Руководство по эксплуатации PYLE Audio PSW501SF

Краткое содержание страницы № 1

2
1
Step Step 4: 4: Hanging Hanging display display
Firstly lift the bracket mounted display over the wall mount. And then hook the
brackets over the top of the wall mount. Rotate the display let the bottom of the
brackets hook over the bottom of wall mount, as shown in Fig.4a. Then put safe
bolts into the bottom of the brackets and lock it, as shown in Fig.4b.
W Wa arning: rning: Some TV require two people to lift, as we are not responsible for any Fixed Flat Panel TV Bracket
personal injury or

Краткое содержание страницы № 2

Har Hard dwar ware e List: List: Actual parts appearance and the quantity may different After determining the height of stand, follow the installation instructions in below with illustrated. to install wall mount to different kinds of wall -wooden, brick, concrete and stone. 2 2 W Wooden ooden wall: wall: 1 Using a awl or nail to make where the nails are located, as shown as Fig.3b. Distance between two nails for fixing wall mount must not less than 16”. Slide the plate into position as required

Краткое содержание страницы № 3

Step Step 2: 2: Install Install the the Cable Cable Cover Cover WARNING Route the cables as required. Snap the cable cover into place onto the rods (Fig. 2a), and then slide the cover into position as required. We are not responsible for any personal injury or product damage due to mishandling, (Fig. 2b) incorrect mounting, incorrect assembly or incorrect use of this product. Note: The supplied wall mounting hardware is not for use on steel stud walls or cold cinder block walls. If you are uncer

Краткое содержание страницы № 4

Following examples shows how to use bolts, spacers and square washers. 2. Some displays have curved backs with recessed mounting lands(Fig.a). It will 1.Some displays have vertical backs. No spacer is required. Install the bracket directly require the use of spacer. For this display, to the back of display by using bolts and square washers provided. As shown in Fig.1a. install a spacer(K) between display and Fig a thebracket.Asshown in Fig1b. M4 Fig bit M5 Fig bit M5 Fig bit M6 Fig bit G K A,B E