Краткое содержание страницы № 1
ZXi200.2
ZXi40.4 / ZXi80.4 / ZXi150.4
ZXi60.4+1K
Краткое содержание страницы № 2
ZEUS HIGH PERFORMANCE AMPLIFIERS The Zeus ZXi Series products have been designed to a very high level of performance, with features unavailable in any other product. All of the amplifiers have variable crossovers built in, with added touches such as subsonic filter, bass equalization and a remote Level control module(some models) that allows subwoofer Level control from the drivers seat. To ensure years of listening pleasure, all amplifiers have a built in diagnostic mode that will detect sho
Краткое содержание страницы № 3
WIRE GAUGE GENERAL INSTALLATION PROCEDURE System Design The success of any car stereo system relies on several factors, such as the system design, execution of the installation, and system setup. Please remember that any system is only as good as its weakest link. Please remember that higher power systems are not necessarily useful purely for high sound pressure levels, but also to establish a headroom capability, to reproduce musical peaks cleanly without distortion. Lower power amplifiers w
Краткое содержание страницы № 4
AMPLIFIER FEATURE DESCRIPTIONS ZEUS ZXi AMPLIFIERS: ! Each model is capable of 4 & 2-Ohms stereo per channel, or 4-Ohms mono bridged operation ! CAUTION: DO NOT OPERATE ANY AMPLIFIER BELOW THE INTENDED IMPEDANCE. YOU except the 5 channel which is capable of 1-Ohm on channel 5. WILL CAUSE DAMAGE TO THE AMPLIFIER THAT WILL NOT BE COVERED UNDER THE ! The input sensitivities for rated output powers are variable from 0.2 volts to 6 volts. WARRANTY PRINTED IN THE BACK OF THE MANUAL. 2 & 4 Channel am
Краткое содержание страницы № 5
LINE OUT LINE INPUT LINE OUT LINE INPUT HI PASS X-OVER LOW PASS BASS EQ LEVEL POWER HI PASS X-OVER LOW PASS BASS EQ LEVEL POWER L L L L 0dB 10dB 10Hz 15KHz 30Hz 150Hz 0dB 10dB 6V 0.2V PROTECT REMOTE 10Hz 15KHz 30Hz 150Hz 6V 0.2V PROTECT REMOTE HP FULL LP/BP HP FULL LP/BP R R R R ZXi200.2 2-CHANNEL AMPLIFIER APPLICATIONS FULL RANGE STEREO This is the most basic application for the HFi Series 2 channel amplifiers. 4. Line Level: Refer to the section “Setting up systems after insta
Краткое содержание страницы № 6
1/2 CH LINE INPUT REMOTE HI PASS LOW PASS BASS EQ LEVEL POWER LINE OUT 1/2 CH LINE INPUT REMOTE HI PASS LOW PASS BASS EQ LEVEL POWER LINE OUT CH1/2 CH3/4 X-OVER CH1/2 CH3/4 X-OVER R R R R R R 10Hz-15KHz 30Hz-150Hz 0dB-10dB 6V 0.2V PROTECT HI FULL LP/BP 10Hz-15KHz 30Hz-150Hz 0dB-10dB 6V 0.2V PROTECT HI FULL LP/BP 3/4 CH HI PASS LOW PASS BASS EQ LEVEL 3/4 CH X-OVER HI PASS LOW PASS BASS EQ LEVEL X-OVER L L L L L L CH2-CH4 CH2-CH4 10Hz-15KHz HI FULL LP/BP 30Hz-150Hz 0dB-10dB 6V 0.2V MODE 1
Краткое содержание страницы № 7
1/2 CH LINE INPUT REMOTE HI PASS LOW PASS BASS EQ LEVEL POWER LINE OUT CH1/2 CH3/4 X-OVER R R R 10Hz-15KHz 30Hz-150Hz 0dB-10dB 6V 0.2V PROTECT HI FULL LP/BP 3/4 CH HI PASS LOW PASS BASS EQ LEVEL X-OVER L L L CH2-CH4 LINE INPUT LINE OUT 10Hz-15KHz HI FULL LP/BP 30Hz-150Hz 0dB-10dB 6V 0.2V MODE HI PASS X-OVER LOW PASS BASS EQ LEVEL POWER L L REMOTE 10Hz 15KHz 30Hz 150Hz 0dB 10dB 6V 0.2V PROTECT HP FULL LP/BP R R ZXi40.4 / ZXi80.4 / ZXi150.4 4-CHANNEL AMPLIFIER APPLICATIONS Front/Rear
Краткое содержание страницы № 8
CH3/4 CH3/4 LINE INPUT CH1/2 LINE INPUT CH1/2 HI PASS X-OVER LOW PASS LEVEL HI PASS LEVEL HI PASS X-OVER LOW PASS LEVEL LEVEL HI PASS X-OVER X-OVER HI FULL BP HI FULL BP HI FULL HI FULL CH3 CH3 CH1 CH1 10Hz 15Khz 6V 0.2V 10Hz 15Khz 30Hz 150Hz 6V 0.2V 10Hz 15Khz 6V 0.2V 10Hz 15Khz 30Hz 150Hz 6V 0.2V 5CH 5CH POWER POWER CH4 30Hz 150Hz 0dB-10dB 6V 0.2V CH2 CH4 30Hz 150Hz 0dB-10dB 6V 0.2V Ch2 Ch4 Ch5 CH2 Ch2 Ch4 Ch5 REMOTE REMOTE LOW PASS BASS EQ LEVEL LOW PASS BASS EQ
Краткое содержание страницы № 9
7
Краткое содержание страницы № 10
SETTING UP SYSTEMS AFTER INSTALLATION FOR BEST PERFORMANCE ZXi200.2 / ZXi40.4 / ZXi80.4 / ZXi150.4 / ZXi60.4+1K General: At this point you are ready to get more specific on the settings for your amplifier. High Pass: -When in Hi Pass operation, this setting acts as a low frequency cut off for your system reproduction. The point that you set it at cuts off any frequencies from reproduction beyond this point. The 12 o’clock position is a great starting point. EXAMPLE: If you adjust the High Pass
Краткое содержание страницы № 11
TROUBLESHOOTING A SYSTEM The key to finding the problem in a misbehaving sound system is to isolate parts of that system in a logical fashion to track down the fault. Description of the PROTECT system built into all Hifonics amplifiers The diagnostic system will shut down the amplifier, until reset by turning the head unit off, and back on. This state of affairs will be indicated by the front panel PROTECT LED lighting up under the following conditions: 1 - A sort circuit on the loudspeaker lea
Краткое содержание страницы № 12
Maxxsonics Limited Warranty As the manufacturer of Maxxsonics, MB Quart, Autotek, Crunch and Hifonics car audio products, Maxxsonics USA Inc. Warrants to the original consumer purchaser the amplifier to be free from defects in material and workmanship for one (1) Year from date of purchase. All other parts and accessories of the system are warrantied to be free from defects in material and workmanship for one (1) year from date of purchase. Maxxsonics will repair or replace at it’s option and f
Краткое содержание страницы № 13
OEM Integration Accessories MX-1 Premium High To Low Level Converter MX-3 Bass Controller * Converts High Level OEM speaker wires to Ultra Clean RCA Low Level Outputs * High Level Inputs: Accepts all types of High level Inputs * Parametric Bass EQ: Provides a wide array of subwoofer output signal including floating ground and high voltages up to 30 volts. shaping controls to enhance bass response and sound quality including * Audio Signal Sense / Hardwire Turn-On: Audio sense detec
Краткое содержание страницы № 14
PART#: A1209
