Краткое содержание страницы № 1
www.usamps.com
A AX X s ser eri ies es
Owner Owners Manual s Manual
a and nd
I Inst nstallation allation
G Guide uide
Copyright 2007 U.S.Amps. All rights reserved.
Краткое содержание страницы № 2
Thank you for choosing U.S.Amps! You have purchased the finest product of its type available. Each product is tested and built in our California factory. You won’t just listen to your U.S.Amp; you’ll experience it. When properly installed, this unit will provide years of trouble-free service. This manual is written for the experienced installer. Please read it ALL before installa- tion! You may need to make changes in your installation to properly connect and operate this fine product. If yo
Краткое содержание страницы № 3
Did You Buy the Right U.S.Amp? There is a U.S.Amp for every purpose! From raw power to exquisite sound quality and everything in between, U.S.Amps offers state-of-the-art technology to meet your every need. INSTALLATION Amplifier Mounting: Choose an appropriate location to mount the amplifier(s). Make sure your choice is free from excess heat, moisture, and vibration. Under the vehicle seat or in the trunk are common mounting locations. Be sure the amplifier receives adequate ventilation to i
Краткое содержание страницы № 4
CARE AND FEEDING OF YOUR BATTERIES As mentioned before, most batteries are built for the relatively light chore of starting the engine. Unless you have the room and ambition to install an upgraded high-powered alternator, your system current requirements may exceed the charging capability of your car’s electrical system. When this happens, you have to rely on the vehicle battery(s) to make up the difference. Another factor to consider is voltage. Although the electrical system is considered
Краткое содержание страницы № 5
AX-TU600C 2-Channel Amplifiers Controls and Features 1 2 3 4 5 6 7 8 Off On HP Full LP L Pwr Prot Min 50 500 50 500 SUB Subsonic HP INPUT SUB XOver Filter Freq Gain Freq RBG R AX X-TU600C -TU600C In Out U.S.A. “VTCSD” Technology 1 Amplifier Input The amplifier MUST receive input on BOTH RCA jacks for proper operation. 2 Amplifier Output The low level output can be connected to other amplifiers. 3 Input Gain is variable from 1 to 9 volts for full output. Best results are achieved by adjusting t
Краткое содержание страницы № 6
AX-1000/2000 2-Channel Amplifiers Controls and Features 1 2 3 4 5 6 7 Off On Off On L Pwr Prot Min 50 500 SUB Subsonic INPUT SUB XOver Filter Gain Freq RBG R AX- X-1000 000 In Out Two Ohm Stable Design U.S.A. (Shown here is AX-1000, but the diagram is also applicable to AX-2000.) 1 Amplifier Input The amplifier MUST receive input on BOTH RCA jacks for proper operation. 2 Amplifier Output The low level output can be connected to other amplifiers. 3 Input Gain is variable from 1 to 9 volts for fu
Краткое содержание страницы № 7
+ + + AX-TU4360C 4-Channel Amplifiers Controls and Features The AX-4360C features a selectable two-way electronic crossover with independent front and rear mid-high frequency adjustment and 2 ohm per channel stability. Power is provided by four 75 watt channels that can be bridged as front and rear pairs into a 4 ohm load for a total of 180 watts per bridged pair. WARNING: NEVER use ground-loop isolation on the input of your U.S.Amp! It doesn’t need it! 1 2 3 4 5 + Front Rear Front Rear SUB G
