Руководство по эксплуатации LOREX Technology DCP1000

Краткое содержание страницы № 1

AUTO PAN TILT COLOR DOME
CAMERA FOR USE WITH VISTAPRO4
DIGITAL MONITORING SYSTEM






DCP1000
DYNACOLOR

Краткое содержание страницы № 2

CAUTION ! RISK OF ELECTRIC SHOCK. DO NOT OPEN. CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). NO USER-SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. Explanation of two Symbols The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure

Краткое содержание страницы № 3

Pan Tilt Controller Interface Module ① ② ③ ③6PIN DIP ②DVR INPUT ①CAMERA INPUT SWITCH CONNECTOR CONNECTOR Port Description Connection Type To Camera RS-485 data input/ video input 6 Pin DIN jack To DVR Serial data output / video output 6 Pin DIN jack SW 1 -6 Camera ID selection 6 Pin DIP switch TO CAMERA - transmits the Pan/Tilt control signals from the VistaPro 4 to the DCP1000 Dome Camera - receives the video signal from the DCP1000 Camera to the VistaPro 4. TO

Краткое содержание страницы № 4

INSTALLATION Ensure electrical power is not connected to the dome camera and PC system during installation. DIAGRAM SHOWING TYPICAL SET-UP RS-232C to RS-485 CONVERTER RS-485(+) RS-232C (to PC COM Port) RS-485(-) 65ft 7ft 6Pin Din RS485 Cable Cable Pan/Tilt PT Dome Camera Interface DC12V VIDEO (VistaPro 4 Main Board) Important Note: For the P/T/Z Camera Model setting in the Camera menu of Setup in the VistaPro4, the DCP1000 is the “DYNACOLOR” camera

Краткое содержание страницы № 5

Step 2: Connecting the Camera to the VistaPro4 Digital Video Capture Card At the location of the PC, plug the other end of the 65’ Camera DIN cable into the DIN port labeled “To Camera” found on the PT interface module. Using the 7’ RS-485 Connection Cable, connect the end terminated with the DIN plug to the port labeled “To DVR” (next to the DIP switches) on the PT Interface module. On the other end of the RS-485 Connection Cable, screw the single orange wire into the “TX +” termin