Руководство по эксплуатации Shure HTSSOSPA

Краткое содержание страницы № 1

HTSSOSPA
Power Amplifier

Краткое содержание страницы № 2

HTSSOSPA SIGNAL PROCESSING STEREO POWER AMPLIFIER INTRODUCTION HTSSOSPA is tailored to correspond to the parti- respectively with the HTSSOLRS and HTSSOCF Congratulations! You have chosen the Shure cular Shure HTS loudspeaker system selected in Loudspeakers when the HTS system does not HTSSOSPA Signal Processing Stereo Power each of its HTSspeaker-correlated switch- include a subwoofer. In these two Modes, Amplitier, specially made as an integral part of selectable Operational Modes. Through

Краткое содержание страницы № 3

tion of the HTS5OSPA with highest quality components used throughout. The power amplifier circuit of each channel uses a hybrid audio power module construction. This compact assembly techque combines semiconductor chips, normally used in amplifiers as separate dwrete devices, into a tightly coupled unit on a multilayer high-thermal-conductivity substrate. The high thermal conductivity of the base substrate results in a close thermal match of the amplifier output circuits to the voltage

Краткое содержание страницы № 4

emphasis in either alternate level setting can provide exceptional excitement and even greater enjoy- ment in home theater sound. These slotted control knobs are intended to require insertion of a coin to change their settings; they resist accidental changes of position. @ OPERATIONAL MODE: The Operational Mode switches select the signal process- ing characteristics of each amplifier channel independently to complement the response characteristics and excur- sion limits of the HTS L

Краткое содержание страницы № 5

binding posts that will accept any of the following methods of connection: bare wire wrapped around the post, bare wire inserted through the hole in the post, spade lug around the post, pin connector through the hole in the post, or banana plug inserted in the jack These output connectors will accommodate most high- performance audio cables. (Gold ,080- inch diameter pins soldered to the loud- speaker cables and inserted under the binding post hex caps [fastened finger- tight] are th

Краткое содержание страницы № 6

BRIDGED CONNECTION If the amplifier is used in the Bridged MtKie, to prevent the risk of electric shock the following instructions describe the only acceptable method of connection (see illustration). Voltages in the Bridged Connection ate hazardous to life. Make all amplifier-to- speaker connections with AC power discon- nected. Refer senicing to qualitied senice ~ewnnel. 1. Thread the speaker lead through the hole in the supplied connector cover plate. 2. Loosen the insulated red l

Краткое содержание страницы № 7

TYPICAL SYSTEM ARRANGEMENT TYPICAL SYSTEM CONNECI'IONS

Краткое содержание страницы № 8

SHURE HTS The Home Theater Sound Division of Shure Brothers Inc. 222 Hartrey Avenue Evanston, l L 60202-3696 Copyr~aht 1983. Shore BI-others Inc Pr~nted In U.S.A. 27A8165 (IA)