Краткое содержание страницы № 1
care and operation
instructions
DIRECT VENT
WarninGs
SSDV-3328 SERIES
• Hot! do not touch! t he glass and
surfaces of this appliance will be hot
direct -Vent Gas Firep Lace Heaters
during operation and will retain heat
p/n 725,045M reV. n/c 09/2007
for a while after shutting off the appli-
ance. severe burns may result.
MODELS
• carefully supervise children in the
same room as appliance.
Millivolt Models Electronic Models
• if small children are present in the home, it is
ssdVt
Краткое содержание страницы № 2
Provide adequate clearances around air open- conGratuLations! ings and adequate accessibility clearance for service and proper operation. Never obstruct In selecting this SUPERIOR Direct-Vent Gas Appliance you have chosen the finest and the front openings of the appliance. most dependable fireplace to be found anywhere. A beautiful, prestigious, alternative to a wood burning fireplace. Welcome to a Family of tens of thousands of satisfied t hese appliances are designed to operate on SUPE
Краткое содержание страницы № 3
At the time of installation, it must be determined On millivolt systems, the piezo igniter, HI/LO Manifold Gas supply pressure if the appliance needs to be derated. Contact flame adjustment knob, and pilot and main (millivolt models) gas OFF/ON control knob are located below your local gas supplier for deration requirements Fuel # Low High the glass panel enclosure. The gas valve for for your area. electronic systems is also located below the natural (Lo) 2.2" Wc (Hi) 3.5" Wc glass enclosu
Краткое содержание страницы № 4
I O O L I P T O IGNITER it TPTH TP TH OFF ON CONTROL L I I P H F F L F F O If your millivolt appliance is equipped with an If your electronic appliance is equipped with an 2. During the first initial burns of these appli- optional remote switch kit (wall switch, remote optional remote wall switch or remote control kit ances, there will be some odor emitted (see control or wall thermostat) and the pilot is lit, Burn-In Period on Page 3 ). the appliance main burner may be turned on and the
Краткое содержание страницы № 5
clean Logs and Burner Maintenance iMportant Carefully remove the logs (use care when han- (see Maintenance schedule, Page 20) dling the fiber logs, as they become quite fragile Refer to the maintenance schedule for maintenance it is imperative that the control after curing). Vacuum out any foreign matter tasks, procedures, periodicity and by whom they compartment, burners and (lint, carbon, etc). on the burner. Ensure the should be performed. Always verify proper opera- circulating air
Краткое содержание страницы № 6
Do not attempt to repaint the appliance until the removing Glass enclosure panels finish is completely cured (see Burn-In Period (see Figure 6) WarninG on Page 3). If the surface later becomes stained or marred, it may be lightly sanded and touched t he glass door of this appli- . Remove the top louver assembly by lifting up with spray paint. it up and pulling it out. ance must only be replaced as a complete unit as provided by Front Glass enclosure panel, removal 2. Remove the contr
Краткое содержание страницы № 7
instaLL LoGs, VoLcanic stone and WarninG GLoWinG eMBers WarninG Logs get very hot and will remain this appliance is not designed Carefully position the ceramic fiber logs and hot up to one hour after gas twigs over the burner according to the following to burn wood. any attempt to steps, while referring to Figure 7. supply is turned off. Handle do so could cause irreparable only when logs are cool. t urn damage to appliance and prove . Set the rear log on the raised
Краткое содержание страницы № 8
notes: 8 NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE.
Краткое содержание страницы № 9
Burner adJustMents (QuaLiFied tecHnicians onLY) Flame appearance and sooting Proper flame appearance is a flame which is blue at the base and becomes yellowish-orange in the body of the flame. When the appliance is first lit, the entire flame may be blue and will gradually turn yellowish-orange during the first 15 minutes of operation. If after a short period the flame stays lowered blue, or if the flame is orange with evidence of sooting (black tip), the air shutter opening may need
Краткое содержание страницы № 10
electronic appliance checkout sit MiLLiVoLt piLot asse MBLY Burner air shutter adjustment proper pilot Flame appearance To light the burner, refer to the lighting instruc- adjustment setscrew igniter r od Hood tions on Pages 18 & 19. Ensure the igniter adjustment r od up lights the pilot. The pilot flame should engulf (Fully open position) the flame sensor as shown in Figure 13. Burner tube t hermocouple 3/8" Min. (9 mm) eLectronic piLot asse MBLY proper pilot Flame appearance air shutter r e
Краткое содержание страницы № 11
TH TH TP TP WirinG diaGraMs electronic Wiring diagram (Honeywell) showing Blower Wiring for optional FBK- 00, FBK-200 & FBK-250 Kits schematic r epresentation only Wiring diagrams are provided here for refer- ence purposes only. This information is also Wall Mounted Blower Speed Control Switch or Auxiliary View A ON/OFF Switch for Blower Kit (optional) provided on schematics attached directly to the J-Box Wiring when appliance on a pullout panel located within the Relay Module C/W FBK-250
Краткое содержание страницы № 12
notes: 2 NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE.
