Краткое содержание страницы № 1
NEW BUCK CORPORATION
MODEL 1110 VENT-FREE GAS HEATER
WARNING: If the information in this manual is not followed exactly, a fire or
explosion may result causing property damage, personal injury or loss of life.
− Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this
or any other appliance.
WHAT TO DO IF YOU SMELL GAS
• Do not try to light any appliance.
• Do not touch any electrical switch; do not use any phone in your building.
• Imm
Краткое содержание страницы № 2
Краткое содержание страницы № 3
TABLE OF CONTENTS Safety Information and Warnings ........................................................................... 3 Product Identification .............................................................................................. 6 Product Features ...................................................................................................... 7 Unpacking ............................................................................................................... 7
Краткое содержание страницы № 4
2
Краткое содержание страницы № 5
SAFETY INFORMATION WARNINGS IMPORTANT: READ THIS OWNER’S MANUAL CAREFULLY AND COMPLETELY BEFORE TRYING TO ASSEMBLE, OPERATE, OR SERVICE THIS APPLIANCE. IMPROPER USE OF THESE LOGS CAN CAUSE SERIOUS INJURY OR DEATH FROM BURNS, FIRE, EXPLOSION, AND CARBON MONOXIDE POISONING. Early signs of carbon monoxide poisoning resemble the flu, with headaches, dizziness, and/or nausea. If you have these signs, the heater may not be working properly. Get fresh air at once! Have burner serviced.
Краткое содержание страницы № 6
5. If this heater is used with propane gas, do not place propane supply tank (s) inside any structure. 6. What To Do IF You Smell Gas: Shut off gas supply. - Do not try to light any appliance. - Do not touch any electrical switch; do not use any phone in your building. - Immediately call your gas supplier from a neighbor’s phone. Follow the gas supplier’s instructions. - If you cannot reach your gas supplier, call the fire department. 7
Краткое содержание страницы № 7
21. All heater screens must be kept clean when operating the gas logs. 22. ”WARNING: Failure to keep the primary air opening(s) of the burner(s) clean may result in sooting and property damage.” 23. Do not use this heater for burning trash or cooking. Never place matches, paper, garbage, or any other material on top of logs or into the flames. 24. Do not install or operate this heater in areas where impurities in the air exist (such as tobacco smoke or heavy
Краткое содержание страницы № 8
PRODUCT IDENTIFICATION Figure 1 WARNING:Installation and repairs should be performed by a qualified service person. The appliance should be inspected before use and at least annually by a professional service person. More frequent cleaning may be required due to excessive lint from carpeting, bedding mate- rial, etc. It is imperative that control compartments, burners and circulating air passageways of the appliance be kept clean. 6
Краткое содержание страницы № 9
PRODUCT FEATURES SAFETY DEVICE This heater has a pilot with an Oxygen Depletion Sensor Shutoff System (ODS). The ODS/ pilot is a required feature for vent-free room heaters. The ODS/pilot shuts off the heater if there is not enough (oxygen) fresh air. PIEZO IGNITION SYSTEM This heater has a piezo igniter. This system requires no matches, batteries, or other sources to light the heater. This appliance is only for use with the type of gas indicated on the rating plate. This applia
Краткое содержание страницы № 10
Front CAUTION THIS HEATER CREATES WARM AIR CURRENTS. THESE CURRENTS MOVE HEAT TO WALL SURFACES NEXT TO HEATER. DO NOT INSTALL HEATER WHERE IMPURITIES IN THE AIR MAY EXIST. MINIMUM CLEARANCES TO COMBUSTIBLE CONSTRUCTION NOTE: FOR GARAGE INSTALLATION • Heater pilot and burner must be at least 18" off the floor. • Locate heater AWAY FROM ANY MOVING VEHICLE. • Keep appliance area clear and free from combustible materials, gasoline and other flammable vapors and liquids. Fo
Краткое содержание страницы № 11
INSTALLATION NOTE: This heater may be installed three different ways: 1. Wall Mounted 2. Freestanding heater (with optional pedestal) 3. Freestanding (with optional wooden mantel) NOTE: Do not set unit flat on any surface without Pedestal or Wooden Mantel. WALL MOUNT INSTALLATION: 1. After determining the location for the heater, unfold the template provided and place the bottom of the template a minimum of 7" from bottom of unit to floor. NOTE: Be sure to level t
Краткое содержание страницы № 12
