Краткое содержание страницы № 1
Cassette t!P Control
i cassette et c~~t~~le de chanlelrr 6
Receptor cun Cassette y Control Camhiador
Radii-C~ssete corn CantrQ”le par t~~hi~d~r C
Bosch Group
~~tQpedi~
Краткое содержание страницы № 2
FCC Warning The equipment has been tested and found to comply with the limits for a Class B device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy, and, if not installed and used in accordance with instructions, may cause harmful interference with radio communications. However, there is no guarantee that radio interfe
Краткое содержание страницы № 3
Table of Contents English Espaiiol 36 FCC Warning.. .................................................. .2 Advertencias FCC ........................................ .............................................. .2 Registro del Propietario ............................... 36 Owner’s Record.. Features ........................................................... 4 Caracteristicas ............................................. 37 37 Precautions ...................................................... .4
Краткое содержание страницы № 4
1 ENGLISH ] Features Congratulations on your purchase of this Blaupunkt Cassette Receiver. Its III-US FM/AM Tuner and Autoreverse Cassette Tape Player mechanism provide the ultimate in radio sound reproduction. Its high-power amplifier and 4-Channel preamp output provide you with tremendous system configuration flexibility. Its ability to control the Blaupunkt CDC-A05 and CDC-A071 CD Changers (or CDC-A08 if adapter 7607898093 is used) lets you easily incorporate CD sound into your car’s sound s
Краткое содержание страницы № 5
Detachable Face Detaching & Attaching the Face: The face of this unit can be detached and taken with you to prevent it from being stolen. Detaching the Face: Press the REL (Release) Button and detach the face by gently pulling it off as illustrated. Note: Do not pull it straight out from the chassis. Be sure not to drop the face when detaching it from the chassis. Attaching the Face: Apply the right hand side of the face to the chassis by sliding (part B) of the face to (part A) at the front of
Краткое содержание страницы № 6
Electrical Connections and Installation @/e?#&*>Q! To avoid the aggravation of costly mistakes and serious damage that could make you feel this way, please carefully read all of the instructions before you begin. Carefully follow all instructions. You’ll be glad you did! GENERAL RECOMMENDATIONS l If you’re not confident that you can install the unit correctly, have it installed by a qualified Blaupunkt installation technician. l Use this unit only with negative ground 12 Volt (11-16 Volt) direct
Краткое содержание страницы № 7
l You can use a either or both of these two methods. . Connecting the Speaker Leads To prevent short circuits or serious damage to the unit and/or speakers: l Connect the speaker leads only as indicated in the wiring diagram. Disconnect the vehicle battery’s negative terminal before making connections. l Only use speakers that have impedance ratings of 4 ohms or higher and have power-handling capabilities greater than the unit’s stated power level. l The unit’s internal amplifier is designed to
Краткое содержание страницы № 8
Installation Recommendations Carefully choose the mounting location so that the unit won’t interfere with normal driving. Avoid mounting locations where the unit would be subject to high temperatures, such as from direct sunlight or hot air from the heater, or where it would subject to dust, dirt or excessive vibration. The illustration below shows a typical installation, however, you may need to adjust the installation, depending on the unit. If you have questions or need additional installatio
Краткое содержание страницы № 9
. Mounting the Unit in a Japanese Car You may have difficulty mounting this unit in some Japanese cars that have mounting features (side-bracket mounting systems). In this case, consult your Blaupunkt dealer. 1 Run a blade along the slits on the back of the front trim ring, unscrew the two side screws, and separate it from the unit. Save the trim ring and related hardware in case you ever want to install the unit in another vehicle. 2 Use the vehicle’s own mounting hardware to attach the unit.
