Краткое содержание страницы № 1
H-CMD7087
DVD/CD/MP3 RECEIVER WITH BLUETOOTH
DVD/CD/MP3- C BLUETOOTH
Instruction manual
Краткое содержание страницы № 2
Dear customer! Thank you for purchasing our product. For safety, it is strongly recommended to read this manual carefully before connecting, operating and/or adjusting the product and keep the manual for reference in the future. Table of contents Table of contents ...............................................................................................................................................2 Important safeguards .....................................................................
Краткое содержание страницы № 3
Important safeguards Using the device at temperature below -10º may cause the breakage of the device. Before using please heat up the passenger compartment to the recommended temperature! Disconnect the vehicle's negative battery terminal while mounting and connecting the unit. When replacing the fuse, be sure to use one with an identical amperage rating. Using a fuse with a higher amperage rating may cause serious damage to the unit. Do not attempt to disassemble the unit. Laser beams from
Краткое содержание страницы № 4
Accessories Receiver 1 pc Remote controller 1 pc Panel protective case 1 pc AV cable 1 pc USB cable 1 pc Mounting parts: set ISO cable 1 pc Release keys 2 pc Screw 20 1 pc Bolt 6 4 pc Washer 2 pc Mounting strap 1 pc Rubber 1 pc Customer information 1 pc Warranty card 1 pc Instruction manual 1 pc 4
Краткое содержание страницы № 5
Installation/connection Attention: Remove the transport CD stopper (2 screws) before use. Din front-mount (method 1) After inserting the holder into the dashboard, select the appropriate tab and bend them inwards to secure the holder in place. 1. Dashboard 2. Nut (5mm) 3. Spring washer 4. Screw (5 x 25mm) 5. Screw 6. Strap 7. Plain washer Removing the unit frame Insert fingers into the groove in the front of frame and pull out to remove the frame. (When reattaching the frame, point the side wit
Краткое содержание страницы № 6
Din rear-mount (method 2) Installation using the screw holes at both sides of the unit. 1. Select a position where the screw holes of the main unit are fitted for aligned, and tighten the screws at 2 positions at each sides. Use either truss screws (5 x 8mm) or flush surface screws (4 x 8mm), depending on the shape of the screw holes in the bracket. 2. Screw. 3. Factory radio mounting bracket. 4. Dashboard or Console. 5. Hook (Remove this parts). Note: The mounting box, outer trim ring, and the
Краткое содержание страницы № 7
Attaching the control panel 1. Insert the right side of the control panel into the main unit (pic. 3). 2. Press the control panel on to the left side of middle of it until a “click” sound is heard (pic. 4). Pic. 4 Pic. 3 Caution: Do not insert the control panel from the left side. It can damage the control panel. The control panel can easily be damaged by shocks. After removing it, place it in a protective case and be careful not to drop it or subject it to strong shocks. The rear connector t
Краткое содержание страницы № 8
Electrical connection Caution: Do not interchange the connection of the wiring! For some car models you may need to modify wiring of the supplied power cord. Contact your authorized car dealer before installing this unit. Note: 2 cable is connected to a Hands-Free device (not included). 8
Краткое содержание страницы № 9
Parking wire NThe parking wire is connected with brake signal; for safety, the programs can be seen on the monitor after braking the car. 9
Краткое содержание страницы № 10
Panel controls Front panel 1. PWR/MUTE button 2. Microphone 3. 1/PLAY/PAUSE button 4. 4/RANDOM button 5. 2/RPT button 6. 5/DIR- button 7. 3/INT button 8. 6/DIR+ button 9. OPEN button 10. USB jack 11. 9/PTY/SCN button 12. #/BAND/LOUD button 13. 8/TA/DSP button 14. 0/DISP/DUAL button 15. 7/AF/MONO button 16. */AS/PS button 17. AV IN 18. IR sensor 19. LOC button 20. REJECT CALL button 21. MODE button 22. SEL button 10
Краткое содержание страницы № 11
23. NEXT/T-UP, PREVIOUS/T-DN buttons Inner panel 24. VOL+/- buttons 25. ACCEPT CALL button 26. SD/MMC button 27. EJECT button 28. Light indicator 29. RESET button 30. Disc slot 11
Краткое содержание страницы № 12
