repliez le(s) câble(s) comme illustré et faites-le(s) passer dans le clip, puis fixez-le(s) à l'aide de la sangle fournie. Branchez ensuite l'autre extrémité du ou des câbles sur une prise de courant mise à la terre ou sur une sour
Краткое содержание страницы № 19
Mise sous tension du système Mettez le commutateur d'alimentation en position ON (ALLUMÉ). Les voyants d'alimentation s'allument. REMARQUE : assurez-vous que le boîtier de stockage est connecté au serveur et que le commutateur de mode est configuré sur le mode divisé ou unifié avant de mettre le système sous tension. Installation du cadre en option Installez le cadre (si nécessaire). Guide de mise en route 17
Краткое содержание страницы № 20
Autres informations utiles AVERTISSEMENT : reportez-vous aux informations sur la sécurité et les réglementations fournies avec votre système. Les informations sur la garantie se trouvent dans ce document ou dans un document distinct. � La documentation fournie avec le rack indique comment installer le système dans un rack. �Le Manuel du propriétaire présente les caractéristiques du système et contient des informations de dépannage et des instructions d'installation ou de remplacement des
