Руководство по эксплуатации Casio DQR-200

Краткое содержание страницы № 1

UP (+)
UP (+)
°C/ °F
°C/ °F
MA0308-EA
Operation Guide DQR-200
Sub-unit
1
Main unit
AB C
4 378 2
°C/ °F RESET
5
TEMP. DOWN
WAVE CLEAR
MAX/MIN
(—)
SNZ
SNZ
ON
ON
OFF OFF RESET
ALM °C/ °F RESET
ALM
TEMP.
WAVE DOWN
CLEAR
MAX/MIN
(—)
RESET
960
• A sticker is affixed to the glass of this clock when you purchase it. Be sure to remove the sticker before using the
clock.
• Depending on the clock model, the configuration of your clock may differ somewhat from that shown in the
illustration.
Alarm Off Alarm

Краткое содержание страницы № 2

Operation Guide DQR-200 GENERAL GUIDE Main unit 1SNOOZE/LIGHT button • Press this button to illuminate the display for about four seconds. • Pressing this button while the alarm is sounding stops the alarm. 2Alarm Time Set buttons Use these buttons to change the alarm time or current time setting. 3SET button Inside, among Inside a vehicle Near refrigerators Near a Near high-tension Among or behind Use this button when setting the current time. buildings, or near or other household construction

Краткое содержание страницы № 3

UP (+) UP (+) °C/ °F °C/ °F Operation Guide DQR-200 USING THE ALARM The alarm sounds and the light turns on when the alarm time you set is reached. You can also use the Alarm Setting the Time and Date Manually Mode selector (5) to select the snooze alarm feature. • When using the clock in an area that is outside of the range of the transmitter in Mainflingen or in an area where signal reception is impossible for some reason, you need to manually adjust the time as required. Setting the Alarm Tim

Краткое содержание страницы № 4

Operation Guide DQR-200 BATTERY REPLACEMENT High Temperature and Low Temperature Memory Low Battery Warning • The following data is stored in memory automatically. A indicator appears on the display to let you know when battery power is low. Replace the batteries as soon Main unit high temperature and low temperature Sub-unit high temperature and low temperature as possible. Note that the indicator appears on both the main unit and sub-unit when sub-unit battery power goes low. To replace main

Краткое содержание страницы № 5

Operation Guide DQR-200 USING THE SUB-UNIT Data Transfer from the Sub-unit • Data is transferred from the sub-unit to the main unit every three minutes. • The sub-unit is able to send data to the main unit up to an unobstructed distance of about 30 meters. • The data receive status is indicated on the display of the main unit by the icons shown below. Receive successful Receive unsuccessful • If a receive operation is not successful for some reason, the display of the main unit shows dashes (–)