Краткое содержание страницы № 1
Real Time DVR user manual
SHR-5082
SHR-5162
Real Time DVR
user manual
(Waste Electrical & Electronic Equipment)
Correct Disposal of This Product
imagine the possibilities
(Applicable in the European Union and other European countries with separate collection systems)
This marking shown on the product or its literature, indicates that it should not be disposed with other household wastes at
the end of its working life. To prevent possible harm to the environment or human health from uncontro
Краткое содержание страницы № 2
key features of your DVR The Digital Video Recorder (DVR) compresses the acquired images of 8/16 video channels from cameras using MPEG-4 technologies, and compresses the 4 channel audio inputs into ADPCM audio file in real time to record them on the hard disk or retrieve them from the hard disk simultaneously. In addition, it transfers the video and audio data through a network in real time and allows you to remotely monitor them using your PC. 8/16 channel Composite Input connectors NT
Краткое содержание страницы № 3
safety regulations Please be sure to keep the following in mind for the right use of the product to prevent proprietary risk or damage. Do not use multiple plugs at once. This may cause abnormal heat generation or fire Do not put a vase, flowerpot, cup, cosmetics, medicine, or vessel with water around you. This may cause fire. Do not bend the power cord forcibly nor put a heavy material on it. This may cause fire. Do not touch the power plug with wet hands. This may cause electric s
Краткое содержание страницы № 4
before start This user’s manual provides Information for using DVR such as brief introduction, part names, functions, connection to other equipment, menu setup, and the like. You have to keep in mind the following notices: SEC retains the copyright on this manual. This manual cannot be copied without SEC’s prior written approval. We are not liable for any or all losses to the product incurred by your use of non-standard product or violation of instructions mentioned in this manual. If
Краткое содержание страницы № 5
continued next page contents 03 Controls on the DVR INTRODUCING YOUR REAL 05 Rear panel jacks TIME DVR 06 Remote control 03 08 Checking installation environment INSTALLATION 08 Hdd addition 08 CONNECTING WITH OTHER 12 Connecting video, audio, and monitor DEVICES 12 Connecting the network 13 Connecting the USB 13 Connecting the alarm input/output 14 Connecting the RS-485 device 12 15 Operating the system LIVE 15 Live screen mode 17 Setting audio on/off 18 Freezing and zooming 15 18 Event monit
Краткое содержание страницы № 6
40 Before use SEARCH AND PLAY 40 Calendar search 40 Event search 41 Date time search 40 41 Go to first search 42 Go to last search 42 Backup search 42 Playback 44 Introduction Smart Viewer 44 Main features 44 PC specification (recommended) 44 Smart Viewer installation 44 45 Smart Viewer program execution 46 Smart Viewer initial screen 46 Setup mode 57 Monitoring mode 64 Search mode 68 Product specification APPENDIX 71 Outline drawings 73 Factory default 76 Troubleshooting (FAQ) 68 79 Open source
Краткое содержание страницы № 7
01 INTRODUCING introducing your real time DVR CONTROLS ON THE DVR 1 2 3 4 5082 9 8 7 6 5 1 2 3 4 5162 9 8 7 6 5 1. ALARM LED Lights when an event occurs. HDD LED Lights when the hard disk is operating. When the HDD is accessed, LED repeatedly blinks. NETWORK LED Lights when the data is transferred through the network. BACKUP LED Lights when a backup is in progress. REC LED Lights when a recording is in progress. 2. PTZ Button Toggles PTZ mode On and Off. ZOOM(TELE) Button Implements the digital
Краткое содержание страницы № 8
3. REC Button Starts or ends the recording (Fast/Step Rewind) Button - Step Rewind: Used for backward scene-by-scene search while at pause. - Fast Rewind: Used for quick backward search while in play. (-x2, -x4, -x8, -x16, -x32, -x64) Button (STOP) Ends search while in play. (PLAY/PAUSE) Button Pauses and resumes the screen play. (Fast/Step Forward) Button - Fast Forward: Used for quick forward search while in play. (x2, x4, x8, x16, x32, x64) - Step Forward: Used for forward scene-by-scene sea
Краткое содержание страницы № 9
01 INTRODUCING REAR PANEL JACKS 5082 REAR 1 2 3 4 5 6 7 8 9 10 11 12 5162 REAR 1 2 3 4 5 6 7 8 9 10 11 12 1 VIDEO OUT Composite video output port (BNC type connector) 2 AUDIO OUT Audio output port (RCA jack) a 3 VGA VGA video output port 4 S-VIDEO S-VIDEO video output port 5 NETWORK Network connection port 6 AUDIO IN Audio input port (RCA jack) SPOT1: 1 channel exclusive SPOT output 7 SPOT SPOT2: The same output as the Main VIDEO OUT (OSG is not displayed) 8 USB USB connection port - ALARM 1–16
Краткое содержание страницы № 10
REMOTE CONTROL 06_ introducing SHR-5162_Eng.indb 6 2007-06-18 ｿﾀﾀ・11:47:08 Using the NUMERIC Buttons CHANNEL 1–9 Press the 1 to 9 button respectively. Press the 0(10+) button, release, and press the 0 button again within 3 seconds.Or press the 0(10+) button, CHANNEL 10 release, and wait 3 seconds. CHANNEL 11–16 Press the 0(10+) button, release, and press the 1 (or 2, 3, 4, 5, 6) button again within 3 seconds. RECORD OPEN/CLOSE Starts or ends the Used to open and close recording. the
