Краткое содержание страницы № 4
1 Safety Precautions General Precautions Use this appliance for its intended purpose only. Follow these IMPO IMPOR RT TANT ANT general precautions with those listed throughout this guide: • PLEASE READ all instructions before installing, operating, or servicing the appliance. DANGER RISK OF CHILD ENTRAPMENT. Before you throw away your • Proper installation procedures must be followed when old refrigerator or freezer, take off the doors and leave shelves completing an installation or relocat
Краткое содержание страницы № 5
Wine Captain® Model Features: 2 2000 Series Product Features Capacity.15” Wine Captain® Model, up to 24 .75L Bottles. 24" Wine Captain® Model up to 48 .75L Bottles. Stable temperatures. Stable, consistent temperatures provide longer-term storage capability. All 2000 Series Models Feature: Built-in. Provides custom look. No additional clearance needed around sides, top or rear of unit for ventilation. Do not obstruct Touch Digital Controls. Provides ability to set and see the front grille. t
Краткое содержание страницы № 6
3 Product Operation Adjusting Air Temperature Air Flow IMPO IMPOR RT TANT ANT Adjust the set point temperature in single increments, IMPO IMPOR RT TANT ANT and wait 24 hours for the temperature to stabilize before The unit requires proper air flow to perform at its highest rechecking. efficiency. Do not block the front grille or internal fans at any time, or the unit will not perform as expected. Do not install the unit behind a door. 12 3 4 5 To adjust the set point temperature: 1. Press a
Краткое содержание страницы № 7
Interior Lighting Checking Product Temperature Normal Operation. Opening the door will cause the interior of the cabinet to illuminate. Use LIGHT (5) on the control panel to change the lighting functions. 12 3 4 5 Timed Lighting. For Wine Captain® Models and Glass Door Refrigerators the interior of the cabinet is illuminated for a timed four-hour period. 1. Press and release LIGHT (5) (the °F symbol will flash briefly) to switch from door-operated lighting control to the timed four hour li
Краткое содержание страницы № 8
Electronic Control Quick Guide Task Touch Touch Display Comment Turn ON/OFF Hold 10 seconds Release when °F flashes. or °F flashes after first touch, or or Adjust set-point saved after 5 Temperature seconds of inactivity and °F Touch and release Touch to change temperature stops flashing. View Actual WC models will scroll top/ Hold 5 seconds Release when °F flashes. Temp mid/bottom temps. Change F/C Hold or Blackout will end in 36 Display (and cabinet light) will not Blackout Mode
Краткое содержание страницы № 9
4Food Storage IMPO IMPOR RT TANT ANT Drawers When opening or closing the crisper, pull or push slowly The drawers should only be removed for servicing by a trained and and carefully. If the crisper is pulled out too far or pushed certified repair personal. in too hard, it could come out all the way and possibly Top Storage Bin cause product damage or personal injury. Other Models Crisper Your models may have a lower crisper drawer for storage. To open, grasp the crisper handle and slowly p
Краткое содержание страницы № 10
5 U-Line Wine Guide Matching Food and Wine Although there are no hard fast rules for matching wine to food, Looking Behind the Label observe some guidelines. Delicate dishes should be accompanied To most, wine is a delicious mystery. We purchase it, uncork it, and by lighter more delicate wines. Full-flavored foods should be savor its taste and beauty. But there is so much more to true wine matched with fuller-bodied wines. appreciation. Many secrets are simply too good to keep bottled up.
Краткое содержание страницы № 11
The Cork: A Mystery on Its Own. Ideal Wine Storage Considerations Cork Presentation. The ritual of the presentation of the cork Temperature: The most important element about storage has a rich and fascinating history dating back to the late 1800's. A temperature is stability. If wine is kept in a stable environment phylloxera (root louse) devastation to the vineyards severely between 40°F and 65°F, it will remain sound. A small 1-2 degree limited the supply of great wines. Restaurateurs w
Краткое содержание страницы № 12
Wine Stocking Recommendation Wine Rack Removal and Installation Specially designed horizontal wine racks properly positioned the To remove a rack from the cabinet: bottles so the wine remains in contact with the cork and assure 1. Remove any bottles stored on the rack. the cork does not become dry. 2. Grasp the end of the rack, and gently slide it out until it stops. Stock the unit as follows: 1. Stock the wine racks beginning with the lowest rack, at the back, and working forward. Stagger th
Краткое содержание страницы № 13
Wood Trim Finishing Staining and final finish application: WARNING IMPO IMPOR RT TANT ANT You MUST remove the wood trim from the unit for DO NOT use oil-based stains on wood trim. Vapors from staining or finishing to prevent permanent damage to the inner liner of the unit. Allow stain or finish to dry oil-based stains will permanently penetrate the liner and will not dissipate over time. thoroughly (at least 24 hours for each coat) following the product manufacturer’s instructions before 1
