Руководство по эксплуатации JL Audio Stealthbox SB-GM-SLVCRW/10W1v2

Краткое содержание страницы № 1

SB-GM-SLVCRW/10W1v2_INSTR_SKU#011173
INSTALLATION

D I F F I C U L T Y :

If you choose to perform the installation yourself, it is absolutely vital that
®
OUT
the Stealthbox be properly mounted to the vehicle according to these
OF
instructions. Failure to mount the enclosure properly presents two problems:
I N S T A L L A T I O N G U I D e
for the 1) The sub-bass performance will suffer due to the movement of the enclosure
55
cau

Краткое содержание страницы № 2

SB-GM-SLVCRW/10W1v2_INSTR_SKU#011173 S T e P 4 S T e P 8 With a Phillips screw driver, remove the two screws that Passenger's side: secure the driver’s side c-pillar to the rear wall. Grab the black plastic box(vent column) and pull it towards the front of the truck, until it clears the threaded stud(circled). No mounting hardware secures this vent column to the truck. After the vent column is free from the threaded stud, lift up and pull the vent column out. The vent that is mounted to the

Краткое содержание страницы № 3

SB-GM-SLVCRW/10W1v2_INSTR_SKU#011173 HD Series Trucks Only S T e P 1 2 S T e P 1 6 With cut off wheels or a saw, remove the four (two are Place the pair of supplied wax square into place. circled) rear wall ledges. These support the folding floor Passenger's side(pictured): extensions. Place one of the supplied wax squares onto the lower left corner of the same emboss metal that the threaded stud Cut as flush to the rear wall as possible. was located on. Driver's side(not pictured): Place

Краткое содержание страницы № 4

SB-GM-SLVCRW/10W1v2_INSTR_SKU#011173 S T e P 2 0 I N C L U D e D H A R D W A R e If an amplifier is to be mounted onto the Stealthbox®. (4) #10 x 3/4 Phillip pan head sheet metal screws (2) 3/8" - 16 x 2-1/4" Socket Cup Set Screw Drill the mounting holes in the proper location. Apply (2) 3/8" Split Lock Washer (2) 3" x 3" Wax Squares silicone to the four supplied Phillip head screws before (2) 3/8" Flat Washer securing the amplifier. (2) 3/8" x 1-1/4” Fender Washer Run speaker wire