Руководство по эксплуатации Air King AKCV1380

Краткое содержание страницы № 1

IMPORTANT INSTRUCTIONS -
OPERATING MANUAL
Models AKCV1225,
Central Vacuum
AKCV1380, AKCV1310
READ AND SAVE THESE INSTRUCTIONS
READ CAREFULLY BEFORE ATTEMPTING TO ASSEMBLE, INSTALL, OPERATE OR MAINTAIN THE PRODUCT DESCRIBED. PROTECT
YOURSELF AND OTHERS BY OBSERVING ALL SAFETY INFORMATION. FAILURE TO COMPLY WITH
INSTRUCTIONS COULD RESULT IN PERSONAL INJURY AND/OR PROPERTY DAMAGE!
RETAIN INSTRUCTIONS FOR FUTURE REFERENCE.
GENERAL SAFETY INFORMATION
When using electrical appliances, basic precaution

Краткое содержание страницы № 2

Debris INSTALLATION INSTRUCTIONS 1. Unpack central vacuum power unit from the carton and confirm that all 45° Elbows pieces are present. In addition to the power unit you should have: 45° Wye 1 - Power unit mounting bracket Trunk Line 1 - Inlet valve 1 - Instruction/Safety Sheet Obstruction Stop Planning the Installation Coupling The Air King Central Vacuum System consists of three major components. The Trunk Line to Branch power unit, fittings including the inlet valves and tubing, and the tool

Краткое содержание страницы № 3

Installing the Tubing Installing Wall Inlet Models CVIV60A or CVIV60W NOTE: When installing the tubing, start at the farthest inlet and work towards CAUTION: INSTALLATION WORK AND ELECTRICAL WIRING MUST the power unit. Keep the tubing as straight as possible with the least amount BE DONE BY QUALIFIED PERSON(S) IN ACCORDANCE WITH ALL APPLICABLE of elbows and tees as possible to ensure maximum performance of your system. CODES AND STANDARDS, INCLUDING FIRE-RELATED CONSTRUCTION. When installing tee

Краткое содержание страницы № 4

8. Align the inlet screw holes with the mounting plate holes and lightly press Installation into Existing Construction the inlet into place, guiding any extra wire back through the mounting plate Installing the Inlet Valves as you go. Attach wall inlet to mounting plate with provided screws making sure mounting plate is properly seated in hole (Figure 12). 1. Once the desired location of the inlet has been determined, drill a small pilot hole through the subfloor directly below the center of the

Краткое содержание страницы № 5

2. Your unit is equipped with a self cleaning filter and it should not be removed. Wiring If an excess of debris has built up on the filter you can simply shake it off. 1. Make connections to low voltage wire from inlet to inlet in parallel. Connect It is recommended that you place a large plastic garbage bag under the any low voltage wire along trunk and branch lines using suitable wire unit when doing this. connectors. Connect the low voltage wire to crimp connectors located on the top outside