Краткое содержание страницы № 14
6 Maintenance Light bulb Replacement Removing and Installing Grille To replace the light bulb in your U-Line unit: WARNING 1. Find the light located at the top of the unit. Grasp the edges of Disconnect electric power to the unit before removing the light housing lens (1) opposite the exposed tab and gently the grille. push the lens toward the tab (2). 2. Pull the edge of the lens down (1) and swing it out of the light WARNING housing. DO NOT touch the condenser fins(4). The condenser fins
Краткое содержание страницы № 15
For models equipped with glass shelves having shelf supports, remove the shelves as follows: 1. Open door completely. Removing and Installing Interior Shelves 2. Grasp the shelf edge in the center and slide the shelf from the unit. Insert the shelves as follows: Reposition the shelf as required, ensure the raised edge strip is 3 toward the rear of the unit and graphics, if applied, are on the underside of the shelves. 1 2 Removing and Installing Door Shelves 1 For models equipped with glass
Краткое содержание страницы № 16
7 Doors Door Alignment and Adjustment Align and adjust the door if it is not level, or is not sealing properly. If the door is not sealed the unit may not cool properly, or excessive frost may form in the interior. IMPO IMPOR RT TANT ANT • Properly aligned, the door’s gasket should be firmly in contact with the cabinet all the way around the door (no gaps). Carefully examine the door’s gasket to ensure 4 that it is firmly in contact with the cabinet. Also make door is parallel with top of
Краткое содержание страницы № 17
Remove Door Reversing Black or White Doors 3 1 2 1. Hold door to keep it from falling. 2. Remove hinge screw pin (1) from top hinge using a Phillips screwdriver. 3. Remove door by tilting forward and lifting door off bottom hinge closer inserts. 4. Reinstall hinge screw pin (1) into top hinge using a Phillips screwdriver. • The Hinge hardware will be removed and reinstalled on the opposite side of the cabinet. Remove hole plugs. • The top hinge hardware will be reinstalled on the bottom of
Краткое содержание страницы № 18
Remove preexisting bottom hinge. Reversing Stainless Steel Glass Doors Remove the preexisting bottom hinge (three screws) (2). Remove Door Reinstall hinge to top opposite. 3 Install the hinge just removed from the bottom to the TOP 1 opposite side of the cabinet (three screws) (2). Reinstall Hole Plugs. 4. Install plastic screw plugs (three each, top and bottom) (3) into holes where hinge hardware was removed. 2 1. Hold door to keep it from falling. 1 2. Remove hinge screw pin (1) from top hin
Краткое содержание страницы № 19
3. Grasp outer edge of stainless frame and firmly press inside edge 3. Swing door into frame. of glass in while pulling stainless frame in opposite direction. 4. Install screws removed in “Remove Stainless Frame” step 1 to top of door, opposite handle. 5. Install pivot plat to bottom of door, opposite of handle, using hardware removed in “Remove Stainless Frame”step 2. Arrange Pull Frame pivot plate so the flat edge is against the edge of the door. Away Door Edge Pivot Plate Flat Edge Push Gl
Краткое содержание страницы № 20
Remove existing bottom hinge. Remove the existing bottom hinge (three screws) (2). Reinstall hinge to top opposite. Install the hinge just removed from the bottom to the TOP opposite side of the cabinet (three screws) (2). Reinstall Hole Plugs. Install plastic screw plugs (three each, top and bottom) (3) into holes where hinge hardware was removed. Install Door. 1. Hold door upright and tilted forward. 2. Lift door on to bottom hinge closer inserts. 3. Tilt door forward into position. 4. Hold
Краткое содержание страницы № 1
USE AND CARE GUIDE
®
2000 SERIES
WINE CAPTAIN® MODELS
GLASS DOOR REFRIGERATORS
REFRIGERATORS
BEVERAGE CENTER
WINE CAPTAIN® MODELS REFRIGERATOR
U-2175BEVCOL-00 U-2175BEVCOL-60
U-2115WCOL-00 U-2175WCCS-00
U-2115RB-00 U-2175RCS-00
U-2175BEVCOL-02 U-2175BEVCS-00
U-2115WCS-00 U-2175WCCS-02
U-2115RS-00 U-2175RCS-01
U-2175BEVCS-02
U-2175WCCOL-00 U-2175WCCS-13
U-2115RS-01 U-2175RCS-22
U-2175WCCOL-02 U-2175WCCS-22
U-2115RS-02 U-2175RCW-00
U-2175WCCOL-60
U-2115RSOD-00 U-2175RFB-00
U-2115RSOD-01 U-2175RFS-
Краткое содержание страницы № 2
Introduction Please Record Your Model Information You will need your product model and serial number when you request additional information or services. You can find this information on the serial plate located on the upper right or back Congratulations on your purchase of a U-Line refrigerator. wall in the interior of your product. This information also appears on the warranty registration card. Please complete and mail your For nearly five decades and three generations, U-Line continues
Краткое содержание страницы № 3
Table of Contents 1 - Safety Precautions .....................................................................................................................................................1 Safety Alert Definitions ........................................................................................................................................1 General Precautions .............................................................................................................................
