Руководство по эксплуатации Ariens SBXC900SS

Краткое содержание страницы № 1

CHIMNEY COOKER HOOD


INSTRUCTION MANUAL


















Model No.: SBXC600SS / SBXC900SS


 PLEASE READ THE MANUAL CAREFULLY BEFORE OPERATION 

Краткое содержание страницы № 2

GENERAL 1. Carefully read the following important information regarding installation safety and maintenance. Keep this information booklet accessible for further consultations. 2. The appliance has been designed as a exhausting version (external exhaust) or as a charcoal filter version (internal air recycle) cooker hood. SAFETY PRECAUTION 1. Take care when the cooker hood is operating simultaneously with an open fireplace or burner that depends on the air in the environment and is supp

Краткое содержание страницы № 3

MAINTENANCE Proper maintenance of the Range Hood will assure proper performance of the unit. DISPOSAL Do not dispose this product as unsorted municipal waste. Collection of such waste separately for special treatment is necessary. Grease Filters The grease filters should be cleaned frequently. Use a warm detergent solution. Grease filters are washable. See “ INSTALL FILTERS” section for removal and installation instructions. Non-Ducted Recirculation charcoal filter The non-ducted

Краткое содержание страницы № 4

PREPARE THE HOOD Unpack hood and check contents. You should receive: 1.- Hood 1 - Glass 1 – Decorative Chimney ( bottom or both bottom and top ) 1 – Parts Bag: 1 – Hood Mounting Bracket 1 – Chimney Mounting Bracket 1 – Discharge Collar 2 – Chimney Bracket Screws (ST 4 X 8 mm ) 3 – Chimney Bottom Fixing Screws (ST 4 X 8 mm ) 5 – Mounting Screws (ST 5 X 50 mm ) 5 – Drywall Anchors 1 – Installation Manual 2 – Charcoal Filters (optional) 1 – Wall Cap (optional

Краткое содержание страницы № 5

INSTALL THE DUCTWORK (DUCTED HOODS ONLY) Caution: To reduce the risk of fire, use metal ductwork is preferred. 1. Decide where the ductwork will run between the hood and the outside. 2. A straight, short duct run will allow the hood to perform most efficiently. 3. Long duct runs, elbows, and transitions will reduce the performance of the hood. Use as few of them as possible. Larger ducting may be required for best performance with longer duct runs. 4. The air must not be discharge int

Краткое содержание страницы № 6

INSTALL THE HOOD Minimum hood distance above cooktop must not be less than 650mm. A maximum of 750mm above the cooktop is highly recommended for best capture of cooking impurities. Distance over 750mm above the cooktop are at the installer’s and user’s discretion - providing that ceiling height and flue length permit. 1. Secure the hood mounting bracket to the wall using ST 5 x 50mm mounting screws and dry wall anchors. Align the hood body with the hood mounting bracket. Gently lower

Краткое содержание страницы № 7

INSTALL FILTERS (DUCTED AND NON-DUCTED HOODS) 1. To remove the grease filter, push in on them metal latch tab. This will disengage the filter from the hood. Tilt the filter downward and remove. 2. To install the grease filter, align rear filter tabs with slots in the hood. Push in the metal latch tab, push filter into position and release. Make sure the filter is securely engaged after assembly. (NON-DUCTED HOODS ONLY) 1. To install the charcoal filter, and lock it until the stop cl

Краткое содержание страницы № 8

EXPLODED VIEW 7

Краткое содержание страницы № 9

WIRING DIAGRAM stop low mid high lamp key switch Control Panel NL brown Electronic yellow-green Transformer yellow AC 12V blue lamp white 8 brown grey black blue