Краткое содержание страницы № 13
accessorY coMponents product reference information Cat. Model Ship. Ship.Vol. No. Wt.(lbs) (inches) H6898 SSDVT-3328CNM 115 lbs 37W x 17D x 36H (13.1 cu.ft). H6899 SSDVT-3328CNE 115 lbs 37W x 17D x 36H (13.1 cu.ft). H6896 SSDVR-3328CNM 115 lbs 37W x 17D x 36H (13.1 cu.ft). H6897 SSDVR-3328CNE 115 lbs 37W x 17D x 36H remote control Kit, standard remote control Kit, deluxe (13.1 cu.ft). cat. no. Model no. description cat. no. Model no. description H0249 rcL remote control system H025 rcL-st
Краткое содержание страницы № 14
accessor Y coMponents interior Brick Liner Kits rear Vent t op Vent Models Where used cat. # Model cat. # Model 99L54 BLK-4r 99L53 BLK-4t ssdV-3328 interior Brick Liner Kits The brickade liner kits include tan stamped sheetmetal panels for the rear and side walls of the firebox. The panels have brick-like features in relief. These kits can be retrofitted into previously installed appliances. decorative arch screen panel Kits eyebrow Hood Kits cat. no. Model no. Models Where used Models poli
Краткое содержание страницы № 15
P A accessor Y coMponents Arch Door Kit - Polished Brass cat. no. Model Fireplace Model 99L56 adK-4B ssdV-3328 Arch Door Kit - Brushed Stainless Steel cat. no. Model Fireplace Model 99L57 adK-4Bs ssdV-3328 3 piece t rim Kit cat. no. Model no. description H0453 tK33pB3 33” polished Brass, 3328 arch door Kits H83 tK33Bs3 33” Brushed stainless, 3328 The arch door kits are easy to install and do not require hardware to attach them to the standard door frame. H4820 tK33c3 33” charcoal, 3328 The de
Краткое содержание страницы № 16
I O O L I P T O it TPTH TP TH L I P I F F L H F F O LiGHtinG instructions – HoneYWeLL and sit MiLLiVoL t Gas V aLVe For Your saFetY read BeFore LiGHtinG WarninG: iF You do not FoLLoW tHese instructions eXactLY, a Fire or eXpLo - sion Ma Y resuL t causinG propertY daMaGe, personaL inJur Y or Loss oF LiFe. a. This appliance has a pilot which must be lighted with a piezo • do not use any phone in your building. igniter. When lighting the pilot, follow these instructions • immediately call your ga
Краткое содержание страницы № 17
I O O L I P T O it TPTH TP TH L I P I F F L H F F O INSTRUCTIONS D’ALLUMAGE – VANNE GAZ MILLIVOLT HONEYWELL ET SIT POUR VOTRE SÉCURITÉ, LISEZ CES INSTRUCTIONS AVANT L’ALLUMAGE aVertisseMent : si Vous ne suiVeZ pas ces instructions À La Lettre, iL pourrait s’en suiVre un incendie ou AVERTISSEMENT : SI VOUS NE SUIVEZ PAS CES INSTRUCTIONS À LA LETTRE, IL POURRAIT S’EN SUIVRE UN INCENDIE OU UNE une eXpLosion causant des doMMaGes MatÉrieLs, des BLessures corporeLLes ou MÊMe des pertes de Vie. EXPLO
Краткое содержание страницы № 18
IGNITER OFF ON CONTROL LiGHtinG instructions — eLectronic For Your saFetY read BeFore LiGHtinG WarninG: iF You do not FoLLoW tHese instructions eXactLY, a Fire or eXpLo - sion Ma Y resuL t causinG propertY daMaGe, personaL inJur Y or Loss oF LiFe. a. When lighting the appliance, follow these instructions • Immediately call your gas supplier from a neighbor’s exactly. phone. • If your gas supplier cannot be reached, call the fire B. BEFORE OPERATING smell all around the appliance area departme
Краткое содержание страницы № 19
IGNITER OFF ON CONTROL INSTRUCTIONS D’ALLUMAGE — ELECTRONIC POUR VOTRE SÉCURITÉ, LISEZ CES INSTRUCTIONS AVANT L’ALLUMAGE aVertisseMent : si Vous ne suiVeZ pas ces instructions À La Lettre, iL pourrait s’en suiVre un incendie ou AVERTISSEMENT: SI VOUS NE SUIVEZ PAS CES INSTRUCTIONS À LA LETTRE, IL POURRAIT S’EN SUIVRE UN INCENDIE OU une eXpLosion causant des doMMaGes MatÉrieLs, des BLessures corporeLLes ou MÊMe des pertes de Vie. UNE EXPLOSION CAUSANT DES DOMMAGES MATÉRIELS, DES BLESSURES CORPO
Краткое содержание страницы № 20
Maintenance scHeduLe annually (Before the onset of the Burning Season) Maintenance tasK accoMpLisHinG person procedure Inspecting/Cleaning Burner, Logs Qualified Service Technician Inspect valve and ensure it is properly operating. Check piping and Controls for leaks. Vacuum the control compartment, fireplace logs and burner area. Check Flame Patterns and Flame Qualified Service Technician Refer to Figure 9 on Page 9 and verify the flame pattern and Height height displayed by the appliance
