Краткое содержание страницы № 1
3D0038800A
»
CD-RW2000
CD Rewritable Recorder
Professional
OWNER’S MANUAL
CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT
REMOVE COVER (OR BACK). NO USER-SERVICEABLE PARTS
Ü INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.
The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert
the user to the presence of uninsulated “dangerous voltage” within the product’s enclosure
ÿ
that may be of sufficient magnitude to constitute a risk of electric sh
Краткое содержание страницы № 2
Important Safety Precautions For U.S.A IMPORTANT (for U.K. Customers) TO THE USER DO NOT cut off the mains plug from this equipment. This equipment has been tested and found to If the plug fitted is not suitable for the power points in your home or comply with the limits for a Class A digital device, the cable is too short to reach a power point, then obtain an pursuant to Part 15 of the FCC Rules. These appropriate safety approved extension lead or consult your dealer. limits are designed to p
Краткое содержание страницы № 3
IMPORTANT SAFETY INSTRUCTIONS CAUTION: "Note to CATV system installer: …Read all of these Instructions. This reminder is provided to call the CATV system installer’s attention to …Save these Instructions for later use. Section 820-40 of the NEC which provides guidelines for proper grounding …Follow all Warnings and Instructions marked on the audio and, in particular, specifies that the cable ground shall be connected to the equipment. grounding system of the building, as close to the point of ca
Краткое содержание страницы № 4
SAFETY INFORMATION This product has been designed and manufactured according to FDA regulations "title 21, CFR, chapter 1, subchapter J, based on the Radiation Control for Health and Safety Act of 1968", and is classified as a class 1 laser product. There is no hazardous invisi- ble laser radiation during operation because invisible laser radiation emitted inside of this product is completely confined in the protective housings. The label required in this regulation is shown in 1. CAUTION - DO N
Краткое содержание страницы № 5
Table of Contents 5 DISPLAY key ..................................... 13 1 – Introduction 6 MENU key .......................................... 13 1.1 About CD-R and CD-RW discs ......... 6 7 ENTER key ........................................ 13 1.2 Finalizing ............................................7 8 FADER key ........................................ 13 1.2.1 “Recordable” discs .................................... 7 9 MONITOR key ................................... 13 1.2.2 About this man
Краткое содержание страницы № 6
1 – Introduction ful licensor, your unauthorized recording, The CD-RW2000 CD rewritable recorder allows you reproduction or distribution thereof may result in to make your own CDs from a variety of sources— severe criminal penalties under copyright laws and other CDs, MD recordings, analog cassette tapes, and international copyright treaties. If you are uncertain records. about your rights, contact your legal advisor. Under Tracks can be recorded all at one time, or added, until no circu
Краткое содержание страницы № 7
1 – Introduction—Finalizing The main unit itself 1.2 Finalizing The remote control unit Two AA batteries for the remote control unit Although audio data may be written on a CD-R or A rack-mounting screw kit CD-RW disc, a standard CD player will not be able to read the data (i.e. play back the audio) until a final 1.3.1 Rack-mounting the unit table of contents (TOC) has been written at the start Use the rack-mounting kit to mount the unit in a stan- of the disc. dard 19-inch equipment
Краткое содержание страницы № 8
1 – Introduction—Environmental considerations The voltage supplied to the unit should match the Unlike conventional records, the compact disc has voltage as printed on the rear panel. If you are in any no grooves to collect dust and microscopic debris, doubt regarding this matter, consult an electrician. so gently wiping with a soft cloth should remove most particles. NOTE Wipe in a straight motion from the inside to the When transporting the unit, always use the original outside of the d
Краткое содержание страницы № 9
1 – Introduction—Environmental considerations from sources of heat such as radiators or heat-gen- 1.4.6 Default settings erating electrical devices. The default settings when the CD-RW2000 is • Always store CD-R discs in their “jewel cases” to shipped from the factory are given below. avoid dirt and dust accumulating on their surfaces. Setting Description Default value • Do not put labels or protective sheets on the discs Input selection 4.1, “Input selection”
Краткое содержание страницы № 10
2 – Features of the CD-RW2000 2 3 4567 8 A9 B 1C DEFGHIJKL MN OP Q RSTUV W XYZ 1 2 3 4 5 6 8 7 9 A B C D F E H G L K I J 10 TASCAM CD-RW2000
Краткое содержание страницы № 11
