Краткое содержание страницы № 1
B
D
/
L
INSTRUCTION MANUAL
MODEL : A66HY
CAR CD / MP3 PLAYER / RDS RECEIVER
WITH USB/SD/MMC INTERFACE
AND BUILT IN BLUETOOTH
HANDSFREE SYSTEM
MIC
CLA S SIC LOUD TP
POP
DSP
MENU ID3(0)
(7) (8) (9)
2 SCN 3 RPT 4 SHF 5 DN AF
6 UP PTY TA
AMS
DISP
DSP
MODE
D
/
E
D - A U D
N
T
Краткое содержание страницы № 2
B B D D / / L L FUNCTIONS OF LOCATION PANEL FUNCTION RELEASE SELECT CD DSP EJECT BUTTON BUTTON SLOT MICROPHONE BUTTON BUTTON MIC CLA SSIC LOUD TP POP DSP MENU (7) (8) (9) ID3(0) 2 SCN 3 RPT 4 SHF 5 DN 6 PTY UP TA AF AMS DISP DIRECTORY AF MODE POWER AMS/ CD CD CD CD PTY TA BAND/ UP/DOWN BUTTON BUTTON BUTTON MP3 PAUSE SCAN REPEAT SHUFFLE BUTTON BUTTON LOUDNESS / BUTTONS MENU BUTTON BUTTON BUTTON BUTTON MP3 BUTTON ENTER BUTTON ENCODER VOLUME MUTE TALK KNOB BUTTON BUTTON MIC CLA SSIC LOUD TP POP D
Краткое содержание страницы № 3
HANDLING COMPACT DISCS MOISTURE CONDENSATION On a rainy day or in a very damp area, moisture may condense on the lenses inside the unit. Should this occur, the unit will not operate properly. In such a case, remove the disc and wait for about an hour until the moisture has evaporated. NOTES ON CDs NOTES ON DISCS 1. A dirty or defective disc may cause sound If you use the discs explained below, the sticky residue can cause the CD to stop dropouts while playing. To enjoy optimum spinning and
Краткое содержание страницы № 4
INSTALLATION Before finally installing the unit, connect the wiring temporarily and make sure it is all connected up properly and the unit and system work properly. Use only the parts included with the unit to ensure proper installation. The use of unauthorized parts can cause malfunctions. Consult with your nearest dealer if installation requires the drilling of holes or other modifications of the vehicle. Install the unit where it does not get in the driver's way and cannot injure the passe
Краткое содержание страницы № 5
DIN REAR-MOUNT (METHOD B) Installation using the screw holes on the sides of the unit. Fastening the unit to the factory radio mounting bracket. 1. Select a position where the screw holes of the bracket and the screw holes of the main unit become aligned (are fitted) and tighten the screws at 2 places on each side. 2 2. Screw(must not use more than 6mm length) 3. Factory radio mounting bracket. 4 4. Dashboard or Console 5 5. Hook (Remove this part) 3 Note: the mounting box, outer trim ring, a
Краткое содержание страницы № 6
ELECTRICAL CONNECTION a. Make sure your car battery is a 12 volt (6 filler caps) negative ground system (if not, a converter will be necessary). b. Before starting wiring connections, disconnect the power supply by removing the fuse from the fuse box. c. Connect the power wire to one of the extra terminals of the fuse box. d. Connect the black ground wire to a metal part of the car. It is important to make good contact. e. Make other wiring connections as shown. f. If your car does not
Краткое содержание страницы № 7
AUDIO OPERATIONS ENCODER VOLUME KNOB Turn this knob to adjust desired volume level. FUNCTION SELECT BUTTON Press this button to select desired audio function. ORDER OF FUNCTION: VOLUME(VOL) -> BASS(BAS) -> TREBLE(TRE) ->BALANCE(BAL) ->FADER(FAD) While the selected function is displayed, turn Volume Knob to adjust the level within 5 seconds, otherwise the unit will return to volume adjustment mode. MUTE BUTTON Press this button to mute the sound. Press it again to resume listening. DSP BUTTON
Краткое содержание страницы № 8
AUTO MEMORY STORE/PRESET SCAN BUTTON (AMS) 1.PRESET SCAN: Press AMS button briefly enter Preset Scan mode, it will scan all the preset stations in the memories, you can hear that will stay on each station for about 5 seconds. 2.AUTO MEMORY STORE: Press AMS button long to enter Auto Store mode, this feature will automatically scan the current band and enter up to 6 strongest stations into the 6 preset memories. To stop Auto Store & Scan, press the AMS button again. STATION PRESET BUTTONS (M1-
Краткое содержание страницы № 9
RDS OPERATIONS OVERVIEW OF THE RDS FUNCTION Radio Data System (RDS) is a broadcasting service that allows FM stations to send additional digital information along with the regular radio program signal. Your car stereo offers you a variety of services. Here are just a few: - PI (Program identification) It is a code that identified RDS stations; it is unique for each station. - PS (PROGRAM Service Name) The name of current station, it is shown on the display. - AF (Alternative Frequencies Lis
Краткое содержание страницы № 10
PROGRAMMABLE OPTIONALS To use this function keep press long SEL Button for few seconds, each time you press this button the mode will move and the functions will shown on the display, turn the encoder volume knob up/ down to set the desires functions ,the function states as following: - TA SEEK, TA ALARM To determine what action will the radio take if the newly tuned station does not receive TP information for 5 seconds. TA SEEK The radio retunes to a different station which contains TP