Краткое содержание страницы № 8
+ + + AX-5600 5-Channel Amplifier Controls and Features The 5-channel AX-5600 features a selectable 3-way electronic crossover with independent front and rear mid-high frequency adjustment, dual power supplies, 2 ohm per channel stability, and a Remote Bass Gain. WARNING: NEVER use ground-loop isolation on the input of your U.S.Amp! It doesn’t need it! 1 Rear Front Sub Sub Band Rear Gain XOver Pass HP Gain Gain L L Min 50 500 200 5K 50 500 Max 50 500 Max Rear LP Rear HP Front HP XOver XOver XO
Краткое содержание страницы № 9
+ + + + + + + AX-600DE/3200DE Class “DE” Amplifiers Controls and Features 1 2 3 4 5 Subsonic Slave PWR Prot L Class DE Digital Amplifier Min 50 500 XOver INPUT SUB U.S.A. Gain Freq RBG R + AX-600DE 1200 Watts Dynamic Power INPUT One Ohm Stable Design 600 Watts RMS Power (Shown here is AX-600DE, but the diagram is also applicable to AX-3200DE.) 1 Amplifier Input The amplifier MUST receive input on BOTH RCA jacks for proper operation. 2 Input Gain is variable from 150 mV to 3 volts for full out
Краткое содержание страницы № 10
+ + + + + + + + + + + + Wiring Instructions for AX-TU600C/1000/2000 Power Output + AX-TU600C 165W X 2 @ 4 Ω 300W X 2 @ 2 Ω – AX-1000 300W X 2 @ 4 Ω 500W X 2 @ 2 Ω AX-2000 + 600W X 2 @ 4 Ω 1000W X 2 @ 2 Ω LEFT LEFT RIGHT RIGHT [—] [+] [—] [+] + Source Unit + + Positive 12V Remote Turn-on Bridged Output AX-TU600C 600W X 1 @ 4 Ω Fuse Rating AX-1000 1000W X 1 @ 4 Ω AX-TU600C: 60A 12V REM GND POS AX-2000 AX-1000: 100A 2000W X 1 @ 4 Ω AX-2000: 200A + Negative 12V to Vehicle Ground F (Use minimum 8-gau
Краткое содержание страницы № 11
+ + + + + + + + + + + + Wiring Instructions for AX-TU4360C Source Unit WARNING: NEVER use ground-loop isolation on the input of your U.S.Amp! It doesn’t need it! Positive 12V Remote Turn-on Front Left Front Right Speaker Speaker 12V REM GND POS + + – Positive 12V + to Vehicle Battery FL FL FR FR (Use minimum [—] [+] [—] [+] Negative 12V 8-gauge Wire) to Vehicle Ground + Power Output (Use minimum RL RL RR RR 75W X 4 @ 4 Ω [—] [+] [—] [+] 8-gauge Wire) 90W X 4 @ 2 Ω + F 60A U S E – + Rear Left Rea
Краткое содержание страницы № 12
+ + + + + + + Wiring Instructions for AX-5600 Source Unit WARNING: NEVER use ground-loop isolation on the input of your U.S.Amp! It doesn’t need it! Front Left Positive 12V Remote Turn-on Speaker Front Right + Speaker 12V REM GND POS – + AX-600DE Positive 12V Power Output to Vehicle Battery 75W X 4 @ 4 Ω (Use minimum Negative 12V 90W X 4 @ 2 Ω 8-gauge Wire) to Vehicle Ground (Use minimum 8-gauge Wire) RL RR FL FR SUB F [—] [—] [—] [—] [—] U 75A + S RL RR FL FR SUB E [+] [+] [+] [+] [+] + + − Sub
Краткое содержание страницы № 13
+ + + Wiring Instructions for AX-600DE SPECIAL NOTE: Class “DE” amplifiers are single-ended mono designs, and are not bridgeable. BE SURE the TOTAL LOAD of ALL connected speakers does not fall beneath 1 Ω. Choose one of three possible connections shown below. 1 2 + – Source Unit Positive 12V Remote Turn-on Power Output AX-600DE 250W X 1 @ 4 Ω 400W X 1 @ 2 Ω LEFT LEFT RIGHT RIGHT [—] [+] [—] [+] 600W X 1 @ 1 Ω + 3 12V REM GND POS + Negative 12V to Vehicle Ground F (Use minimum 8-gauge Wire) U 50A
