Руководство по эксплуатации Ford 839

Краткое содержание страницы № 1

WARNING
This body lift kit should only be installed on
vehicles that are in good working condition.
Before the installation begins, the vehicle
should be thoroughly inspected for evidence of
corrosion or deformation of the sheet metal
around the factory body mounts. This body lift
kit should not be installed on any vehicle that
is suspected to have been in a collision, or
misused. Off road use of your vehicle with this
body lift installed may increase the stress
applied to the fact

Краткое содержание страницы № 2

off the studs protruding from the floorboard and carefully remove it from the vehicle. WARNING Carefully pull the carpeting back to expose the Make sure that your vehicle is properly back four cab-mounting bolts (Two on each blocked and secured before you begin side. One is under the seat back and the other installation of this lift kit. is just behind the front seat in the floorboard). These can be loosened at this time. 2. Park the vehicle on a clean, dry, flat, level surface

Краткое содержание страницы № 3

container. Remove the upper and lower 18. Remove the cab mounting bolts from the radiator hoses from the radiator. Remove the passenger side of the cab. Check for any upper radiator mounting bolts. Remove the wires, hoses, cables, etc. that may be too radiator from the vehicle. Remove the fan short and that may have not been covered in shroud from the vehicle. the instructions. Using a hydraulic jack and wooden block, slowly lift the cab just high 12. Pull down the air flap between the bu

Краткое содержание страницы № 4

upper fan shroud lowering brackets to the bed bolts) apply Loctite ®, reinstall bolt and radiator where the fan shroud was originally tighten to vehicle manufacturer torque specifications. mounted. Do not tighten. Mount the fan shroud to the studs protruding from the fan shroud 24. Connect the steering shaft to the steering brackets. Install a 1/4" washer and nylock nut on each stud. Do not tighten. Check the fan to extension. It will only go on one way. Be sure that the steering sha

Краткое содержание страницы № 5

relocating brackets to the frame using four 7/16" x 1 1/2" bolts, 7/16" washers and 7/16" nylock nuts. Tighten all rear bumper mounting CAUTION hardware securely. Reconnect the license Performance Accessories does not plate lights to the rear bumper recommend any particular wheel and tire combinations for use with its body lifts and can 32. Place the warning sticker on the vehicle not assume responsibility for the customers dash in plain sight of all vehicle occupants. choice of

Краткое содержание страницы № 6

1999 Ford Super Duty Kit # 893 SE 3000 Steering extension Parts List KIT 16 3x3 blocks 4 3x2 overload blocks 2 Front bumper brackets 2 Rear bumper brackets 1 4wd shifter extension bracket 1 1 1/2" x 5" fuel-filler extension 1 3/4" x 18" fuel vent hose 1 Warning to driver sticker 1 Logo label 3x2 overload blocks 1 10ml bottle Loctite 262 1 Bolt pack BP893 4 12mm x 200mm bolts 4 12mm x 180mm bol

Краткое содержание страницы № 7

Parking brake bracket Bumper cutouts