Краткое содержание страницы № 1
User’s Manual
HDMI 201 Tx/Rx
Digital Video Transmitter and Receiver
Extron USA - West Extron USA - East Extron Europe Extron Asia Extron Japan Extron China Extron Middle East
Headquarters
+800.633.9876 +800.3987.6673 +800.7339.8766 +81.3.3511.7655 +400.883.1568 +971.4.2991800 68-1375-01 Rev. C
+800.633.9876 Inside USA / Canada Only Inside Europe Only Inside Asia Only +81.3.3511.7656 FAX Inside China Only +971.4.2991880 FAX
Inside USA / Canada Only 01 09
+1.919.863.1794 +31.33.453.4040 +65.6383.
Краткое содержание страницы № 2
Precautions Safety Instructions • English Warning Power sources • This equipment should be operated only from the power source This symbol is intended to alert the user of important indicated on the product. This equipment is intended to be used with a main power operating and maintenance (servicing) instructions in system with a grounded (neutral) conductor. The third (grounding) pin is a safety the literature provided with the equipment. feature, do not attempt to bypass or disable it.
Краткое содержание страницы № 3
警告 安全须知 • 中文 电源 • 该设备只能使用产品上标明的电源。 设备 这个符号提示用户该设备用户手册中 必须使用有地线的供电系统供电。 第三条线 有重要的操作和维护说明。 （地线）是安全设施，不能不用或跳过。 拔掉电源 • 为安全地从设备拔掉电源，请拔掉所有设备后 这个符号警告用户该设备机壳内有暴 或桌面电源的电源线，或任何接到市电系统的电源线。 电源线保护 • 妥善布线， 避免被踩踏，或重物挤压。 露的危险电压，有触电危险。 维护 • 所有维修必须由认证的维修人员进行。 设备内部没 注意 有用户可以更换的零件。为避免出现触电危险不要自己 阅读说明书 • 用户使用该设备前必须阅读并理 试图打开设备盖子维修该设备。 解所有安全和使用说明。 通风孔 • 有些设备机壳上有通风槽或孔，它们是用来防止 保存说明书 • 用户应保存安全说明书以备将来使 机内敏感元件过热。 不要用任何东西挡住通风孔。 用。 锂电池 • 不正确的更换电池会有爆炸的危险。 必须使用与 遵守警告 • 用户应遵守产品和用户指南上的所有安 厂家推荐的相同或相近型号的电池。 按照生产厂的建 全和操作说明。 议处理废弃电
Краткое содержание страницы № 4
Table of Contents Chapter One • Introduction .................................................... 1-1 About this Manual .................................................................... 1-2 About the HDMI 201 Tx/Rx .................................................... 1-2 TP cable advantages .............................................................. 1-4 Control communications ....................................................... 1-4 Transmission distance ..............................
Краткое содержание страницы № 5
Table of Contents, cont’d Appendix A • Reference Information ..............................A-1 HDMI 201 Tx/Rx Specifications ..............................................................................A-2 Part Numbers ..............................................................................A-6 Transmitter/receiver pair part numbers ...............................A-6 Included parts.........................................................................A-6 Mounting accessories ............
Краткое содержание страницы № 6
Introduction There are two subsets of transmitters and receivers in two About this Manual different enclosures or form factors: This manual contains information about the Extron family of ™ • HDMI 201 Tx/Rx — These units are housed in quarter High Definition Multimedia Interface (HDMI ) extenders, the rack width metal enclosures. They can be set on a HDMI 201 Tx/Rx transmitter and receiver pair, including how tabletop or mounted in a rack, under or through furniture, to install, ope
Краткое содержание страницы № 7
Introduction, cont’d In this manual, the terms "HDMI 201," N Features "HDMI 201 Tx," "HDMI 201 Rx," "transmitter," and T ransmits single link HDMI signals over two CA T 5/5e/6 "receiver" refer to the applicable unit(s) in either form cables — Standard twisted pair cables provide an factor, unless otherwise specified. economical, easily installed cable solution. Long distance transmission — TP cable advantages CA T 5/5e/6/7 UTP cable — Accommodates 720p and Twisted pair cable is much sm
Краткое содержание страницы № 8
Introduction, cont’d HDMI 201 Tx/Rx Chapter Two 2 Installation and Operation Mounting the Tx/Rx Connections Operation Technical Points for Digital Video and Content Protection Encryption Troubleshooting Application Examples 1-6 HDMI 201 Tx/Rx • Introduction
Краткое содержание страницы № 9
Installation and Operation Mounting the Tx/Rx Installation and service must be performed by C VersaTools Rack Shelf authorized personnel only . Non-Decora unit mounting The 1" high, quarter rack width HDMI 201 (non-Decora) transmitters and receivers can be placed on a tabletop, mounted on a rack shelf, or mounted under a desk or tabletop. The receiver can be mounted on a projector bracket. Tabletop placement 1/4 Rack Width Front False Faceplate Affix the four included rubber feet to
Краткое содержание страницы № 10
Installation and Operation, cont’d 1U Universal Rack Shelf 1/2 Rack Width Front False Faceplate 1/4 Rack Width Front False Faceplate Both front false faceplates use 2 screws. (2) 4-40 x 3/16" Screws Use 2 mounting holes on opposite corners. Figure 2-3 — Under-desk mounting Figure 2-2 — Mounting the transmitter or receiver Through-furniture mounting unit on a standard rack shelf The transmitter or receiver can be mounted through a desk or other furniture using an optional Extron MBD 12
Краткое содержание страницы № 11