Краткое содержание страницы № 11
RDS OPERATIONS AF BUTTON Press this button briefly to switch on or off the AF follow mode, the state of the AF follow mode will be indicated on the LCD by the "AF" icon: Icon Off : AF follow mode off Icon On : AF follow mode on and RDS reception OK Icon Flashing : AF follow mode selected, but no RDS data received When AF follow mode is on, the radio will from time to time measure the signal strength of the alternative frequencies that come with the RDS data. When an altern
Краткое содержание страницы № 12
MMC/SD CARD & USB DEVICE OPERATIONS START THE USB DEVICE MODE P.1 1.The USB socket is accessible as indicated in picture 1.(P.1) USB SOCKET 2.Plug in the USB drive / device completely as indicated in picture 2(P.2) and display will show “USB PLAY” to indicate that the USB drive / device is being plugged in correctly & the download has begun. 3.Does not matter the unit is in what mode (TUNER, CDC, CD, SD/MMC, etc), once a USB drive / device is being P.2 plugged into the unit, unit will a
Краткое содержание страницы № 13
START THE SD/MMC MODE P.4 1.Press panel release button to release the front panel.(P.4) 2.The SD/MMC card slot is located on top of the front panel as indicated in (P.5). 3. Insert the SD/MMC card into the card slot in the correct direction until a “CLICK” sound is heard. 4.Close the front panel. 5. The display will show “SD PLAY” to indicate that the SD or P.5 MMC card is correctly inserted. Once the SD or MMC card is inserted, the MP3 file will automatically loaded & playback will also
Краткое содержание страницы № 14
MP3 OPERATIONS Notes : - An MP3 directory is shown in this manual as “Directory”, and an MP3 file is shown as “Track”. - Maximum length of file name : 28 characters. - Maximum length of directory : 16 characters. - Maximum number of tracks per disc : 254. - Maximum number of directories per disc : 128. - Sampling Frequencies support : 32KHz, 44 KHz, 48KHz. - Bit Rates support : 64 - 320KHz including VBR. - Supports Multi-Session recording. - Supports CD, CDR and CDRW. (Playback of MP3, CD-R and
Краткое содержание страницы № 15
ID3 TAG Press DISPLAY button repeatedly to Display ID3 TAG information. If the MP3 file is available with ID3 TAG, pressing the display button repeatedly will show information in the following sequence: SONG TITLE > ARTIST> ALBUM TITLE If any of the ID3-TAG information is not available, pressing the DISPLAY button repeatedly will show information in the following sequence: UNKNOWN SONGNAME> UNKNOWN ARTIST> NO ALBUM TITLE If the MP3 file is without ID3 TAG, pressing the DISPLAY button, & “NO
Краткое содержание страницы № 16
INSTRUCTION FOR HANDFREE FUNCTION SET UP a. Press panel release button to release the front panel. b. The PAIR button is located on bottom right of the front panel as indicated. c. Press PAIR Button about 4 seconds, the LED indicator twinkle rapidly, and it enters into Pairing Mode (Headset or handsfree profile or both). d. Turn the phone to Bluetooth Menu, then scan Bluetooth set named CAR_AUDIO_HF and enter the connecting password (0000) to connect Bluetooth set after successful sca
Краткое содержание страницы № 17
The Bluetooth symbol (...) and the connected symbol (< / >) on the mobile phone will be different from one to another. Please refer lo the corresponding specification. The TALK Button LED turns on when an audio connection exists (e.g. talking) or when it is ringing. When the main unit turns on, if there is a call incoming, it will auto switch to talk state. When you hang up the phone, the main unit will revert to previous state (radio, CD or other mode). When the main unit turns off (wit
Краткое содержание страницы № 18
SPECIFICATIONS CD PLAYER System Compact disc audio system Usable disc Compact disc, CD-R, CD-RW (AUDIO/MP3 format) Sampling frequency 44.1KHz No of quantization bits 1bit Frequency 5-20,000Hz Number of channels 2 stereo S/N Ration 70dB RADIO SECTION FM Frequency Range 87.5 - 108 MHz 10.7 MHz Intermediate Frequency Usable Sensitivity Better than 15dB at S/N 30 dB 25 dB at 1KHz Stereo Separation S/N Ratio 50 dB AM (MW) Frequency Range 522 - 1620 KHz 450KHz Intermediate Frequency Usable Sensitiv
Краткое содержание страницы № 19
TROUBLE SHOOTING Before going through the check list, check wiring connection. If any of the problems persist after check list has been made, consult your nearest service dealer. Symptom Cause Solution If the power supply is properly connected No power The car ignition is not on. to the car accessory terminal, switch the ignition key to “ACC” The fuse is blown. Replace the fuse. Remove the disc in the player, then put a Disc cannot be loaded Presence of CD disc inside new one. or ejected th
