Руководство по эксплуатации Snapper 7-4510

Краткое содержание страницы № 1

SETUP INSTRUCTIONS AND PRE-OPERATION CHECKLIST FOR
SNAPPER GROUNDS CRUISER UTILITY VEHICLE

INTRODUCTION: These instructions cover the setup of the Snapper Grounds Cruiser utility vehicle. Complete
each step carefully. A checklist has been provided. It is very important to verify and record each item on the
list prior to placing the machine into service. The dry weight of the machine you are about to setup is 1,230 lb. It
is strongly recommended that you use an overhead hoist when lifti

Краткое содержание страницы № 2

3. Place (1) 1/2” x 1 1/4“ diameter flat washer on (1) STEP 3 7/16-20 x 2” bolt. Insert bolt with washer into seat INSTALL FRONT TIRES belt mounting plate. See Figure 1.3. The front bumper can be used to lift the front of the 4. Insert bolt into hole in seat support. Place large machine. Block the machine to prevent it from falling. 2 1/2” diameter flat washer over bolt against inside NOTE: The front tires are directional. Install with valve surface of seat support. stems out an

Краткое содержание страницы № 3

STEP 6 STEP 7 INSTALL OPERATOR PROTECTIVE ENGINE OIL AND TRANSMISSION FLUID The engine oil and transmission fluid must be checked STRUCTURE (OPS) before operation. The installation of the Operator Protective Structure 1. Fill engine crankcase to proper level. Refer to requires two people. The mounting hardware for the Engine Owner’s Manual for capacity and oil OPS and seat belts must be properly torqued. Do Not specifications. Check with dipstick unthreaded. modify the OPS in any way.

Краткое содержание страницы № 4

STEP 8 (Continued) WARNING ACTIVATE BATTERY Shield the positive terminal with Terminal Cover located on Positive Battery Cable. This prevents 8. Thoroughly clean any spilled acid from battery. metal from touching the positive terminal, which Neutralize with Baking Soda and flush with large could cause sparks. quantity of water. Dry off battery. 9. Install battery into power unit. Place battery into battery tray and secure in place with retaining rod. See Figure 1.5.

Краткое содержание страницы № 5

STEP 10 (Continued) INSTALL OPERATOR’S AND PASSENGER’S SEAT (3) SEAT BOLTS 1/2-13 X 3” BOLT & 1/2-13 NYLOC NUT HINGE ROD 1/2-13 X 3 3/4” BOLT & 1/2-13 NYLOC NUT PROP ROD FIGURE 1.8 STEP 12 ALIGN CARGO BED LATCH HAIRPIN Lower the Cargo bed slowly until the latch contacts the striker pin. The head of the striker pin should be inside FIGURE 1.7 of the latch as shown in figure 1.9. If it is not aligned correctly, loosen the bolts that attach t

Краткое содержание страницы № 6

PRE-OPERATION CHECKLIST FOR SNAPPER GROUNDS CRUISER Snapper has completed initial adjustments and performed operational tests prior to shipping the machine. Due to the possible effects of shipping, handling and storage, Snapper intends for all of the following items to be verified and necessary final adjustments made at time of setup. It remains good practice and is strongly recommended that all the items also be checked prior to placing the machine into service. It is very important tha