Руководство по эксплуатации Genelec AIW26

Краткое содержание страницы № 1

Genelec AIW26 Installation and
In-wall Speaker System Operating Manual

Краткое содержание страницы № 2

General Installation imaging is needed, such as the front chan- The Genelec AIW26 Active In-wall speaker Genelec recommends that you use the nels of a Surround Sound system or a Stereo system consists of a bass reflex type two- services of an authorized installation spe- system, we recommend that the speakers are way speaker and a matched remote amplifier cialist or other competent and experienced placed as far away from corners or other walls module, RAM1. It has been designed to the instal

Краткое содержание страницы № 3

See Table 1 for recommended cable gauges. ing brackets of the AIW26 need a clearance Attach the grill frame to the speaker with six The binding posts accept a cable up to 6 inside the wall of at least 125 millimeters M6x60 Phillips screws provided with the kit 2 mm (9 gauge). (5”) above the top edge of the hole and 65 (see Figure 5). As you tighten the screws 9 mm (2 / ”) below the lower edge. Also note evenly, the sheetrock will be clamped 16 If you are installing the AIW26 system to an th

Краткое содержание страницы № 4

Figure 6. Front panel of the RAM1 amplifier Figure 7. Rear panel of the RAM1 amplifier Mounting the RAM1 amplifier to an the binding posts. If you have lost the cable (1.22V) is needed in this setting. Most pre- equipment rack binding post tool then a large screwdriver will amplifiers are capable of this output level. also work, but be careful not to overtighten We recommend that you use the Genelec Setting the room response controls the binding posts as they may be damaged. RM1 rack mount kit

Краткое содержание страницы № 5

Safety considerations ‘treble tilt’ to -2 dB, if too bass heavy, set ‘bass ered with a piece of plexiglass to protect tilt’ to -2 dB. The adjustment is done by set- the settings. Attach the plexiglass over the • Servicing and adjustment must only ting the three groups of room response control switch groups with two Phillips screws when be performed by qualified service switches ‘treble tilt’, ‘bass tilt’ and ‘bass roll-off’ you have completed the adjustments. Do not personnel. The loudspea

Краткое содержание страницы № 6

SYSTEM SPECIFICATIONS AIW26 Speaker unit Free field frequency response of system: 45 Hz...21kHz (±2,5 dB) Maximum short time sine wave acoustic output at 1 m on axis in half space, averaged from 100 Hz to 3 kHz: >110 dB SPL Maximum peak acoustic output for a pair with music material: >120 dB SPL Drivers Bass: 182 mm (7”) 3 Treble: 19 mm ( / ”) metal dome 4 Harmonic distortion at 90 dB SPL @ 1 m on axis: < 3% (50...200 Hz) Figure 11. AIW26 side view < 0,5% (>200 Hz) Figure 10. A