Краткое содержание страницы № 1
USER
MANUAL
MODEL 2174
CopperLINK™ High Speed
Ethernet Extender
This is a Class A device and is not intended for
use in a residential environment.
Part# 07M2174-UM SALES OFFICE
Rev. A
(301) 975-1000
Revised 9/23/11
TECHNICAL SUPPORT
(301) 975-1007
An ISO-9001Certified
Company
Краткое содержание страницы № 2
CONTENTS 1.0 Warranty Information ................................................................. 4 1.1 Regulatory Information ................................................................. 4 EMC Directive:.............................................................................. 4 Low-Voltage Direcive (Safety):..................................................... 4 PSTN:........................................................................................... 4 1.2 Radio and TV Interf
Краткое содержание страницы № 3
RJ-45.......................................................................................... 19 C.2 CopperLINK Interface ................................................................ 19 RJ-45.......................................................................................... 19 Terminal Block............................................................................ 19 D Line Rate & Reach Chart, Based on 24 AWG (0.5 MM) ......... 20 3
Краткое содержание страницы № 4
1.0 WARRANTY INFORMATION Patton Electronics warrants all Model 2174 components to be free from defects, and will—at our option—repair or replace the product should it fail within one year from the first date of the shipment. This warranty is limited to defects in workmanship or materials, and does not cover customer damage, abuse or unauthorized modification. If this product fails or does not performs as warranted, your sole recourse shall be repair or replacement as described above. Under
Краткое содержание страницы № 5
tion. The device has been tested and found to comply with the limits for a Class A computing device in accordance with specifications in Subpart B of Part 15 of FCC rules, which are designed to provide reasonable pro- tection from such interference in a commercial installation. However, there is no guarantee that interference will not occur in a particular instal- lation. If the device does cause interference to radio or television recep- tion, which can be determined by disconnecting the uni
Краткое содержание страницы № 6
1.6 SAFETY WHEN WORKING WITH ELECTRICITY • This device contains no user serviceable parts. This device can only be repaired by qualified service per- sonnel. • Do not open the device when the power cord is con- nected. For systems without a power switch and without an external power adapter, line voltages are present within the device when the power cord is connected. • For devices with an external power adapter, the power adapter shall be a listed Limited Power Source. The mains outlet
Краткое содержание страницы № 7
In accordance with the requirements of council direc- tive 2002/96/EC on Waste of Electrical and Electronic Equipment (WEEE), ensure that at end-of-life you sepa- rate this product from other waste and scrap and deliver to the WEEE collection system in your country for recy- cling. This device contains no user serviceable parts. This device can only be repaired by qualified service per- sonnel. WARNING This device is NOT intended nor approved for connec- tion to the PSTN. It is intended only
Краткое содержание страницы № 8
2.0 GENERAL INFORMATION Thank you for your purchase of this Patton Electronics product. This product has been thoroughly inspected and tested and is warranted for one year for parts and labor. If any questions or problems arise during installation or use of this product, contact Patton Electronics Technical Support at +1 (301) 975-1007. 2.1 FEATURES Variable rate CopperLINK extender - Easy to configure Auto-MDIX Ethernet Configurable 10/100, Full/Half, and Auto-Negotiating Ethernet
Краткое содержание страницы № 9
Figure 1. Typical application The pair of 2174 models work together to create a transparent extension between two peered Ethernet LANs using twisted pair (2-wire), Cat5+, or 75-ohm BNC. Figure 1 shows a typical point-to-point application. 3.0 INSTALLATION The Interconnecting cables shall be acceptable for external use and shall be rated for the proper applica- tion with respect to voltage, current, anticipated tem- CAUTION perature, flammability, and mechanical serviceability. To install the
Краткое содержание страницы № 10
Figure 2. Model 2174 rear panel options 10
Краткое содержание страницы № 11