2 – Features of the CD-RW2000—Front panel A DISPLAY key 2.1 Front panel Repeated presses of this key cycle through the differ- ent time display modes. These modes differ, accord- 1 POWER switch ing to whether the unit is playing back or recording a The power switch is used to switch the unit between disc. off and on (full operational mode). B MULTI DIAL control When the unit is turned on, the display shows Use this control to select tracks for playback, to set Welcome!. parameter values, et
Краткое содержание страницы № 12
2 – Features of the CD-RW2000—Rear panel H PLAY key R ATT (attenuation for left balanced analog output) Use this key to start or resume playback or recording. Use a small Phillips screwdriver with this attenuator I PAUSE key if you need to reduce the output signal level from the Use this key to pause playback or recording. left balanced analog output. As set at the factory, a it is set to maximum output, and can reduce the level by J RECORD key 20 dB. Use this key to enter record ready mode
Краткое содержание страницы № 13
2 – Features of the CD-RW2000—Remote control unit D RECORD key 2.3 Remote control unit Use this key to enter record ready mode (equivalent to J). 1 OPEN/CLOSE key E SYNC REC key Opens and closes the disc tray (equivalent to 3). Use this key to turn synchronized recording on and 2 Number keys (0 through 10 and +10) off (equivalent to K). See 4.3.1, “Synchronized Use these keys for direct entry of track numbers recording” for details). when playing back, or making a programmed play F REC MUTE
Краткое содержание страницы № 14
2 – Features of the CD-RW2000—Connections Audio signals output from the unit are output from NOTE the balanced and unbalanced ANALOG OUT N Q There should be one, and only one, word clock source in a jacks, as well as from the DIGITAL AES/EBU OUT digital audio setup. Multiple word clocks in a setup may W, DIGITAL COAXIAL OUT jack X and DIGITAL result in damage to equipment. OPTICAL OUT connector Y simultaneously. 2.4.2 Control connections 2.4.1 Word sync connections The pinouts of this conn
Краткое содержание страницы № 15
3 – Playback operations The CD-RW2000 can be used to play back CDs Press the DISPLAY key (A or 5) to cycle through (including CD-R and CD-RW discs that have been these time display modes, as described below: recorded and finalized on other types of recorder), as Display shows Meaning well as CD-R discs and CD-RW discs that have been TOTAL Total elapsed time of the disc recorded on the unit. [blank] Elapsed time of the current track TOTAL REMAIN Time remaining of the current disc 3.1 Simple pl
Краткое содержание страницы № 16
3 – Playback operations—Programmed order playback 5 Repeat steps 3 and 4 above until the program is NOTE complete. Selecting the playback mode is only possible using the remote control unit. It is not possible to select the 6 Press the PLAY key (H or L) to start playback playback mode using the main unit alone. at the first program step. 1 Press the PLAY MODE key A repeatedly to The display shows the track, the current time cycle the display through the following: display, and the program
Краткое содержание страницы № 17
3 – Playback operations—CALL playback tion of the track as indicated by the subcode, but at 3.4 CALL playback the first position of the track where the audio level exceeds a set trigger level. The CALL keys (L and K) allow the unit’s play- The trigger level is the same as the recording trigger back position to be returned to the point at which level, as set in 4.3.1, “Synchronized recording”. Con- playback last started from pause mode. If there is no sult this section on how to set the trig
Краткое содержание страницы № 18
4 – Recording Before you start recording using the CD-RW2000, nal input level). There is also a ---- setting make sure that you understand the following key which represents a complete signal cut. points: NOTE Once you have recorded on a CD-R disc, the data If digital direct is selected, as described below (4.3.3, cannot be erased from it. “Digital direct”), the digital volume is bypassed and You can add tracks to an unfinalized recordable this menu item disappears. However, once the di
Краткое содержание страницы № 19
4 – Recording—Basic recording 4 Press the PLAY key (H or L) to start 4.2 Basic recording recording. Note that there is no need to “cue up” the NOTE recording position—the unit always finds the According to the “Red Book” (the specification for next available location on the disc and start audio CDs), a track cannot be less than four seconds recording to it. in length, and there can be a maximum of 99 tracks on an audio CD. Bear these limitations in mind when 5 Press the PAUSE key (I or
Краткое содержание страницы № 20
4 – Recording—Advanced recording When in record or record ready mode, repeated The number of remaining tracks can be changed dur- presses of the DISPLAY key (A or 5) cycle ing recording using the MULTI DIAL control. between displaying the remaining time left for 4.2.5 Full disc recording on the disc (TOTAL REMAIN) and the elapsed time of the track currently being recorded (no indica- If recording a long program, and the number of tor lit). tracks has not been restricted, when there is no spac
