Краткое содержание страницы № 1
Owner’s Manual
Installation and Operation
Model:
6000TV-OAK
6000TV-OAK-IPI
Underwriters
Laboratories Listed
READ THIS MANUAL BEFORE INSTALLING OR
OPERATING THIS APPLIANCE. THIS INSTALLERS
WARNING: IMPROPER INSTALLA-
GUIDE MUST BE LEFT WITH APPLIANCE FOR
TION, ADJUSTMENT, ALTERATION,
FUTURE REFERENCE.
SERVICE OR MAINTENANCE CAN
CAUSE INJURY OR PROPERTY DAM-
AGE. REFER TO THIS MANUAL. FOR
WARNING: IF THE INFORMATION
ASSISTANCE OR ADDITIONAL INFOR-
IN THESE INSTRUCTIONS IS NOT
MATION CONSULT A QUAL
Краткое содержание страницы № 2
SAFETY AND WARNING INFORMATION These units MUST use one of the vent systems READ and UNDERSTAND all instructions carefully ! ! described in the Installing the Fireplace section of before starting the installation. FAILURE TO the Installers Guide. NO OTHER vent systems or FOLLOW these installation instructions may result components MAY BE USED. in a possible fire hazard and will void the warranty. This gas fireplace and vent assembly MUST be Prior to the first firing of the fireplace, READ the !
Краткое содержание страницы № 3
TABLE OF CONTENTS Safety and Warning Information. ............................................... 2 Service Parts Lists. .................................................................... 4 Section 1: Approvals and Codes. .............................................. 8 Appliance Certification................................................................... 8 Installation Codes.......................................................................... 8 High Altitude Installations ..........
Краткое содержание страницы № 4
Service Parts 6000TV-OAK, 6000TV-OAK-IPI (NG, LP) Exploded Parts Diagram Beginning Manufacturing Date: 4-01 Ending Manufacturing Date: ______ 2 3 4 5 12 1 13 6 Log Set Assembly 9 7 11 8 10 Part number list on following page. 4 Heat & Glo • 6000TV-OAK, 6000TV-OAK-IPI • 384-900 Rev. N • 11/05
Краткое содержание страницы № 5
Service Parts List 6000TV-OAK, 6000TV-OAK-IPI IMPORTANT: THIS IS DATED INFORMATION. The most current information is located on your dealers VIP site. When order- ing, supply serial and model numbers to ensure correct service parts. ITEM COMMON PARTS SERIAL # PART NUMBER 1Burner NG, LP SRV383-338A 2 Glass Door Assembly GLA-6TROC PRE 002324021 385-130 3 Surround POST 002324021 2026-108 4Hood SRV60-143-BK 5 Log Grate 383-360A 6 Oak Log Set Assembly LOGS-6OAK 7 Log 1 SRV385-720 8 Log 2 SRV385-7
Краткое содержание страницы № 6
Service Parts 6000TV-OAK-IPI (NG, LP) Exploded Parts Diagram Beginning Manufacturing Date: 4-01 Ending Manufacturing Date: ______ 11 Intermittent Pilot Ignition Valve Assembly 9 8 7 1 3 4 6 10 2 5 ITEM DESCRIPTION SERIAL # PART NO. 1 Flex Ball Valve Assembly 302-320A 2 ON/OFF Rocker Switch 060-521A 3Valve NG 750-500 3 Valve LP 750-501 PRE 002324021 477-301A 4 Flexible Gas Connector POST 002324021 383-302A 5 Module 593-592 6Wire Assembly 593-590A Burner Orifice NG (#40C) 582-840 7 Burner Or
Краткое содержание страницы № 7
6000TV-OAK Service Parts (NG, LP) Exploded Parts Diagram Beginning Manufacturing Date: 4-01 Ending Manufacturing Date: ______ 5 Standing Pilot Ignition 6 Valve Assembly 7 9 8 3 10 2 1 4 ITEM DESCRIPTION SERIAL # PART NUMBER 1 ON/OFF Rocker Switch 060-521A 2 Valve NG (30 Sec) 060-522 2 Valve LP (30 Sec) 060-523 PRE 002324021 477-301A 3 Flexible Gas Connector POST 002324021 383-302A 4Wire Assembly 049-552A 5Pilot Assembly NG 485-510A 5 Pilot Assembly LP 485-511A 6 Pilot Bracket 385-164 7 B
Краткое содержание страницы № 8
Approvals and Codes 1 Appliance Certification (current edition). The Uniform Mechanical Code - (current edition), and local Building Officials for the options allowed The Heat & Glo fireplace models discussed in this Installers in obtaining an effective bedroom volume of unconfined Guide have been tested to certification standards and listed space. by the applicable laboratories. These models (natural gas and propane) can be installed in a bedroom (in Canada) if a thermostat (Model WH-STAT) is C
Краткое содержание страницы № 9
Getting Started 2 Introducing the Heat & Glo Gas Fireplaces The Heat & Glo Warranty will be voided by, and Heat & Glo disclaims any responsibility for, the following actions: Heat & Glo B-type vent gas fireplaces are designed to op- • Installation of any damaged fireplace or vent system erate with all exhaust gases expelled to the outside of the component. building. • Modification of the fireplace or direct vent system. The information contained in this Installers Guide, unless • Installation ot
Краткое содержание страницы № 10
28-1/2 (724mm) 21-1/2 (548mm) 9-3/8 (238mm) 6” B-VENT (152mm) ELECTRICAL ACCESS GAS LINE ACCESS 38 (965mm) 34-5/8 (879mm) 3-1/2 (90mm) 2-1/8 (55mm) 36-1/8 (916mm) 6-7/8 41 6-1/2 (174mm) (1043mm) (165mm) VENT COLLARS STANDOFFS HOOD RATING PLATES & LABELS OUTSIDE AIR GAS CONTROLS GAS ACCESS ELECTRICAL ACCESS Figure 1. Diagram of the 6000TV-OAK 10 Heat & Glo • 6000TV-OAK, 6000TV-OAK-IPI • 384-900 Rev. N • 11/05
Краткое содержание страницы № 11
