Руководство по эксплуатации Genz-Benz NEOX400-210T

Краткое содержание страницы № 1

NEOX400-210T
OWNER’S MANUAL
CONGRATULATIONS !
Your new NEOX400-210T Combo is designed with the power, features and performance that
today’s professional bassists desire.
The solid yet lightweight cabinet construction and powerful Neodymium dual 10”, 250 watt
loudspeakers provide a solid platform for the versatile, compact NEOX400 amplifier. The circuit
design, features and physical layout have been carefully calculated to deliver the best performance
and reliability in bass guitar amplification.

Краткое содержание страницы № 2

TECHNICAL INFORMATION The first stage of the NEOX400-210T preamp uses a low noise bi-fet linear scaling amplifier with a 2 pole low cut point at 23 Hz to prevent excessive speaker cone excursion and intermodulation distortion. Additional bandwidth roll-off is provided at 20 kHz for RFI suppression. The variable gain stages are a feedback-divider type control, one of which is all solid state and the other utilizing a cathode follower (tube), each providing a maximum gain of about 30 dB. On the tu

Краткое содержание страницы № 3

features may be provided with the active pickup, such as equalization, volume control and compression. Tuner Output Jack — The “tuner output jack is provided to allow a tuner to remain plugged into the amplifier while playing. This output remains active when the “mute switch is pressed, allowing for tuning your instrument while not sending signal to either the “direct output or the speaker. Signal level of -30dB (typical hot bass level) will drive all known tuners. Input Signal Mute Switch — T

Краткое содержание страницы № 4

LED will illuminate for approximately 3 seconds during power switch-on and switch-off. It is normal for this LED to glow while continuing to monitor the internal conditions for about 3 seconds after the protection relay has closed. It will also illuminate during any internal fault condition. If this happens, turn the amp off and consult a repair technician. • The “thermal LED indicates that the amplifier has overheated, engaged the protection circuit and shut down. This circuit is self-resettin

Краткое содержание страницы № 5

chorus, delay and reverb processors) require that the signal flow out of the send jack on the amplifier, through the unit where it is split into a dry (unaltered) signal and a wet (processed) signal. On the processing unit, you will use the mixed signal output to return the signals (both wet and dry) to the return jack on the amplifier. The ratio between the wet signal and the dry signal is heard as the amount of effects added back to the original signal, which is controlled by the mix knob (als

Краткое содержание страницы № 6

CAUTIONS • Never set an amplifier on anything that will tip over or collapse under its weight. • These amplifiers are capable of producing sound pressure levels that may cause permanent hearing loss. • There are no user serviceable parts inside these units. Always consult a qualified service repair facility for service. THE HEATSINK MAY BECOME VERY HOT!!! WARNING!! DO NOT TOUCH. The use and operation of this device constitutes an agreement of full release of any and all liability connected with