Руководство по эксплуатации Vermont Castings FK28/2960

Краткое содержание страницы № 1

PDV20/SDVR Installation Procedure
– for Pinnacle Direct Vent
1. Attach the Snapstat to the Bracket using two #10 x
1/2” phillips screws as shown in Figure 1.
2. Locate and remove the 1/4-20 x 3/8” hex head bolt
installed in the hole in the right rear ledge of the fire-
Circulating Fan Kit
box. (A, Fig. 1) Use that bolt to secure the Snapstat
Bracket to the firebox. The mounting hole is slotted to
Installation Instructions
let you adjust the bracket so that the snapstat head
makes contact

Краткое содержание страницы № 2

UVS27 Installation Procedure 4. The Rheostat Control switch attaches to the Control – for Stardance and Pinnacle Vent-Free Panel plate provided in the parts bag with the stove. • Insert the switch box shaft through the hole in the 1. Attach the Fan assembly to the rear shroud in the back of the right side of the Panel, aligning the loca- same manner as detailed in the preceding section for tor pin with the smaller hole in the panel. (Fig. 4) the PDV20/SDVR, following Step 3, Figures

Краткое содержание страницы № 3

Jefferson Installation Procedure 1. Attach the snapstat assembly to the snapstat bracket with two sheet metal screws. (Fig. 8) Remove the Upper Flange 1/4-20 x 3/8” hex head bolt installed in the hole in the right rear ledge of the firebox. Use that bolt to secure the snapstat bracket to the firebox. The mounting hole is slotted to allow you to adjust the bracket so that the snapstat bracket head makes contact with To the firebox. (Fig. 9) Control Valve 2. Attach the fan to the rear shrou

Краткое содержание страницы № 4

JUV Installation Procedure Pinch - for Jefferson Unvented Grommet to Remove 1. Attach the fan to the rear shroud by engaging the upper flange of the fan skirt under the lower edge of the shroud and secure the skirt with the four screws and one star washer provided. (Figs. 12,13) Snapstat Bracket Snapstat Module Upper Flange ST468 Fig. 14 Remove snapstat and grommet from bracket. ST468 Snapstat remove snapstat grommet 9/28/00 djt ST240 Fig. 12 Place upper flange behind lower edge of sh

Краткое содержание страницы № 5

Seville Installation Procedure Install the Snapstat 1. Disconnect the leads from the Snapstat terminals. 2. Use pliers to remove the retainer ring from the Snapstat Cover and slip the cover off the wire har- ness. 3. Reconnect the wire leads to the Snapstat Plate. 4. Using two sheet metal screws from the fan kit, attach the Snapstat Plate to the Inner Shroud as indicated in Figure 17. Snapstat Plate ST462 Fig. 18 Install fan body into rear shroud. Leads Snapstat ST462 Cover seville Switch

Краткое содержание страницы № 6

MOTOR BLK SNAPSTAT WHT BLK ON/OFF RHEOSTAT FK 28 Fan Wiring Diagram ST236 FK26 wiring diagram 12/99 MHSC 149 Cleveland Drive • Paris, Kentucky 40361 www.mhsc.com WHT WHT GRN BLK