Краткое содержание страницы № 11
01 INTRODUCING REMOTE CONTROL introducing _07 SHR-5162_Eng.indb 7 2007-06-18 ｿﾀﾀ・11:47:09 Using the NUMERIC Buttons CHANNEL 1–9 Press the 1 to 9 button respectively. Press the 0(10+) button, release, and press the 0 button again within 3 seconds.Or press the 0(10+) button, CHANNEL 10 release, and wait 3 seconds. CHANNEL 11–16 Press the 0(10+) button, release, and press the 1 (or 2, 3, 4, 5, 6) button again within 3 seconds. RECORD OPEN/CLOSE Starts or ends the Used to open and close
Краткое содержание страницы № 12
installation You should pay attention to the following before you use the product. Do not use it outdoor. Do not place water or liquid near the connection part or the product. Do not impose excessive shock or force. Do not pull out the power cord unreasonably. Do not disassemble the product on your own. Do not exceed the rated input or output voltage range. Use the certified power cord only. For the product with an input ground, use a power plug with a ground pin. Please keep the
Краткое содержание страницы № 13
02 INSTALLATION Setting the jumper [Checking HDD Data] Please, pay attention to Following CAUTION information to minimize the chance of losing HDD data. Remember that you should protect HDD from any impact or misuse as this may cause damaged. The Manufacturer is not responsible The jumper setting method is illustrated on the for missing data or defects caused surface of the purchased HDD. by the user’s mishandling. Using SAMSUNG hard disk, the jumper setting Note: Adding Extra HDD
Краткое содержание страницы № 14
3. There are brackets (Bracket-HDD) mounted on the right and left sides where you can mount HDDs. Remove the screws holding each bracket to mount an HDD onto. BRACKET- HDD(B) 5. To add a hard disk, the built-in HDD (Primary Master) should have been installed. Basically a built-in HDD has been installed as the Primary Master and a DVD-RW driver as the Secondary Master. Before adding a hard disk, set the jumper for master and slave. The jumper setting method is illustrated on the surface
Краткое содержание страницы № 15
02 INSTALLATION 6. To add another hard disk after adding a hard 8. When adding hard disks completes, connect disk completes, remove the Bracket-HDD(B) the power supply cable, signal transmission on the DVD-RW driver. cable (IDE Cable), and fan cable to the hard disks. BRACKET-HDD(B) 7. Fix the hard disk to the Bracket using 4 (B)SCREW-MACHINE (6-32UNC, L4. 2) provided when purchasing the HDD. The screws should be fastened not to come loose. Fix the Bracket-HDD(B) using screws after alig
Краткое содержание страницы № 16
connecting with other devices The illustrations are described based on SHR-5162. CONNECTING VIDEO, AUDIO, AND MONITOR CONNECTING THE NETWORK Connecting to Internet through Ethernet (10/100BaseT) 12_ connecting SHR-5162_Eng.indb 12 2007-06-18 ｿﾀﾀ・11:47:55
Краткое содержание страницы № 17
03 CONNECTING Connecting to Internet through ADSL CONNECTING THE USB CONNECTING THE ALARM INPUT/OUTPUT 1. There are two USB connecting ports on the front and rear panels of the product. The Alarm IN/OUT ports on the rear of the product have the following elements: 2. USB Hard Disk, USB CD/DVD, and USB 5082 Alarm IN/OUT Ports Memory can be connected through any of those ports. 3. If the USB HDD is connected to the system, it should be detected and set through Menu > System > Storage Set
Краткое содержание страницы № 18
CONNECTING THE RS-485 DEVICE You can connect an RS-485 device through a rear port of the product. For example, you can connect and control PTZ cameras supporting the RS-485 communication. You can also adopt either Half Duplex or Full Duplex method for exchanging data. PTZ device Rear Half Duplex Type Data (–) Tx(–) Data (+) Tx(+) Full Duplex Type Rx(+) Rx(–) Rx(–) Tx(–) Rx(+) Tx(+) Supportable baud rates are 600, 1200, 2400, 4800, 960
Краткое содержание страницы № 19
04 LIVE live OPERATING THE SYSTEM LIVE SCREEN MODE Turn on the power and the following Samsung Live screen icons logo appears. The live screen icons display the status of current setup or function. Upon completion of initializing procedure, the CAM_01 live screen appears with a beep sound. (It takes about one minute until a live screen comes up.) If a new HDD is installed, the initialization may take much more time because it includes a new HDD initialization. If the live screen doe
Краткое содержание страницы № 20
: PTZ icon : Auto Sequence icon This icon appears when setting the PTZ device This icon appears in Auto Sequence mode. and it changes to yellow when operating the PTZ. : Backup Play icon : Audio icon This icon appears when the backup data is now This icon represents the ON/OFF status of audio played. and it changes to yellow when the audio is set to ON. It does not appear in Video mode or when : Fan Error icon This icon appears when the fan does not work the audio is disabled. properly. : Sen