3.1 CONNECTING THE LINE INTERFACE The Interconnecting cables shall be acceptable for external use and shall be rated for the proper applica- tion with respect to voltage, current, anticipated tem- CAUTION perature, flammability, and mechanical serviceability. The Model 2174 supports communication between two peer Ethernet LAN sites over a distance of up to 10,000 ft (3 km) over 24 AWG (0.5 mm) twisted-pair wire, Cat5+, or 75-ohm BNC. Note Actual distance and link performance may vary dependi
Краткое содержание страницы № 12
RING TIP Figure 4. Model 2174 (Terminal Block) twisted pair line interface Connecting the Line Interface for Model 2174/BNC To connect the line interface of the Model 2174/BNC, simply use a coax- ial cable with a BNC connector at each end to connect the pair of Model 2174s. 3.2 CONNECTING THE 10/100BASE-T ETHERNET INTERFACE The Interconnecting cables shall be acceptable for external use and shall be rated for the proper applica- tion with respect to voltage, current, anticipated tem- CAUTION
Краткое содержание страницы № 13
3.3 CONNECTING POWER The Interconnecting cables shall be acceptable for external use and shall be rated for the proper applica- tion with respect to voltage, current, anticipated tem- CAUTION perature, flammability, and mechanical serviceability. The Model 2174 does not have a power switch, so it powers up as soon as it is plugged in. An external AC or DC power supply is available separately. This connec- tion is made via the barrel jack on the rear panel of the Model 2174. No configuration
Краткое содержание страницы № 14
S1
!"#$ Figure 6. DIP switch orientation 4.2 CONFIGURING DIP SWITCH S1 DIP switch S1 is where you configure the CopperLINK line. The following tables describe the configuration for the 2174. Table 1: S1 Summary Position Description S1-1 Local/Remote Configuration S1-2 Line Rate/Symmetry S1-3 Line Rate/Symmetry S1-4 Reserved S1-5 SNR Margin S1-6 Reserved S1-7 Reserved S1-8 Reserved 14 ! " # $
Краткое содержание страницы № 15
Switch S1-1: Local/Remote Configuration Use switch S1-1 to configure the unit as Remote or Local in the Model 2174 pair. Table 2: Local/Remote Unit Configuration S1-1 Setting ON CPE/Remote OFF CO/Local Switches S1-2 and S1-3: Symmetric/Asymmetric Operation Use switches S1-2 and S1-3 to configure the CopperLink line rate type- and operation. Table 3: Symmetric/Asymmetric Selection Chart S1-2 S1-3 Setting OFF OFF High-Speed “Symmetric” OFF ON High-Speed “Asymmetric” ON OFF Long-Range “Symmetric”
Краткое содержание страницы № 16
5.0 OPERATION Once the Model 2174s are properly installed, they should operate trans- parently. No user settings required. This section describes reading the LED status monitors. Before applying power to the Model 2174, please review section 3.3, “Connecting Power” on page 13 to verify that the unit is connected to the appropriate power source. 5.1 FRONT PANEL LED STATUS MONITORS The Model 2174 features six front panel LEDs that monitor power, the Ethernet signals, the CopperLINK connectio
Краткое содержание страницы № 17
APPENDIX A SPECIFICATIONS A.1 LAN CONNECTION Four RJ-45, 10/100Base-T, IEEE 802.3 Ethernet CopperLINK Connection: RJ-45 A.2 TRANSMISSION LINE Two-wire unconditioned twisted pair or 75-ohm BNC A.3 COPPERLINK LINE RATE AND COPPERLINK DISTANCE Line Rate: Up to 200 Mbps asymmetrical Distance: Up to 9,842 ft (3 km) Note Distances depend on line rate and line conditions. A.4 LED STATUS INDICATORS Power (Green) CopperLINK: Link (Green) Local (Green) Remote (Green) Ethernet: Li
Краткое содержание страницы № 18
APPENDIX B MODEL 2174 SERIES FACTORY REPLACEMENT PARTS AND ACCESSORIES Patton Model # Description Base Models 2174/EUI-2PK High Speed CopperLink Ethernet Extender Kit (Local and Remote); RJ45 Line, 100-240VAC 2174/TB/EUI-2PK High Speed CopperLink Ethernet Extender Kit (Local and Remote); Terminal Block Line, 100-240VAC 2174/BNC/EUI-2PK High Speed CopperLink Ethernet Extender Kit (Local and Remote); BNC Line, 100-240VAC 07M2174-UM User Manual Power Supplies PS-03671H1-002 100-240VAC (12V, DC
Краткое содержание страницы № 19
APPENDIX C MODEL 2174 SERIES INTERFACE PIN ASSIGNMENT C.1 10/100BASE-T INTERFACE RJ-45 Pin 1: TX+ Pin 2: TX- Pin 3: RX+ Pin 6: RX- Pins 4, 5, 7, 8: no connection C.2 COPPERLINK INTERFACE RJ-45 Pin 4: RING Pin 5: TIP Pins 1, 2, 3, 6, 7, 8: no connection Terminal Block RING TIP Figure 1. Model 2174 (Terminal Block) twisted pair line interface 19
Краткое содержание страницы № 20
APPENDIX D LINE RATE & REACH CHART, BASED ON 24 AWG (0.5 MM) Table 6: Line Rate & Reach Chart Using Twisted-Pair (Long Range) Distance in Feet Mbps Mode (Long Range) ft m/km DS US 250 ft 76 m 68 40 1000 ft 305 m 62 44 2,000 ft 610 m 50 16 Symmetric 3,000 ft 914 m 33 4 5,000 ft 1.5 km 16 2 10,000 ft 3 km 2.5 1 250 ft 76 m 67 16 1000 ft 305 m 59 16 2,000 ft 610 m 45 11 Asymmetric 3,000 ft 914 m 31 5 5,000 ft 1.5 km 17 682 kbps 10,000 ft 3 km 4 263 kbps Note The actual distance and link performance
