Краткое содержание страницы № 1
OWNER`S MANUAL
OIL BURNING STOVE
EVEREST
Vérified and tested following
CAN/CSA B140.3 et UL 896 standards by:
Intertek Testing Services
Manufactured by:
1700 Léon-Harmel
Québec, (Québec)
G1N 4R9
www.drolet.ca
tel : (418 ) 527-3060
Fax : (418 ) 527-4311
READ THESE INSTRUCTIONS AND SAVE FOR REFERENCE
990615/45088A_feb 03
Краткое содержание страницы № 2
TABLE OF CONTENT TECHNICAL DATA......................................................................................................................................... 1 INSTALLATION INSTRUCTIONS .................................................................................................................. 2 LOCATING THE STOVE ......................................................................................................................... 2 CHIMNEY INFORMATIONS.................
Краткое содержание страницы № 3
INSTALLATION INSTRUCTIONS LOCATING THE STOVE • Install the stove as close to the chimney as possible. • Many configurations are possible, the most frequent are illustrated in figures 1, 2 and 3. • Respect clearances indicated on page 1. They have been tested according to approvals. • Always respect clearances of stove pipes manufacturers. Larger clearances always prevail. Figure 1 : CORNER INSTALLATION Figure 2 : PARALLEL INSTALLATION Table 1 : CLEARANCES
Краткое содержание страницы № 4
CHIMNEY INFORMATIONS • Before the hook up of the stove, check if the chimney is in good condition and that the quality of the flue pipe will allow a sufficient draught. For a good combustion, refer to the technical data of the stove to know the minimum draught required. • Factory built ‘’A’’ type chimney or ‘’L’’ type chimney are approved for this unit. The chimney has to be well insulated. A chimney too cold can affect the gas temperature and lower draught effects. Low gas t
Краткое содержание страницы № 5
CONNECTING THE STOVE TO THE CHIMNEY • The gases are vented from the back of the unit. The female part of the black pipe connector has to be installed toward the flue connector of the stove. Secure all connections with the (3) self taping o screws, with 120 distance between each of them. • The connection between stove pipes and chimney has to be perfectly sealed. • A maximum horizontal length of 8' is allowed. Make sure to have a 1/4" slope per foot minimum. o • Do not use more
Краткое содержание страницы № 6
LEVELING THE UNIT • Now that the stove is in place and properly hooked up to the chimney, you have to adjust the level on the burner. • Put the level in the middle of the burner parallel to the door. (Figure 9A). Screw or unscrew the adjustable legs to level the burner with a 7/16" key (10 mm). • Put the level in the middle of the burner parallel to the sides. (Figure 9B). Screw or unscrew the adjustable legs to level the burner with a 7/16" key. Figure 9A: LEVELL
Краткое содержание страницы № 7
CONNECTING STOVE TO OIL TANK • Make sure that the tank outlet is 12" (305 mm) higher than the inlet of the carburetor. (Gravity fed) • Use only copper piping to connect tank to stove. • Make sure that there is a small slope on the connection from the tank toward the stove. • A 3" (75 mm) down slope is needed on the tank itself, from the outlet towards the other end of the tank. • When the tank is installed outdoors, it is preferable to use oil #1, to avoid viscosity problems. NO
Краткое содержание страницы № 8
ADJUSTING THE DRAUGHT • Your stove operated with natural draught, created by the ascension of combustion gases in the chimney. This movement creates a siphon effect in the stove and forces ambient air to go in the burner by the holes in its surround. These orifices let air in for combustion. • For the unit to function properly, it is essential to check the quality of the draught using a draught gauge. The draught is usually measured in inches of water column. • Check the minimum
Краткое содержание страницы № 9
OPERATION INSTRUCTIONS COMBUSTIBLE • Your stove has been designed to work with oil #1 or #2. DO NOT USE GASOLINE, CRANKCASE OIL OR ANY OIL CONTAINING GASOLINE. The manufacturer declines all responsibility regarding damage cause by using other combustibles. • Make sure to use oil without impurities which may plug filters and valve’s orifice. Impurities only give an improper combustion. LIGHTING BEFORE LIGHTING • make sure that : The tank is full; The isolating valve
Краткое содержание страницы № 10
LIGHTING (CONT’D) • Place the flow regulating handle on the "1" position, as soon as the oil enters the burner return to "0" position. • Open the door and pore into the burner 2 to 3 once (75 ml) of lighting gel or wood alcohol. NOTE : USE OF LIGHTING GEL IS BETTER FOR A SAFE IGNITION. • With a long wood match, ignite carefully and close the door. • After a couple of minutes (before alcohol goes out) the burner and the chimney are hot, place the flow regulator handle on "1"
Краткое содержание страницы № 11
TURNING THE STOVE OFF • Set the flow regulating handle to position ‘’0’’. • If you plan to keep the stove off for a long while, it is recommended to disarm the valve’s lever and close the tap on the pipe between the stove and your oil tank. ALWAYS KEEP THE VALVE SHUT OFF WHEN THE BURNER IS NOT OPERATING MAINTENANCE ONCE A WEEK : • Clean the oil inlet tube of the burner with the cleaning tee : Push in the rod of the cleaning tee while turning it; Move back and forth ope
Краткое содержание страницы № 12
TROUBLESHOOTING GUIDE PROBLEMS CAUSES SOLUTION Position 6 was reached too 1. Set flow regulating handle ON POSITION 6 (MAXIMUM) THE FLAME IS LONG AND quickly. to position 1; SMOKY, THERE IS SUIT 2. wait for combustion to BUILD UPON THE GLASS. stabilize; 3. Progressively increase flow to desired position. NOTE : SEE LIGHTING PROCEDURES. Maximum flow is too high. 1. Set flow to a lower position; 2. Call a qualified technician to adjust the valve. ON POSITION 1 (M
Краткое содержание страницы № 13
TROUBLESHOOTING GUIDE (CONT’D) PROBLEMS CAUSES SOLUTION THE FLAME PRODUCES Door gasket is not selling 1. Tighten door by turning SMOKE, IN ANY POSITION. properly. counter-clockwise the door handle; 2. Check if gasket needs to be changed. The burner orifices are plugged 1. Clean the burner with a up. metallic brush. Draught is too low. 1. Make it checked by a technician. FLAME GOES OUT BY Oil level in the tank is too low. 1. Fill up the tank. ITSELF. Air pocket i
Краткое содержание страницы № 14
SPARE PARTS After years of use, if you need to replace some parts, please contact your SUPPLIER or one of our Drolet approved DEALERS. • Give him product data as displayed in your warranty voucher or on your appliance’s name plate at the rear. Keep the warranty voucher even after its EXPIRY date. • Our dealers are in possession of all spare parts nomenclatures and technical data about our products, and will provide you with the spare parts you need and any maintenance interventi
Краткое содержание страницы № 15
SPARE PARTS (CONT’D) Figure 16: EVEREST EXPLODED VIEW, SPARE PARTS LIST Page 14 of 15
Краткое содержание страницы № 16
W A R R A N T Y The warranty of the manufacturer applies to the original buyer only. This warranty may not be transferred to a second person and becomes effective on the date of purchase. Proof of purchase is necessary to validate the warranty and to establish the warranty coverage period. The warranty is conditional to normal residential use of the product. Any use other than that for which the product was intended will invalidate the warranty. The warranty covers repairs and
