Краткое содержание страницы № 1
Service
This manual is to be used by qualified appliance
technicians only. Maytag does not assume any
This Base Manual covers general information
responsibility for property damage or personal
injury for improper service procedures done by Refer to individual Technical Sheet
an unqualified person.
for information on specific models
This manual includes, but is
not limited to the following:
AGR4400ADW
Freestanding AGR4412ADB/Q/S/W
AGR5712ADB/Q/S/W
CPL1100ADH/L/Q/T/W
Gas Range CPL1110ADH/L/T
CPR11
Краткое содержание страницы № 2
Important Information Pride and workmanship go into every product to provide our customers with quality products. It is possible, however, that during its lifetime a product may require service. Products should be serviced only by a qualified service technician who is familiar with the safety procedures required in the repair and who is equipped with the proper tools, parts, testing instruments and the appropriate service information. IT IS THE TECHNICIANS RESPONSIBILITY TO REVIEW ALL APPROPR
Краткое содержание страницы № 3
Table of Contents Important Information .................................................... 2 Oven Door Removal .................................................21 Important Safety Information Oven Door Hinge Reciever ....................................... 22 Safety Practices for Servicer .................................... 4 Side Panel Removal ................................................ 22 Servicing .................................................................. 4 Backguard .........
Краткое содержание страницы № 4
Important Safety Information Recognize this symbol as a safety precaution. ! WARNING ! Due to the nature of cooking, fires can occur as a result of overcooking or excessive grease. Although a fire is unlikely, if one occurs proceed as follows: WARNING ! If the information in this manual is not followed exactly, Oven Fires a fire or explosion may result causing property 1. Do not open the oven door. damage, personal injury or death. 2. Turn all controls to the OFF position. 3. As an added precaut
Краткое содержание страницы № 5
Important Safety Information 4. Using lights—Use a hand flashlight when servicing Never use range for warming or heating a room. This ranges or checking for gas leaks. Electric switches may cause burns, injuries, or a fire. should not be operated where leaks are suspected. Do not use water on grease fires. This will avoid creating arcing or sparks which could Do not let grease or other flammable materials collect ignite the gas. If electric lights are already turned on, in or around rang
Краткое содержание страницы № 6
Important Safety Information Gas Burner Orifices Universal orifices are Baking, Broiling, and Roasting used on most valves. Do not use oven area for storage. They must be adjusted Stand back from range when opening door of a hot or set for the type of gas oven. Hot air or steam can cause burns to hands, being used Natural or face, and eyes. LP. Do not use aluminum foil anywhere in the oven. This After servicing a valve or could result in a fire hazard and damage the range. orifice verify i
Краткое содержание страницы № 7
General Information This manual provides basic instructions and suggestions This manual contains information needed by authorized for handling, installing and servicing gas ranges. service technicians to install and service gas ranges. There may be, however, some parts which need further The directions, information, and warnings in this manual explanation. Refer to the Installation Instructions, Use are developed from experience with, and careful testing and Care, Technical Sheets or the toll-fr
Краткое содержание страницы № 8
General Information Specifications Model Identification Refer to individual Technical Sheet for specification Complete enclosed registration card and promptly return. information. If registration card is missing: • For Amana product call 1-800-843-0304 or visit the Web Site at www.amana.com Placement of the Oven For Maytag product call 1-800-688-9900 or visit the This freestanding range must be placed in the kitchen or Web Site at www.maytag.com comparable room. All safety guidelines must be
Краткое содержание страницы № 9
General Information Grounding ! WARNING NOTE: This appliance must be properly grounded, for Attaching adapter ground terminal to wall receptacle personal safety. cover screw does not ground appliance unless the Power cord on this appliance is equipped with a three- cover screw is metal and not insulated, and wall prong grounding plug. This matches standard three-prong receptacle is grounded through the house wiring. grounding wall receptacle to prevent possibility of electric Consumer should hav
Краткое содержание страницы № 10
Range Description Control Oven Light Switch Surface Surface Burners Burners Surface Burner Surface Burner Control Knobs Control Knobs Door Handle Broil Burner Oven Door Oven Light and Sensor Oven Racks Door Hinge Door Hinge Bake Burner Model Number Rating Label Service/ Warming Drawer 10 16023522 ©2004 Maytag Services
Краткое содержание страницы № 11
Troubleshooting Procedures WARNING ! To avoid risk of electrical shock, personal injury or death; disconnect power and gas to oven before servicing, unless testing requires power and/or gas. Problem Possible Cause Correction Poor ground on burner cap ........................... • Clean burner cap. Weak or failed spark module ........................ • Replace spark module. Burners will not ignite; no Low gas pressure .......................................... • Verify pressure 4” WC
Краткое содержание страницы № 12
Troubleshooting Procedures WARNING ! To avoid risk of electrical shock, personal injury or death; disconnect power and gas to oven before servicing, unless testing requires power and/or gas. Problem Possible Cause Correction Failed ignitor. ................................................. • Check ignitor current draw, 3.2 – 3.6 Amps. Replace ignitor, if it fails test. Gas pressure too high ................................... • Check for correct gas pressure. Natural gas pres
Краткое содержание страницы № 13
Troubleshooting Procedures WARNING ! To avoid risk of electrical shock, personal injury or death; disconnect power and gas to oven before servicing, unless testing requires power and/or gas. Problem Possible Cause Correction Failed oven lamp ..................................... • Check lamp and replace is necessary. Failed wiring ............................................ • Check for broken, loose or dirty connections. Oven light does not operate. Failed light socket........
