Руководство по эксплуатации Soundstream Technologies Airbass Wireless Subwoofer Volume Control System

Краткое содержание страницы № 1

AIRBASS™
V
This device complies with F.C.C. Rules part 15. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference and, (2) This device must accept any interference that
OWNERS MANUAL AND
may be received, including interference that may cause undesired

120 Blue Ravine Road  Folsom  California 95630 USA
ph 916.351.1288  fax 916.351.0414
rev A - 5.21.96

12
1

SOUNDSTREAM TECHNOLOGIES
INSTALL ATION GUIDE

olume Cont

Краткое содержание страницы № 2

CONGRATULATIONS! TROUBLESHOOTING You now own the REFERENCE AIRBASS ™ Wireless Subwoofer PROBLEM CAUSE Remote System , the product of an uncompromising design and AIRBASS i n- • AIRBASS switch on the amplifier's main engineering philosophy. Your Soundstream REFERENCE accessory stalled, the LED is pc boa rd is in the "IN" position, and that the low pass the performance of your audio system. FLASHING, but filter in the amplifier has been engaged. (Read the a m- the unit is not

Краткое содержание страницы № 3

ADVANCED OPERATION TABLE OF CONTENTS Each button on the AIRBASS transmitter has a special "second" function which it can perform when it is held down for 2 seconds. The Design Features ................................ ................................ ...... 4 BUTTON Time Duration Function AIRBASS Transmitter and Receiver Board ............................. 5 é Volume Up Installation ................................ ................................ ............... 6 é Maxi

Краткое содержание страницы № 4

MULTIPLE CAR INSTALLATIONS INTRODUCTION For installations using one transmitter to control AIRBASS receiver The AIRBASS wireless subwoofer control allows you to grasp total boards in multiple cars, each transmitter has four "banks" of codes. control over your subwoofers. A hand - held wireless transmitter Any receiver board can be programmed to learn bank of codes. (programma ble to run multiple Soundstream amplifiers) con trols up to Therefore, any transmitter can control up to

Краткое содержание страницы № 5

MULTIPLE RECEIVER BOARD INSTALLATIONS For installations using multiple Reference amplifiers to drive multiple subwoofers, it may be desired to have one AIRBASS hand - held transmitter control all the subwoofer ampl ifiers at the same time. This is very easy to do, but the programming procedure will require the amplifier to be powered up wit h the bottom plate off. To program multiple receiver boards to one transmitter, please complete the Remove the bottom plate of the amplifier,

Краткое содержание страницы № 6

INSTALLATION BASIC OPERATION Disconnect all power wires from the amplifier. The AIRBASS receiver board comes from the factory pre - programmed Remove the bottom cover plate of the amplifier by removing the to be used with the transmitter it has been packaged with. The four screws at the ends of the amplifier. (There also may be AIRBASS screws on the center of the bottom plate on the larger Reference of the four buttons on the top of the remote controller. For initi al amplifiers.) A T