Краткое содержание страницы № 10
Maintenance Removing the Unit Use the Release Keys as shown below. Keep them in a safe place in case you need them in the future. Fuse Replacement When replacing the fuse, be sure to use one with the correct amperage, which will be stated on the fuse case. Never use a fuse that has a stated amperage exceeding the one supplied for this unit, as this could cause malfunction and serious damage to the unit. 10
Краткое содержание страницы № 11
. Wecifications Audio Power Specifications Power Output and Total Harmonic Distortion: 13.5 watts per channel minimum continuous average output into 4 ohms, 4 channels driven, from 30-15,000 Hz with no more than 1% total harmonic distortion. Other Specifications Tuner FM 87.5 - 107.9 MHz Tuning Range: 10.7 MHz Intermediate Frequency: 13 51 Seek lo sensitivity: 31 80 65 (stereo), 70 (mono) Signal-to-Noise Ratio: 0.7% (stereo), 0.5% (mono) Harmonic distortion at 1 30 Frequency Response: 30
Краткое содержание страницы № 12
Location of Controls 12 3 9 45 6 78 10 11 f (/ 3 CD CHhNGER ZONTRC LLER 35 WAlTS x 4 l HIGH POWER fillnl0 TS BLAUPUNKT 0 \y --r .- JJI 12 13 14151617 18 19 22 20 21 1. REL (Release) Button Balance Right 2. PWR (Power) Button Fade to Rear Source (and Radio Band) Select 3. 14. A Button 4. Cassette Eject Seek and Manual Tuning Mute/ Audio Button/ Clock Adjust:00 5. CD Track Up SCA (Scan) TS (Travelstore) 6. Audible CD Cue LD (Loudness)/ SENS (Tuning Sensitivity) 7. Clock Hours 8. Cassette Insertion
Краткое содержание страницы № 13
Ignition-Off Clock Recall Any button press while ignition off displays time for about 8 seconds. Ignition-On Unit lights up and clock is displayed. Release for Detachable Faceplate Push REL to detach face. Already-inserted cassette remains in unit. Current settings and source mode are stored. If power was not switched off before face removed, unit will automatically on when face is reattached. Power (PWR) On/Off When ignition on, press PWR or insert a disc to turn unit on. Last-used source beco
Краткое содержание страницы № 14
AUDIO TS Bass, Treble, Balance and Fade Press Mute/AUDIO for more than second to access Bass. Subsequent presses access Treble, Balance and Fade modes. Bass -Adjust from to -7 at 2 using + to increase bass, - to decrease. Treble - Adjust from to -7 at 2 using + to increase treble,- to decrease. Balance - Adjust balance from 9 (all the way left) using + to -9 (all the way right) using -. Fader - Adjust fader from 9 (sound only from the front) using + to -9 (sound only from the rear) using L
Краткое содержание страницы № 15
. Preset Station Storage After tuning desired frequency on desired band, press and hold a Preset Button for more than 2 seconds to store current frequency. Audio is muted during storage, preset number appears, and beep acknowledges storage. Preset Station Selection Press desired Preset Button. Travelstore This feature allows you to automatically store stations onto all 5 preset buttons and is especially useful when traveling outside your normal listening area. In any FM Bank, press for 2 second
Краткое содержание страницы № 16
PWR 0 l- Changer Control (When optional changer is connected.) Your receiver is ready to control a Blaupunkt CD changer with the Disc Management System, such as the CDC-A05 or changers (or CDC-A08, if adapter 7607898093 is used). See your Blaupunkt dealer for more information. Activating Changer Press SRC as many times as necessary to access Changer Mode, which is indicated in display by Track Number/Disc Number display. Display Options See page 13 for display options. In changer mode, the firs
Краткое содержание страницы № 17
Track Scan Press SCA to start Track Scan. Track Number blinks during operation. Unit stops at each track for 10 seconds. After scanning all tracks on disc, unit advances to next disc. Unit continuously scans until user stops scan by pressing SCA, another playback control or Track Scan deactivates any previously-active MIX or RPT modes. Disc Scan Press and hold SCA for more than 2 seconds to start Disc Scan. Disc Numbers blink during scanning operation. stops at first track on each disc for 10
Краткое содержание страницы № 18
l BLAUPUIVKT,- Bosch Group German Headquarters: Blaupunkt-Werke GmbH Postfach 77 77 77 D-31 132 Hildesheim Germany Robert Bosch Corporation Sales Group - Blaupunkt Division 2800 South 25th Avenue, Broadview, Illinois 60153 I-800-950-BLAU Robert Bosch, SA., DE, C. V. Dr. Lucia 270 Cols. Doctores, Mexico 06720 Made in Malaysia Fabrique en Malasie Hecho en Malasia Fabricado en Malaysia Copyright 1997 by the Robert Bosch Corporation No portion of this work may be reproduced in any form without the w