Installation and Operation, cont’d Side Mounting 1. Loosely attach the mounting brackets to the transmitter Plate or receiver using the four machine screws and washers Bracket supplied with the mounting kit. Brace 2. Hold the transmitter or receiver against the inside of the U-Bolt surface through which it will be mounted. Mark the four Extron screw holes and the table material to be removed on the DVI 201 or HDMI 201 inside of the surface to which you are mounting the device. Receiver 3
Краткое содержание страницы № 12
Installation and Operation, cont’d PMK 350 mounting The PMK 300 has a hole in the bottom plate that N allows the projector pole to be inserted through the Mount the receiver to a PMK 350 bracket as follows: center of the plate (figure 2-6), rather than outside of 1. Remove the front and rear plates from the PMK 350 the plate (figure 2-5). To install the PMK 300 in this (figure 2-7), using an Extron Tweeker or a #2 Philips configuration, slide the bracket up from the bottom of the screw
Краткое содержание страницы № 13
Installation and Operation, cont’d 6. Assemble the U-bolt and the following parts in the Decora unit mounting following order (figure 2-8): The HDMI 201 A D (Decora) transmitter and receiver can be a. Pass the legs of the U-bolt through the slotted holes on installed in a one-gang electrical wall box with a Decora wall the mount plate flange. plate cover (supplied). b. Place the legs around the projector pole. The installation must conform to national and local electrical codes and to the
Краткое содержание страницы № 14
Installation and Operation, cont’d Wall Stud Wall Stud 2.50” [63.5mm] Signal Signal Output Output Cable Cable Cable Cable Clamp Clamp TP Cable 1.51” [38.48mm] (no boot) Screws Screws or Nails or Nails Captive Screw Connectors Figure 2-10 — Installing the wall box TP Cable If attaching the wall box to wood, use four #8 or #10 (no boot) N scr ews or 10-penny nails. A minimum of 0.5" (1.3 cm) of screw thread must penetrate the wood. Junction Box If attaching the wall box to metal st
Краткое содержание страницы № 15
Installation and Operation, cont’d Final installation Connections After testing and making any adjustments, do the following: Transmitter connections 1. At the power outlet, unplug the power supply. The wall-mountable transmitter is in an enclosure that can be One power supply can power both the transmitter and N mounted in UL standard wall boxes with Decora-style face the r eceiver , so only one unit needs a power supply . plates. The rack-mountable transmitter is in a quarter rack widt
Краткое содержание страницы № 16
Installation and Operation, cont’d HDMI 201 Tx Rear Panel Input Audio — Plug an unbalanced stereo audio input into this c HDMI 201 Tx POWER pair, left and right, of female RCA connectors (figure 2-14). 12V HDMI INPUT RS-232 0.4A MAX PASS THRU Tip (Signal) 1 2 Tx Rx Tip (+) Right Channel (Red Jacket) Sleeve (Gnd ) 4 1 5 2 HDMI 201 A D Tx Rear Panel Left Channel Sleeve ( ) (White Jacket) Figure 2-14 — RCA connector wiring DC power input connector — Plug the included external d HDMI
Краткое содержание страницы № 17
Installation and Operation, cont’d Receiver connections Audio Output connector (HDMI 201 A D Tx [Decora] only) — f The rack-mountable receiver is in quarter rack width enclosure. Connect one end of a 5-wire audio cable to this 3.5 mm, 5-pole direct insertion connector. The wall-mountable receiver is in an enclosure that can be mounted in UL standard wall boxes with Decora-style face Connect the free end of the same cable from the transmitter to plates. any compatibly wired unit, such
Краткое содержание страницы № 18
Installation and Operation, cont’d HDMI 201 A D Rx Front Panel If necessary , test for pr oper cable connection (output 1 to N input 1, output 2 to input 2) as follows: 1. Plug both TP cables into the powered unit. 2. Momentarily connect either of the cables on the opposite end into the unpowered unit‘s “2” connector. OUTPUT If the unpowered unit’s Power LED is lit, the connection is correct. HDMI If the unpowered unit’s Power LED is not lit, 9 unplug the connector on the unpow
Краткое содержание страницы № 19
Installation and Operation, cont’d Side Pins: RJ-45 Output Audio — Plug an audio device into this pair, left and 12345678 l Connector right, of female RCA connectors (figure 2-14) for an unbalanced TIA/EIA T TIA/EIA T stereo audio signal. Signal 586 A 586 B Pin Wire color Wire color RJ-45 #1 RJ-45 #2 Pin assignments and wiring 1 White-green White-orange Data 0+ CEC 2 Green Orange Data 0– HPD HDMI connector pin assignments RS-232 3 White-orange White-green ID Clock+ Figure 2-19 defines the pin
Краткое содержание страницы № 20
Installation and Operation, cont’d Terminating shielded cable The transmitter and receiver pair works with unshielded N twisted pair (UTP) or shielded twisted pair (STP) cables; Crimped Connector but, to ensure FCC Class A and CE compliance, STP cables are required. Figure 2-23 — Crimped RJ-45 connector The Tx/Rx includes four shielded RJ-45 connectors and a length of self-adhesive shielded tape that you can use to make the STP Power supply wiring cables that connect the transmitter and