Remote control 1. DISP/DUAL button 2. STANDBY button 3. OSD button 4. ST/MO button 5. SETUP button 6. ENTER button 7. PREVIOUS/NEXT button 8. ANGLE button 9. VOL- button 10. SEL button 11. BAND/RDM button 12. AUDIO/GOTO button 13. Number buttons 14. P.SCN/RPT button 15. TITLE button 16. DSP button 17. MODE button 18. MUTE button 19. MENU button 20. Cursor buttons (LEFT, RIGHT, UP, DOWN) 21. PLAY/PAUSE button 22. INT button 25. A-B/ZOOM button 23. VOL+ button 26. SUB-T button 24. STOP/PBC button
Краткое содержание страницы № 13
Changing the battery 1. Press the catch and at the same time pull out the battery tray. 2. Insert the 1 x lithium battery, type CR 2025 3V battery with the stamped (+) mark facing upward. Insert the battery tray into the remote control. Warning: Store the battery where children cannot reach. If a child accidentally swallows the battery, consult a doctor immediately. Do not recharge, short, disassemble or heat the battery or dispose it in a fire. Do not expose or bring into contact the battery
Краткое содержание страницы № 14
General operations Reset the unit Operating the unit for the first time or after replacing the car battery, you must reset the unit. Press OPEN button on the panel to open the panel and press RESET button to restore the unit to the original factory settings. Power button Press any button on the panel or STANDBY button on the RC to turn on the unit. Press and hold PWR button on the panel or STANDBY button on the RC to switch the unit off. Note: After the unit is off, the volume level and radio cu
Краткое содержание страницы № 15
Setting other characteristics During TUNER mode press SEL button and hold for 2 seconds, shortly and repeatedly press SEL button to select the setting: TA SEEK => PI MUTE => RETUNE L => MASK DPI =>TA VOL => EON TA =>BEEP=> DISP REV. TA SEEK/TA ALARM To choose the TA mode, press SEL button for 2 seconds, then press it repeatedly until the display shows TA SEEK or TA ALARM. Press VOL +/- buttons to choose between the TA SEEK and TA ALARM. After choosing, please leave the unit idle to activate. In
Краткое содержание страницы № 16
BEEP Turn BEEP on if you want the pressing of buttons to be sounded. Press SEL button until the display shows nd BEEP, then press VOL +/- buttons to turn BEEP sound ALL or OFF or 2 (you hear BEEP sound when you press the button over 1.5 seconds). DISP REV: Press VOL +/- buttons to select LED display color between black and white. Turning the sound off Press MUTE button to turn the sound off. Press it again or press VOL +/- buttons to turn the sound on. Mode setting Press MODE button on the panel
Краткое содержание страницы № 17
Digital tuner operations Note: RDS (Radio Data System) service availability varies with areas. Please understand if RDS service is not available in you area, the following service is not available, either. RDS overview PI: Program Identification Code – for identifying code. PS: Program Service Name Broadcast – station name data expressed in alphanumerically character. TP: Traffic Program Identification – for traffic information broadcasting station. TA: Traffic Announcement Identification – show
Краткое содержание страницы № 18
- Select a band (if needed) - Select a station by pressing T-DN/T-UP buttons on the panel or PREVIOUS/NEXT buttons on the RC. - Hold a Preset button (1-6), which you want store the station for at least 2 seconds. To recall a station: - Select a band (if needed) - Press a Preset button (1-6) briefly to recall the stored station. AF/MONO button Press AF/MONO button to enable AF mode. Press and hold AF/MONO on the unit or press ST/MO on the RC to choose MONO or STEREO. Auto memory store Select a b
Краткое содержание страницы № 19
AF (Alternative Frequencies) function Press AF/MONO button on the panel shortly to turn on or turn off the AF function. If the AF function is on the display will show “AF”. When AF switching mode is selected, but RDS information is not received yet the “AF” will be flashing. The RDS program will be automatically searched and received. After turning on, if the RDS signal is weak or even no signal, the unit will search another frequency with this RDS program. Default setting is ON. PTY (Program Ty
Краткое содержание страницы № 20
Disc glossary PBC (PlayBack Control) PBC is a menu recorded on the disc with SVCD or VCD2.0 format. For the discs contained PBC, it can playback interactive software with the menu displayed on TV. And if the disc contains still images, it can playback high definition of still image. Title The title is the important part of DVD disc. The memory volume of the disc is rather big, that makes possible to record several films on one disc. For example, if a disc contains three films, they may be divide