Краткое содержание страницы № 14
Component Testing Procedures WARNING ! To avoid risk of electrical shock, personal injury or death; disconnect power and gas to oven before servicing, unless testing requires power and/or gas. Illustration Component Test Procedure Results Oven light socket Test continuity of receptacle terminals ... Indicates continuity with bulb inserted. Measure voltage at oven light................. 120 VAC, see wiring diagram for terminal identification. If no voltage present, check wiring.
Краткое содержание страницы № 15
Component Testing Procedures ! WARNING To avoid risk of electrical shock, personal injury or death; disconnect power and gas to oven before servicing, unless testing requires power and/or gas. Illustration Component Test Procedure Results Spark module Test for voltage at terminals 4 + 0 L and N............................................... 120 VAC Input GND L or N Polarity and ground ............................ Not subject to polarity Spark module Test for voltage at
Краткое содержание страницы № 16
Component Testing Procedures WARNING ! To avoid risk of electrical shock, personal injury or death; disconnect power and gas to oven before servicing, unless testing requires power and/or gas. Illustration Component Test Procedure Results M1 Controlled Oven temperature Press Bake pad. While increasing or decreasing oven adjustment Enter 550 on the digit-pad. temperature, this does not affect self- Immediately press and hold Bake pad cleaning temperature. for 3 to 5 seconds. Oven
Краткое содержание страницы № 17
Component Testing Procedures ! WARNING To avoid risk of electrical shock, personal injury or death; disconnect power and gas to oven before servicing, unless testing requires power and/or gas. "Quick Test" Mode for Electronic Range Control Follow procedure below to use the quick test mode. Entries must be made within 32 seconds of each other or the control will exit the quick test mode. 1. Press and hold Cancel and Broil pads for 3 seconds. 2. Once the control has entered the "Qui
Краткое содержание страницы № 18
Component Testing Procedures WARNING ! To avoid risk of electrical shock, personal injury or death; disconnect power and gas to oven before servicing, unless testing requires power and/or gas. Diagnostic Code Checking Code Description When Checked Detection 1c1c Shorted key Always 1 minute 1c2c Keyboard tail disconnected Always 1 minute 1c31 Cancel key circuit problem Always 20 seconds 1c6c EEPROM error When accessing EEPROM 3 tries 1c7c Control not calibrated Always 3 tries 1c8c
Краткое содержание страницы № 19
Component Testing Procedures ! WARNING To avoid risk of electrical shock, personal injury or death; disconnect power and gas to oven before servicing, unless testing requires power and/or gas. NOTES: 1 "Action Taken" applies as long as the condition exists. If the condition goes away, the control recovers. 2 If there is a cook function or timer active, the function continues. The user cannot edit the function, and [Cancel] will cancel the cook mode. 3 Flash rate: 0.2 seconds on
Краткое содержание страницы № 20
Disassembly Procedures To avoid risk of electrical shock, personal injury, or death: ! WA RN IN G disconnect electrical and gas supply before servicing. 4. Reverse procedure to reinstall control board Removing and Replacing Range assembly. 1. Turn off power to the range at the circuit breaker. 2. Turn off gas supply line to unit. Rocker Switch 3. Pull the range forward out of the cabinet opening. 1. Remove control panel, see "Control Panel" procedure 4. Unplug the power cord leading from unit to
