Краткое содержание страницы № 1
AVR 5000 Audio/VideoReceiver
OWNER’S MANUAL
O O
DTS MUTE RDS PTY CT RT TA AUTO TUNED ST MEMORY PRESET
SLEEP L 0 C 0 R
DOLBY D
O O
PCM
O O
MP3
LS LFE RS
OPTICAL 1 2 3 COAXIAL 1 2 3 ANALOG VMAx NF 5.1 LOGIC 7 CM OSD O O
NIGHT MULTI
DIGITAL PRO LOGIC 3- STEREO 5 CH STEREO HALL 12 THEATER
®
™
Power for the Digital Revolution
Краткое содержание страницы № 2
Table of Contents 3 Introduction 4 Safety Information 5 Front Panel Controls 7 Front Panel Information Display 9 Rear Panel Connections 11 Main Remote Control Functions 14 Zone II Remote Control Functions Declaration of Conformity 15 Installation and Connections 19 System Configuration 19 Speaker Selection and Placement 20 First Turn On and Use of OSD 20 Settings to be Made With Each Input Used We, Harman Consumer International 21 Input Setup 21 Surround Setup 2, route de Tours 22 Speaker Setup
Краткое содержание страницы № 3
Introduction Thank you for choosing Harman Kardon! Finally, the AVR5000 is among the very few A/V The AVR5000’s flexibility and power extend With the purchase of a Harman Kardon receivers that offer decoding of MP3 data, so beyond your main home theater or listening AVR5000 you are about to begin many years of that you may listen to the latest music selections room. The AVR includes a sophisticated multi- listening enjoyment. The AVR5000 has been cus- directly from compatible computers or playba
Краткое содержание страницы № 4
Safety Information Installation Location Important Safety Information Unpacking To assure proper operation and to avoid the Verify Line Voltage Before Use The carton and shipping materials used to potential for safety hazards, place the unit on Your AVR5000 has been designed for use with protect your new receiver during shipment were a firm and level surface. When placing the 220-240-Volt AC current. Connection to a line specially designed to cushion it from shock and unit on a shelf, be certa
Краткое содержание страницы № 5
Front Panel Controls ˆıÙ Û Û Û Ú Ú ÚÒ Ò Ò Ô Ô Ô 30 29 MUTE RDS PTY CT RT TA AUTO TUNED ST MEMORY PRESET O O DTS L 0 C 0 R SLEEP DOLBY D O O PCM O O MP3 LS LFE RS Ó OPTICAL 1 2 3 COAXIAL 1 2 3 ANALOG VMAx NF 5.1 LOGIC 7 CM OSD O O DIGITAL PRO LOGIC 3- STEREO 5 CH STEREO HALL 12 THEATER NIGHT MULTI ( * 1 1 1 & & & 2 2 2 4 4 4 3 3 3 5 5 5 6 6 6 7 7 7 8 8 8 9 9 9 ) ) ) ! ! ! @ @ @ $ ^ ^ ^ # # # % % % Main Power Switch Input Source Selector Set Button 1 ! Ô System Power Control RDS Select Button
Краткое содержание страницы № 6
Front Panel Controls 7 Surround Mode Selector: Press this but- $ Input/Output Status Indicators: These Input indicators: A green LED will light in ton to change the surround mode by scrolling LED indicators will normally light green to show front of the input that is currently being used as through the list of available modes. Note that that the front panel Video 4 A/V jacks or the the source for the AVR5000. Dolby Digital and DTS modes can be selected Coaxial 3 digital jack is operating as an
Краткое содержание страницы № 7
Front Panel Information Display Z AE ADYAC AB AA X W V UTSRQ O O AUTO TUNED ST MEMORY PRESET DTS MUTE RDS PTY CT RT TA L 0 C 0 R SLEEP DOLBY D O O A PCM O O MP3 LFE LS RS OPTICAL 1 2 3 COAXIAL 1 2 3 ANALOG OSD O O VMAx NF 5.1 LOGIC 7 CM B NIGHT MULTI DIGITAL PRO LOGIC 3- STEREO 5 CH STEREO HALL 12 THEATER C D E F G H I J KL M N O P A L W Bitstream Indicators Hall Mode Indicator Tuned Indicator B M X Optical Source Indicators OSD Indicator Auto Indicator C N Y DTS Mode Indicator Theater Mode In
Краткое содержание страницы № 8
Front Panel Information Display S Preset Indicator: This indicator lights when AA TA Traffic Announcement Indicator: the tuner is in use to show that the Preset This indicator illuminates if the RDS station Number/Sleep TimerR is showing the sta- tuned somtimes transmits traffic information tion’s preset memory number. (See page 33 for (see page 34 for more information on RDS). more information on tuner presets.) AB RT Text Indicator: This indicator illumi- T Sleep Indicator: This indicator ligh
Краткое содержание страницы № 9
Rear Panel Connections " $ b
! # ® HDCD , High Definitioni Compatible Digital and Pacific Microsonics™ are either registered trademarks or trademarks of Pacific Microsonics, Inc. In the United States and/or other countries. HDCD system manufactured under license from Pacific Microsonics, Inc. This product is covered by one or more of the following: in the USA: 230V/50 Hz 5,479,168, 5,638,074, 5,640,161, 5,808,574, 5,838,274, 5,854,600, 5,864,311,
Краткое содержание страницы № 10
Rear Panel Connections Video Monitor Outputs: Connect these Remote IR Input: If the AVR5000’s front- " Video 2 Audio Inputs: Connect these jacks jacks to the composite and/or S-Video input of a panel IR sensor is blocked due to cabinet doors to the PLAY/OUT audio jacks on a VCR or other TV monitor or video projector to view the on- or other obstructions, an external IR sensor video source. screen menus and the output of any video source may be used. Connect the output of the sensor ! Video 2
Краткое содержание страницы № 11
