Руководство по эксплуатации Home Automation 37A00-1

Краткое содержание страницы № 1

HAI UPB™ 15A Relay Switch and Auxiliary Switch
Installation and Operating Instructions

For the following Models:

40A00-1 HAI 15A Relay Switch (referred to as HAI UPB™ Wall Switch, in this document), and
37A00-1 HAI Auxiliary Switch

READ THESE INSTRUCTIONS BEFORE INSTALLING DEVICE

This HAI UPB™ Wall Switch and Auxiliary Switch is intended for installation in accordance with the National Electrical Code and
local codes and regulations. It is recommended that a qualifi

Краткое содержание страницы № 2

HAI Auxiliary Switch Overview The 37A00-1 HAI Auxiliary Switch (Figure 2) is an optional companion device used with the HAI UPB™ Wall Switch for multi-way circuits. The HAI Auxiliary Switch has a Decora-style rocker switch that controls the load in the exact same manner as the Decora- style rocker switch on the HAI UPB™ Wall Switch. LED INDICATOR BLACK TOP LINE (ON) GRAY *NEUTRAL (FOR RED INDICATOR) BLUE *NEUTRAL (FOR BLUE INDICATOR) YELLOW CONTROL BOTTOM (OFF)

Краткое содержание страницы № 3

Installation Procedure 1. Be sure that all power to the load has been disconnected by turning off the circuit breaker. 2. If applicable, remove the faceplate from the existing wall switch, remove the existing wall switch from the wall box, and disconnect the wires from the existing wall switch. Identify the “Line”, "Neutral", "Load" and “Traveler” (if applicable) wires. 3. Remove ¾” of insulation from each of the wires on the HAI UPB™ Wall Switch. Install the HAI UPB™ Wall Switch by

Краткое содержание страницы № 4

HAI 15A RELAY SWITCH OPERATION The HAI 15A Relay Switch has configurable items that can be set using the UPB™ UPStart configuration software. The following describes the operation of the HAI 15A Relay Switch in its factory default configuration. Local Rocker Switch Operation The HAI 15A Relay Switch has a Decora-style rocker switch that can be used to control the load as follows. Rocker Event Top Rocker Bottom Rocker Single-Tap Load turns on. Load turns off. Table 1 - HAI UPB™

Краткое содержание страницы № 5

SPECIFICATIONS Model Number 40A00-1 Incandescent Loads, Inductive Loads, and Florescent Loads Yes Motor-Operated Appliances Yes Current Maximum 15A Connections 18 GA LED Indicator Yes Dimensions 4.1 x 1.75 x 1.45 Weight 0.25 lb. Mounting Standard J Box Input Power 120 ± 12 VAC Input Frequency 60 ± 3 Hz Operating Temperature -40 °F to 104 °F Note: It is normal for this switch to make a slight buzzing sound during operation. It is also normal for the switch and wall plate to fe