Краткое содержание страницы № 14
+ + + Wiring Instructions for AX-3200DE SPECIAL NOTE: Class “DE” amplifiers are single-ended mono designs, and are not bridgeable. BE SURE the TOTAL LOAD of ALL connected speakers does not fall beneath 1 Ω. WARNING: NEVER use ground-loop isolation on the input of your U.S.Amp! It doesn’t need it! Source Unit LEFT LEFT RIGHT RIGHT [—] [+] [—] [+] + Positive 12V Remote Turn-on AX-TU4360C Power Output 12V REM GND POS 1200W X 1 @ 4 Ω 2500W X 1 @ 2 Ω + 3000W X 1 @ 1 Ω Negative 12V to Vehicle Ground F
Краткое содержание страницы № 15
U.S.Amps Amplifier Power & Fuse Watts per Channel* MODEL 4 Ω 2 Ω 1 Ω FUSE 300W X 2 500W X 2 N/A 100A AX-1000 600W X 2 1000W X 2 N/A 200A AX-2000 AX-1000 75W X 4 90W X 4 AX-5600 500W X 1(Sub) 75A 250W X 1 400W X 1 600W X 1 50A AX-600DE 1200W X 1 2000W X 1 3000W X 1 300A AX-3200DE 165W X 2 300W X 2 N/A 60A AX-TU600C 75W X 4 90W X 4 N/A 60A AX-TU4360C 150W X 2 300W X 2 N/A 200A AX-2000HC Copyright 2007 U.S.Amps. All rights reserved. *Specifications are subject to change without notice 14
Краткое содержание страницы № 16
U.S.Amps Amplifier Specification Bridged THD S/N Damping Slew MODEL Output @ 4 Ω Ratio Factor** Rate AX-1000 1000W X 1 @ 4 Ω <0.025% >95 dB >600 150 Vus AX-TU600C AX-2000 2000W X 1 @ 4 Ω <0.025% >95 dB >1000 150 Vus AX-5600 N/A <0.025% >95 dB >200 150 Vus AX-600DE Mono <0.1% >86 dB >250 N/A Mono <0.1% >86 dB >250 N/A AX-3200DE 600W X 1 @ 4 Ω <0.05% >95 dB >600 150 Vus AX-TU600C 180W X 2 @ 4 Ω <0.05% >95 dB >200 150 Vus AX-TU4360C 600W X 1 @ 4 Ω <0.025% >95 dB >1000 150 Vus AX-2000HC 2000W X 1 @
Краткое содержание страницы № 17
Why Tubes? You may know that a transistor is a modern, efficient, less expensive version of a vacuum tube, which is the device that made sound recording and reproduction possible in the first place. Now, the electronics industry has been trying for many years to equal the sound quality available from tubes. They have been able to make transistor amps louder, cooler, more abusable, and less expen- sive than tubes, but to this day, they’ve been unable to make any solid state amp sound as go
Краткое содержание страницы № 18
VTCSD (continued) VTCSD “follows” the high voltage tube signal STRAIGHT INTO THE SPEAKERS, adding only current in a form of “amplifier power steering” — free from voltage gain or negative amplifier feedback! Vaccum tubes are renowned for their high dynamic range and smooth emphasis of even-order harmonics. The transformer-less VTCSD circuit brings out hidden qualities of the vacuum tubes, including excellent frequency response, smooth “clipping” and high signal-to-noise ratio. VTCSD divides
Краткое содержание страницы № 19
NOTE 18
Краткое содержание страницы № 20
NEVER, NEVER, NEVER! NEVER USE A U.S.AMP WITH A GROUND LOOP ISOLATOR ON THE RCA’S OR AN ISOLATED INPUT SIGNAL. U.S.Amps are input-isolated at the factory and require an input ground for proper operation. NEVER INSTALL OR MOUNT YOUR AMPLIFIER DIRECTLY TO A SPEAKER ENCLOSURE OR ANYWHERE ELSE WHERE SEVERE VIBRATION IS PRESENT. Protect your investment. Use Common sense. Make sure the spot you choose is well-ventilated and free from dirt and moisture. NEVER USE YOUR U.S.AMP BELOW THE RATED MINIMUM