D I G R U I N K T E P A M S L Main Remote Control Functions 0 Power On Button c b a 1 IR Transmitter Window 2 Program/SPL Indicator 3 Power Off Button 39 4 Input Selectors 5 AVR Selector POWER 6 AM/FM Tuner Select TM d ON OFF 38 7 Learn Button e 8 Test Button 9 Sleep Button AVR DVD CD TAPE f A Surround Mode Selector VCR TV CBL/SAT VID 1 VID 2 VID 3 VID 4 B Night Mode g 37 C Channel Select Button LEARN AM/FM 6 CH. SPL h ⁄ ¤ 36 D / Buttons ‹ E Button i 35 F Set Button j TEST SLEEP G Digital Select
Краткое содержание страницы № 12
Main Remote Control Functions IMPORTANT NOTE: The AVR5000’s remote may 5 AVR Selector: Pressing this button will C Channel Select Button: This button is be programmed to control up to seven devices, switch the remote so that it will operate the AVR’s used to start the process of setting the including the AVR5000. Before using the remote, functions. If the AVR is in the Standby mode, it will AVR5000’s output levels with an external it is important to remember to press the Input also turn the AVR
Краткое содержание страницы № 13
Main Remote Control Functions J Direct Button: Press this button when the Q Preset Up/Down: When the tuner is in $Volume Up/Down: Press these buttons to tuner is in use to start the sequence for direct use, press these buttons to scroll through the raise or lower the system volume. entry of a station’s frequency. After pressing the stations programmed into the AVR5000’s memo- % TV/Video Button: This button does not button simply press the proper Numeric Keys ry. When CD or DVD is selected using
Краткое содержание страницы № 14
Zone II Remote Control Functions The Zone II remote may be used in either the ƒ Record/Pause: Press this button to acti- same room where the AVR5000 is located, or it vate the Record or Pause function on compatible POWER MUTE may be used in a separate room with an option- Harman Kardon CD, DVD or Cassette Deck prod- A K OFF al infrared sensor that is connected to the ucts. AVR VID 1 VID 2 AVR5000’s Multi IR input jack %. © Preset Up/Down – Track Skip: When the B AM/ /FM VID 3 VID 4 AVR’s tuner
Краткое содержание страницы № 15
Installation and Connections After unpacking the unit, and placing it on a solid 7. Connect the front, center and surround speak- nected to one or more subwoofer speakers. If surface capable of supporting its weight, you will er outputs to the respective speakers. you are using a powered subwoofer that does need to make the connections to your audio and not have line-level input connections, follow the To assure that all the audio signals are carried to video equipment. instructions furnished
Краткое содержание страницы № 16
Installation and Connections 8. If the component video inputs are used, con- Important Note for Adapter Cables: SCART A/V Connections nect the Component Video Output to the If the cinch connectors of the adapter you’ll use For the connections described above your video component video inputs of your TV, projector or are labeled, connect the Audio and Video ”In” device needs RCA (cinch) connectors or/and S- display device. plugs with the corresponding Audio and Video Video connectors for all Aud
Краткое содержание страницы № 17
Installation and Connections Important Note for the Use of Blac Blackk SCART-Cinch Adapters: Figure 1: Yellow Yellow When video sources are connected to the TV SCART/Cinch-Adapter for Red Red directly with a SCART cable, specific control sig- playback; signal flow: nals apart from Audio/Video signals will be fed SCART Cinch to the TV. These specific signals are: With all video sources, the signal for automatic input Black Black selection that switches the TV automatically to Red Red the appro
Краткое содержание страницы № 18
Installation and Connections Multiroom Audio Connections When an external amplifier is used, connect the System and Power Connections Depending on the distance from the AVR5000 Preamp Out jacks to the inputs on the The AVR5000 is designed for flexible use with to the remote room, two options (A and B) are amplifier. When an equalizer or speaker proces- multiroom systems, external control components available for audio connection: sor is used, connect the Preamp Out jacks and power amplifiers
Краткое содержание страницы № 19
System Configuration When all audio, video and system connections Depending on the specifics of your room Center Front Speaker have been made, there are a few configuration acoustics and the type of speakers in use, you adjustments that must be made. A few minutes may find that imaging is improved by moving the No more than 60cm spent to correctly configure and calibrate the front-left and front-right speakers slightly unit will greatly add to your listening experience. forward of the
Краткое содержание страницы № 20
System Configuration projectors, constant display of a static image such First Turn On and Use of the OSD Settings to be Made With Each as these menus or video game images may cause Input Used Once the speakers have been placed in the the image to be permanently “burned into” the room and connected, the remaining steps are to The AVR5000 features an advanced memory sys- CRT. This type of damage is not covered by the program the system configuration memories. tem that enables you to establish dif
