Руководство по эксплуатации Miele CVA 4075 EN-CA

Краткое содержание страницы № 1

Installation Instructions
CVA 4075 en-CA


Installation, repair and maintenance work should be performed by
a Miele authorized service technician in accordance with national
and local safety regulations and the provided installation instructions.

Краткое содержание страницы № 2

Plumbing Connection to the water The machine must be connected to supply the water supply in accordance with ^ Disconnect the machine from the local and national regulations. electrical supply. The water being used should have the drinking water standards of the ^ Remove the water connection cover respective country where the at the lower rear side of the coffee machine is used. machine. ^ Screw the supplied brass – All units and systems used to deliver compression fitting, with the ¾" end, the

Краткое содержание страницы № 3

Electrical connection Important Ensure that power is not supplied to The coffee system comes equipped the machine while installation or witha6ft (1.8 m) power cord with a maintenance work is performed. NEMA 5-15P molded plug for connection to a 120 V, 15 A, 60 Hz All electrical work should be power supply. performed by a qualified electrician in strict accordance with national and local safety regulations. Installation, repairs and other work by unqualified persons could be dangerous. The manufa

Краткое содержание страницы № 4

Installation Installation options The coffee system is designed to be built into cabinetry. A combination with other Miele built in appliances is possible. If the machine is installed in combination with other appliances, it should be installed with a protective base between the appliance and the unit (exception: installation with a built-in plate warmer). A special display cabinet is also available from your dealer or Miele, as an installation option. 59

Краткое содержание страницы № 5

Installation Installation ^ If your cabinet has 3/4" (19 mm) side walls, drill four holes for the Make sure power is not supplied to mounting. the appliance while installation or ^ Center the unit and turn the screws a maintenance work is performed. little bit in and then out again. Disconnect the power supply to the work area by unplugging the unit, ^ Take the unit out of the niche and drill tripping the circuit breaker or four holes at the screw markings removing the fuse. The coffee (1/16" [2

Краткое содержание страницы № 6

Installation Adjusting the door hinges The door hinges can be adjusted if the door cannot be opened easily. ^ To adjust the door sideways, a, turn screw a. ^ To adjust the door to the front or back, b, turn screw b. 61

Краткое содержание страницы № 7

Alteration rights reserved / 2707 M.-Nr. 06 984 320 / 03 with convertible water connection CVA 4075 For the most updated manual see the Miele website.