3. Lift heater by each bottom corner and place the round part of the tear drop punch out over each screw head. Gently push down until the body of the screw is at the end of the slot. NOTE: Make sure unit is level. 4. Now you are ready to hook up the gas line. The Model 1110 allows for a rear or bottom connection for the gas line. See “Gas Connection” on page 17 for details. CLEANING INFORMATION: Cleaning is a vital part of the life of your stove. In order to properly clean the
Краткое содержание страницы № 13
FREESTANDING WITH OPTIONAL PEDESTAL INSTALLATION 1. Place heater on backside and center the pedestal on the bottom. Mark the 4 pre-punched holes in the pedestal angle. Use the 4 self-tapping screws provided with the pedestal to drill the 4 marked spots. Secure the pedestal to the bottom of the unit. NOTE: If the gas line is run through the floor, you may want to drill a hole in the bottom of the pedestal. 2. The pedestal must be secured to the floor. One option is to drill holes i
Краткое содержание страницы № 14
MOUNTING BRACKET VIEW FREE-STANDING OPTIONAL DELUXE FINISHED MANTEL NOTE: “MODEL 1110 TO BE REV. DATE B USED WITH NEW BUCK OPTIONAL “L” DATE CORP. MANTEL ONLY, PART BRACKETS (2) AND SCREWS (2) PRO- # PAKDM1127.” IF USED WITH VIDED WITH MAN- ANY OTHER MANTEL THE TEL, TO SECURE WARRANTY WILL BE VOID. MANTEL TO WALL IF NEEDED. WOOD SCREWS REAR OF MANTEL SHEET METAL SCREWS Z BRACKETS REAR OF STOVE Z-BRACKET(S) PLACEMENT ON STOVE Z-BRACKETS MOUNTED (SCREWED) TO THE REAR OF
Краткое содержание страницы № 15
PRODUCING ADEQUATE VENTILATION This section is for residential or manufactured (mobile) installation “This heater shall not be installed in a confined space or unusually tight construction unless pro- visions are adequate combustion and ventilation air.” The National Fuel Gas Code, ANSI Z223.1/NFPA 54 defines a confined space as a space 3 whose volume is less than 50 cubic feet per 1,000 BTU per hour (4.8m per kw) of the aggregate input rating of all appliances installed in that spac
Краткое содержание страницы № 16
1. Determine the volume of the space (length x width x height). Length x Width x Height =_________cu.ft.(volume of space) EXAMPLE: 20 ft.(Length) x 16 ft.(Width) x 8 ft.(ceiling Height)= 2560 cu. ft. (volume of space) If additional ventilation to adjoining room is supplied with grills or openings, add the volume of these rooms to the total volume of the space. 2. Divide the space volume by 50 cubic feet to determine the m
Краткое содержание страницы № 17
VENTILATION AIR VENTILATION AIR FROM INSIDE BUILDING This fresh air would come from an adjoining unconfined space. When venting to an adjoining space, you must provide two permanent openings: one within 12" of the ceiling and one within 12" of the floor on the wall connecting the two spaces (see Options 1 and 2, Figure 8). You can also remove door into adjoining room (see Option 3, in Figure 8). WARNING REWORK WORKSHEET, ADDING THE SPACE OF THE ADJOINING UNCONFINED SPACE. THE C
Краткое содержание страницы № 18
WARNING THIS APPLIANCE MUST HAVE FRESH AIR FOR PROPER OPERATION. IF NOT, POOR FUEL COMBUSTION COULD RESULT. READ THE FOLLOWING INSTRUCTIONS TO ENSURE PROPER FRESH AIR FOR THIS AND OTHER FUEL- BURNING APPLIANCES IN YOUR HOME. VENTILATION AIR FROM OUTDOORS Provide extra fresh air by using ventilation grills or ducts. You must provide two permanent openings: one within 12" of the ceiling and one within 12" of the floor. Connect these items directly to the outdoors. These spaces incl
Краткое содержание страницы № 19
WARNING: ANY CHANGE TO THIS HEATER OR ITS CONTROLS CAN BE DANGEROUS. GAS CONNECTION Check gas type. Use only the type of gas indicated on the valve rating plate. If the type of gas listed on the plate is not your type of gas supply, DO NOT INSTALL. Contact your dealer for proper model. Always use an external regulator for all LP heaters to reduce the supply tank pressure to a maximum of 13" W.C. This is in addition to the regulator furnished with the heater. WARNING: CONNECTIO
Краткое содержание страницы № 20
CONNECTING TO A GAS SUPPLY CAUTION: NEVER CONNECT HEATER DIRECTLY TO THE PROPANE SUPPLY. THIS HEATER REQUIRES AN EXTERNAL REGULATOR (NOT SUPPLIED). INSTALL THE EXTERNAL REGULATOR BETWEEN THE HEATER AND THE PROPANE SUPPLY. The installer must supply the external regulator for liquid propane gas. The external regulator will reduce incoming gas pressure. You must reduce incoming gas pressure to between 11" and 14" of water. If incoming gas pressure is not reduced, heater regulator da
