Руководство по эксплуатации JL Audio Stealthbox SB-N-ARMAD/10W6v2

Краткое содержание страницы № 1

®
Stealthbox
INSTALLATION GUIDE START
HERE
for the
SB-N-ARMAD/10W6v2
(2004-Up Nissan Armada, without the power
lift gate)
STEP 1: Clear out any contents from the STEP 2: Fold down the third row seating. STEP 3: Remove the driver’s side rear stor-
cargo area. age door and remove the jack.
This Stealthbox is a product which
requires professional installation skills and
tools.
Please read this installation guide thor-
oughly before beginning the project. It
will guide you step by step through the

Краткое содержание страницы № 2

Cont. From Previous Page ➔➔➔ STEP 7: With a 14mm socket, remove the dri- STEP 8: With a 14mm open end wrench, STEP 9: Remove the driver’s side rear door sill STEP 10: Remove the cargo net loop, that is ver’s side third row seat belt. remove the driver side second row seat belt. plate. found on the driver’s side rear cargo side panel. With a small flat blade screw driver, pop the front of the button out. Remove the net loop assembly com- pletely out of the panel. ➔➔ STEP 11: With a second person,

Краткое содержание страницы № 3

Cont. From Previous Page STEP 13(C) STEP 13(B): You can use different cutting tools. STEP 14: Use a sanding wheel or just sand paper Here we used a cutting wheel. to clean off the edge off the cut. 3/4” 1-1/4” STEP 15: Back inside the SUV, Look into the area that the Stealthbox is going to STEP 16: There is a metal lip to the right. On this lip there is also an exposed hole. reside.There is a metal lip to the left. On this lip there is an exposed hole. Measure 3/4” Measure 1-1/4” from the middle

Краткое содержание страницы № 4

Cont. From FLAT WASHER Previous HEX NUT Page TAP BOLT ➔➔ LOCK WASHER VEHICLE'S SHEET METAL FLAT WASHER STEP 18: Place the supplied slotted mounting bar STEP 19: With the slotted mounting bar into posi- STEP 20: Replace the driver’s side rear cargo STEP 21: Run speaker wire from the amplifier into mounting area.The bar will go behind the open- tion. Place a supplied 1/4”lock washer, 1/4” flat wash- location to the Stealthbox. Make sure that the panel, rear belts, driver’s side rear door sill plat

Краткое содержание страницы № 5

Cont. From Previous THREADED INSERT Page STEALTHBOX WALL CONGRATULATIONS! INSTALL COMPLETE. ➔➔ VEHICLE SHEET METAL FENDER WASHER SOCKET CUP SET SCREW FLAT WASHER LOCK WASHER Included Hardware: HEX NUT 2) 3/8-16x1 Hex Tap Bolt 3) 3/8” Split Lock Washer STEP 25: Reach up through the removed vent STEP 26: Replace side carpet, cargo cleats, carpet- STEP 27: Secure the jack with the pair of straps 5) 3/8” Flat Washer area from STEP 22. Place the supplied fender ed storage flooring and floor storage d