Краткое содержание страницы № 1
Professional
Landscaping Tools
BB40
BACK PACK
BLOWER
IMPORTANT: READ SAFETY RULES AND
INSTRUCTIONS CAREFULLY
DO NOT THROW AWAY
Краткое содержание страницы № 2
Table of Contents Content Page Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 Safety . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 Know Your Unit . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7 Assembly . . . . . . . . . . . . . . . . . . . .
Краткое содержание страницы № 3
Section 1 Safety The purpose of safety symbols is to attract your attention to possible dangers. The safety symbols, and their explanations, deserve your careful attention and understanding. The safety warnings do not by themselves eliminate any danger. The instructions or warnings they give are not substitutes for proper accident prevention measures. SYMBOL MEANING SAFETY ALERT SYMBOL: Indicates Failure to obey a safety warning will result in danger, warning or caution. Attention is serious in
Краткое содержание страницы № 4
Safety (continued) • Do not operate the engine faster than the speed • Add fuel in a clean, well-ventilated outdoor area needed to do the job. Do not run the engine at high where there are no sparks or flames. Slowly remove speed when not in use. the fuel cap only after stopping engine. Do not smoke while fueling or mixing fuel. Wipe up any • Always stop the engine when operation is delayed or spilled fuel from the unit immediately. when walking from one location to another. • Move the unit at
Краткое содержание страницы № 5
Safety (continued) The Unit’s Protective Safety Equipment PROTECTIVE SAFETY EQUIPMENT Stop Switch- Use the stop Personal Equipment switch to stop the engine. To Ear Protection- Wear ear pro- service and test the stop tection that offers a sufficient switch, start the engine and dampening effect. Remove your make sure that the engine halts hearing protection as soon as when you move the stop switch you stop the engine, in order to to the off position. hear any noises or warning sig- nals. Vibrat
Краткое содержание страницы № 6
Safety (continued) Safety and International Symbols This operator's manual describes safety and international symbols and pictographs that may appear on this product. Read the operator's manual for complete safety, assembly, operating and maintenance and repair information. SYMBOL MEANING SYMBOL MEANING • KEEP BYSTANDERS AWAY • SAFETY ALERT SYMBOL WARNING: Keep all bystanders, Indicates danger, warning, or especially children and pets, at caution. May be used in conjunction with other symbols
Краткое содержание страницы № 7
Section 2 Know Your Unit 12 1 11 2 10 3 9 4 8 7 5 6 Blower Components 1 - Spark plug 2 - Choke 3 - Starter handle 4 - Muffler 5 - Fuel tank 6 - Fuel cap 7 - Stop switch 8 - Throttle lever / control 9 - Blow tube 10 - Nozzle 11 - Air filter 12 - Shoulder Harness 7
Краткое содержание страницы № 8
Section 3 Assembly Instructions F A C B E D Assembling the Blower Carton Contents F - Engine Assembly Unpacking Your unit was carefully packed at the factory to 1 - Hose Clamp with Screw (2) prevent damage during shipment. Unpack the carton 2 - Flexible Tube carefully: 3 - Base Tube 1. Remove all contents from the carton. 4 - Middle Tube 2. Identify parts and check them with the list of parts in the above Carton Contents section. 5 - Bent Tube / Nozzle 3. Examine parts for damage. 4. Immediate
Краткое содержание страницы № 9
Section 4 Oil and Fuel NOTE: This unit is equipped with a 2-stroke Mixture/Fueling engine that must always run on a mixture • Always mix fuel and oil in a of gas and oil. It is important to measure clean container that is the quantity accurately, to ensure the intended for fuel. correct mixing ratio. Small discrepancies in the amount of oil have a great bearing on • Always begin by filling the the fuel mix proportions when mixing a container with half the small amount of fuel. amount of fuel req
Краткое содержание страницы № 10
Section 5 Operation Starting Instructions Stop Switch 1. Mix gas with oil. Fill fuel tank with fuel/oil mixture. See Oil and Fuel Mixing Instructions. 2. Put the Stop Switch in the START position. 3. Place the choke lever up into the CHOKE/CLOSE position. 4. Fully press and release the primer bulb (air purge diaphragm) 10 times, slowly, until fuel is visible in the primer bulb. If you can’t see fuel in the bulb, press and release the bulb as many times as it takes before you can see fuel in it.
Краткое содержание страницы № 11
Operation (continued) Holding the Blower/Vacuum •Operate power equipment only at reasonable hours— not early in the morning or late at night Before operating the unit, stand in the operating when people might be disturbed. Comply with times position. Check for the following: listed in local ordinances. Usual recommendations • Operator is wearing proper clothing, such as boots, are 9:00 am to 5:00 pm, Monday through Saturday. safety glasses or goggles, ear/hearing protection, • To reduce noise l
Краткое содержание страницы № 12
Section 6 Maintenance To avoid serious personal injury, always turn Always wear protective gloves during your blower off and allow it to cool before you maintenance operations. Do not carry out clean or service it. maintenance when the engine is hot. Weekly Maintenance Daily Maintenance 1. Check the starter, the starter rope/cord, and the 1. Clean the unit’s exterior. return spring. 2. Check that the throttle control functions safely. 2. Make sure that the vibration damping elements are not dam
Краткое содержание страницы № 13
Maintenance (continued) Muffler NOTE: Some mufflers are fitted with a catalytic Only start and use the unit when it is completely converter. Refer to the Specifications to constructed. If you use the unit without all its determine whether your unit is fitted with a covers fitted, you risk serious personal injury. catalytic converter. The muffler is designed to dampen the noise level of the engine, and to direct Carburetor exhaust fumes away from The unit’s engine is broken in the user. Exhaust
Краткое содержание страницы № 14
Maintenance (continued) Cooling System Air Filter To maintain as low of an The air filter should be operating temperature as cleaned regularly to remove possible, the engine is dust and dirt. This will help equipped with a cooling avoid: system. The cooling sys- • Carburetor malfunction tem consists of: • Problems with starting 1. An air intake on the starter unit. • Unnecessary wear to engine parts. 2. Cooling fins on the flywheel. • Abnormal fuel consumption 3. Cooling fins on the cylinder. C
Краткое содержание страницы № 15
Section 11 Specifications ENGINE* Engine Type ........................................................................................................................... Air-Cooled, 2-Cycle 3 Cylinder Capacity ..................................................................................................................................... 40.2 cm Cylinder Bore.......................................................................................................................................
Краткое содержание страницы № 16
MANUFACTURER’S LIMITED WARRANTY FOR: The limited warranty set forth below is given by Cub No implied warranty, including any implied Cadet Commercial LLC with respect to new warranty of merchantability or fitness for a merchandise purchased and used in the United particular purpose, applies after the applicable States, its possessions and territories. period of express written warranty above as to the parts as identified. No other express warranty Cub Cadet Commercial LLC warrants this product o
