Краткое содержание страницы № 1
MCO080103 (801)
OWNER/OPERATOR MANUAL
BACKPACK SPRAYER
BM46I
WARNING WARNING
This sprayer is not designed to be used with acids of any
Before using our products, please read this
manual carefully to understand the proper kind, corrosive products like caustic soda, gasoline,
use of your unit. materials capable of generating heat, hot fluids, explosive
or highly volatile products.
USE OF THESE AND OTHERS EXPOSE USERS TO
SERIOUS INJURY AND EVEN DEATH.
Краткое содержание страницы № 2
SAFETY FIRST Instructions contained in warnings within this manual and warning seals marked with a symbol on the sprayer concern critical points which must be taken into consideration to prevent possible serious bodily injury, and for this reason you are requested to read all such instructions carefully and follow them without fail. Note that there may be times when warning seals peel off or become soiled and impossible to read. If this happens, you should contact the dealer from which you purch
Краткое содержание страницы № 3
1. Parts location 4. For safe operation
Краткое содержание страницы № 4
4. For safe operation 5. Wear sturdy rubber-soled shoes or shoes • Pay attention to the direction of the wind, do not work with some other form of anti-slip protection to against the wind. help protect you against falling when filling, • Never use the sprayer during windy conditions. using and/or cleaning the sprayer. • Never point a sprayer nozzle toward an open flame to 6. Do not wear loose clothing, scarves, neck avoid the possibility of igniting the unit, causing injury to chains, hair longe
Краткое содержание страницы № 5
4. For safe operation • Make sure the spray hose loops freely without kinking or ■ TRANSPORTATION squeezing. • Clean and rinse tank and spraying assembly after each use to prevent crystallizing, which would later cause clogging 4. After using sprayers and other equipment, CLEAN UP! and chemical damage to the unit. Dispose of debris in trash receptacles. • Drain the content from the tank before transporting or storing the sprayer. ■ MAINTENANCE • Secure the unit carefully to prevent movement when
Краткое содержание страницы № 6
5. Set up NOTE Hose clamps are not completely tight. Please tighten hose clamps prior to using. Hose clamps are left loose to extend life of gaskets and fittings. WARNING Oil cap gasket before using and lubricate weekly so the gasket will seal properly and prevent chemical leaks. Oil check valve and maintain breather hole clear of debris. Your failure to oil may can cause the tank to collapse and crack due to vacuum created by pump lubricate with "3 and 1" oil. ■ HOW TO ASSEMBLE Included in the
Краткое содержание страницы № 7
5. Set up 6. Pre-operation locking pin. (See figure 3). The round tube comes through the NOTE base of the unit and extends out 6.4mm (1/4”), exposing the hole drilled through the tube. Place on the other washer and Hose clamps are not completely tight. the other holding pin. The pump handle assembly is now Please tighten hose clamps prior to using. complete. Hose clamps are left loose to extend life of gaskets and fittings. HIP SUPPORT Take the black plastic hip portion and side the two end WARN
Краткое содержание страницы № 8
7. Operation 8. Maintenance • Always release pressure in the pump prior to filling, WARNING cleaning, or servicing the sprayer. • Before opening a container of pesticide or other spray Before you remove cap, be sure there is no pressure in material, carefully read, understand, and follow all the tank. in order to release pressure, invert unit upside instructions on the label. down and squeeze spray pistol (aim away from you). • Do not use flammable materials in the sprayer: they can Pressure wil
Краткое содержание страницы № 9
9. Storage 11. Parts list WARNING BACKPACK SPRAYER Never store chemicals in your sprayer for any length of time 1. Before you remove cap, be sure there is no pressure in the tank. in order to release pressure, invert unit upside down BM46I and squeeze spray pistol (aim away from you). Pressure will escape; when hissing stops, all pressure has been released. Remove pump assembly by turning counter- clockwise. The pump handle has two locking positions, one turning clockwise and one counter-clockwi
Краткое содержание страницы № 10
11. Parts List : BM46I 10
Краткое содержание страницы № 11
11. Parts List : BM46I Key# Part KIT Number Description Q'ty 1 RMKIT0571 Red cap with handle and check valve. 1 2 RMKIT02A • Seal. 1 3 RMKIT02CH • Check valve for cap. 1 4 RMKIT01AS Strainer with venting hole. 1 5 RMKIT15 Shoulder strap assembly. 2 6 RMKIT31 • Belt hook &buckle. 2 7 RMKIT283 • • Belt hook 2 8 RMKIT36 • Shoulder pads. (2 Pads) 1 9 RMKIT17 Hose & 2 Hose Clamps 1 10 RMKIT18 Complete spray pistol. 1 11 RMKIT19 • Spindle set. 1 12 RMKIT20 • Spindle O-ring set. 1 13 RMKIT21 • Plug set
Краткое содержание страницы № 12
LIMITED WARRANTY FOR TWO (2) YEARS OF HOME USE, ONE (1) YEAR FOR COMMERCIAL USE AND NINETY (90) DAYS FOR RENTAL USE FROM THE DATE OF ORIGINAL PURCHASE,THE COMPANY, THROUGH ANY RedMax DEALER, WILL REPAIR OR REPLACE, FREE OF CHARGE, FOR THE ORIGINAL PURCHASER, ANY PART OF PARTS FOUND TO BE DEFECTIVE IN MATERIAL AND/OR WORKMANSHIP. THIS IS THE EXCLUSIVE REMEDY. THE PURCHASER SHALL BEAR COSTS OF TRANSPORTING THE UNIT TO AND FROM THE RedMax DEALER. THE PURCHASER SHALL NOT BE CHARGED FOR DIAGNOSTIC LA
