Руководство по эксплуатации Liebert Power Strips

Краткое содержание страницы № 1

LIEBERT MP™ ADVANCED POWER STRIPS
QUICK-START GUIDE: OPENCOMMS EM OR MP ADVANCED ACCESS SERVER
SAVE THESE IMPORTANT SAFETY INSTRUCTIONS
This manual contains important safety instructions. Read all safety, installation and operating
instructions before installing the Liebert MP Advanced Power Strip or Access Server. Adhere to all
warnings on the unit and in this manual. Follow all operating and user instructions. Individuals
without previous training can install and operate this equipment.
Th

Краткое содержание страницы № 2

When connecting the rack equipment to the Liebert MP Advanced Power Strip’s receptacles, arrange cables and connections to avoid tangling and crisscrossing the power cables. For power management purposes, record the receptacle where each piece of equipment is connected. Receptacles on the Liebert MP Advanced Power Strip have a numerical designation. Liebert MP Advanced Power Strips with more than one circuit are named with numbers and letters. When connecting power to the Liebert MP Advanced

Краткое содержание страницы № 3

ASSIGN AN IP ADDRESS NOTE These steps must be done on the same network segment where the OpenComms EM is connected. If your network uses static IP addresses and your computer has a Windows operating system, follow the steps below. Otherwise, consult the OpenComms EM user manual (SL-28210). 1. Obtain an IP address for the OpenComms EM from your network administrator. 2. Insert the OpenComms EM CD in your computer’s CD drive. 3. Click on the Start button, then on Run, then Browse to the file IPSE

Краткое содержание страницы № 4

DS74 CX1 CX2 1 2 3 4 CX3 CX4 EIA-232 I/0 MODULE DS62 NETWORK INTERFACE ETHERNET EIA-232 CONFIGURATION WITH LIEBERT MP ADVANCED ACCESS SERVER Liebert MP Advanced Mounting Power Strip Bracket on (MP-C5120) either side EIA-232 EIA-232 Port 1 3 5 8 POWER 2 4 6 8 EIA-232 Port - Connect to Power Strip EIA-232 Port MP-DS74 Card With Configurable Ethernet Port Liebert MP Advanced Communication Ports Access Server (MP-S5138) 100-240VAC On/Off Switch ?????????? 0.21-0.12AMPS ROUTE LINE (not on all m

Краткое содержание страницы № 5

SET THE IP ADDRESS 1. Select “1” to set the IP Address for Module 1. Enter an IP address (below). The address must be unique on your system (obtain this from your network administrator). 2. Press Enter to return to the Network Port Configuration menu. Enter IP address 3. Choose “2” to set the Subnet Mask for your system (obtain this from your network administrator). SET THE GATEWAY ADDRESS 1. Return to the Network Port Configuration menu and choose “3” to set the Gateway Address (the IP addres

Краткое содержание страницы № 6

Liebert Corporation 1050 Dearborn Drive Telephone: 1-800-877-9222 P.O. Box 29186 Facsimile: 1-614-841-6022 Columbus, OH 43229 www.liebert.com © 2006 Liebert Corporation ® Liebert and the Liebert logo are registered trademarks of All rights reserved throughout the world. Specifications subject Liebert Corporation. All names referred to are trademarks or to change without notice. registered trademarks of their respective owners. SL-20812 (01/06) Rev. 2 6