Installing the Fireplace 3 Constructing the Chase A chase is a vertical box-like structure built to enclose the gas fireplace and/or its vent system. Vertical vents that run on the outside of a building may be, but are not required to be, installed inside a chase. CAUTION: TREATMENT OF FIRESTOP SPACERS AND CONSTRUCTION OF THE CHASE MAY VARY WITH THE TYPE OF BUILDING. THESE INSTRUCTIONS ARE NOT SUBSTITUTES FOR THE REQUIREMENTS OF LOCAL BUILDING CODES. THEREFORE, YOUR LOCAL BUILD- ING CODES MUST B
Краткое содержание страницы № 12
Step 2. Framing the Fireplace It is recommended that all natural venting non-air tight gas fireplaces have outside air connected to them. It is also Fireplace framing can be built before or after the fireplace is recommended that the building be mechanically or passively set in place. Framing should be positioned to accommo- balanced to allow atmospherically vented appliances, such date wall coverings and fireplace facing material. The dia- as top vented gas fireplaces with draft hoods, to draf
Краткое содержание страницы № 13
Step 4. Installing the Vent System LISTED TERMINATION CAP A. Vent System Approvals Model 6000TV-Oak is approved to use 6-inch (152mm) diameter B-type vent. B-type vent must be used when the vent system is within combustible construction. LISTED SINGLE-WALL These models may also use single wall rigid or flexible gas GAS VENT vent IF and ONLY IF the vent system is installed within non-combustible construction such as a masonry chimney. The same diameter noted above for B-type vent must be used
Краткое содержание страницы № 14
C. Bedroom Installation in Canada Step 5. Positioning, Leveling, and Securing the Fireplace This model MUST NOT be vented into a vent system in- stalled exterior to a building. The part of the vent system To properly position, level, and secure the fireplace: above the roof line can be exterior to the building. • Place the fireplace into position (see Figure 7). D. Vent Termination • Level the fireplace from side to side and from front to back. WARNING: MAJOR U.S. BUILDING CO
Краткое содержание страницы № 15
• When attaching the pipe, support the control so that the STANDING PILOT lines are not bent or torn. • After the gas line installation is complete, all connections 3/8” (10mm) must be tightened and checked for leaks with a commer- cially available, non-corrosive leak check solution. Be sure to rinse off all leak check solution following testing. WARNING: DO NOT USE AN OPEN FLAME ! TO CHECK FOR GAS LEAKS. • Insert insulation from the outside of the fireplace and pack the insulation tightly to to
Краткое содержание страницы № 16
Figure 10. Standing Pilot Ignition Wiring Diagram Step 9. Wiring the Fireplace NOTE: Electrical wiring must be installed by a licensed Wall Switch electrician. Position the wall switch in the desired position on the wall. An assembly of 18 ft of 20 AWG is provided with the fireplace to CAUTION: DISCONNECT REMOTE CONTROLS IF AB- connect the wall switch to the appliance. Instead of the sup- SENT FOR EXTENDED TIME PERIODS TO PREVENT plied assembly, wire with a length of 25 ft or less and a gauge A
Краткое содержание страницы № 17
NEUTRAL 5 4 3 2 1 5 4 3 2 1 HOT simply connect red and black wire leads to activate battery For Intermittent Pilot Ignition (IPI) Wiring power (connect red to red, black to black). The fireplace can be used as necessary. Once power (110 VAC) is re- 3 Volt Transformer stored, disconnect red and black wire leads to extend bat- This appliance comes with a 3 volt transformer. The trans- tery life. former plugs into the junction box and the two leads p
Краткое содержание страницы № 18
Note: There are 3 metal tabs holding the non-combustible Step 10. Finishing board in place for shipping. These tabs are to be cut off or Figure 13 shows the minimum vertical and corresponding bent back before finishing around the fireplace front. maximum horizontal dimensions of fireplace mantels or other combustible projections above the top front edge of the Step 11. Installing Trim, Logs fireplace. See Figures 2 and 3 for other fireplace clearances. and Ember Material O
Краткое содержание страницы № 19
Step 12. Before Lighting the Fireplace Before lighting the fireplace, be sure to do the following: Remove all paperwork from underneath the fireplace. Review safety warnings and cautions • Read the Safety and Warning Information section at the beginning of this Installers Guide. Double-check for gas leaks • Before lighting the fireplace, double-check the unit for possible gas leaks. Double-check vent terminations and front grilles for Figure 15. Glass Assembly obstructions. • Before lighting
Краткое содержание страницы № 20
Maintaining and Servicing Your Fireplace 4 Fireplace Maintenance Although the frequency of your fireplace servicing and main- tenance will depend on use and the type of installation, you should have a qualified service technician perform an appli- ance check-up at the beginning of each heating season. See the table below for specific guidelines regarding each fireplace maintenance task. IMPORTANT: TURN OFF THE GAS BEFORE SERVICING YOUR FIREPLACE. Replacing old ember material Frequency: Once annu
