Руководство по эксплуатации Audiovox APS-350-A

Краткое содержание страницы № 1

Model APS-350-A
Installation Manual
SELECTABLE FEATURES
Note : When both Passive Arming and Voltage Sensing are selected, you must hardwire the driver’s door pin switch in order
to begin the passive arming sequence.
RF Programmable Features :
Feature Selection 1 Chirp 2 Chirps Default
First 1 Second Door Locks 3.5 Second Door Locks 1 Second
Second Auto Lock On Auto Lock Off Auto Lock Off
Third Auto Unlock On Auto Unlock Off Auto Unlock Off
Fourth Passive Door Locks Active Door Locks Active Locks

Краткое содержание страницы № 2

INSTALLATION OF MAJOR COMPONENTS Control Module : Select a mounting location inside the passenger compartment ( up behind the dash ), and secure using the two screws provided. The control module can also be secured in place using cable ties. Do not mount the control module in the engine compartment, as it is not waterproof. You should also avoid mounting the unit directly onto factory installed electronic components. These components may cause RF interference, which can result in poor transmitte

Краткое содержание страницы № 3

WIRING THE SYSTEM Large 11 Pin Edge Connector : Red Fused Wire : + 12 VDC CONSTANT BATTERY SOURCE This wire controls the sensitivity of the voltage sensing circuit, which detects the turning on of an interior light when a door is opened. It will also detect the switching on of parking or headlamps, and in many cases will trigger the alarm when a thermostatically controlled electronic radiator cooling fan switches on. When installing this system into vehicles with electronic “ after fans “, it is

Краткое содержание страницы № 4

2 Dark Green w/ White Trace Wires : ENTRY ILLUMINATION The dark green w/ white trace wires provide the entry lighting, and flash the vehicle’s dome light while the alarm is sounding. These are NO ( normally open ) and COM ( common ) contacts of an on board, 10 Amp maximum relay. Connect one of the dark green w/ white trace wires to the wire in the vehicle that turns on the interior courtesy light. Connect the other dark green w/ white trace wire to either chassis ground if the vehicle switches g

Краткое содержание страницы № 5

Dark Green w/ Black Trace Wire : LATCHING OUTPUT / CHANNEL 3 The green w/ black trace wire latches to ground via an independent RF channel from the keychain transmit- ter. This is a transistorized, low current ( 300 mA ) output, and should only be used to drive an external relay coil. This wire provides an immediate ground signal, and stays at ground for as long as the button(s) on the keychain transmitter remain pressed. WARNING ! Connecting the dark green w/ black trace wire to the high curren

Краткое содержание страницы № 6

Cut the existing unlock wire, and connect the white wire to the slave switch or motor side of the cut wire. Connect the blue wire to the master switch side of the cut wire. The orange and blue w/ white stripe wires must be connected to a fused + 12 VDC battery source. Refer to the door lock wiring supplement for proper connection of these wires into the various locking circuits available in current vehicles. 6 Pin Door Lock Output Connector : 2 STEP UNLOCK OPERATION When wiring for 2 step unlock

Краткое содержание страницы № 7

Audiovox Corp., 150 Marcus Blvd., Hauppauge, N.Y. 11788 128-5082A