Краткое содержание страницы № 1
Gas hob
INSTR INSTRUCTION BOOKLET UCTION BOOKLET
INSTR INSTR INSTRUCTION BOOKLET UCTION BOOKLET UCTION BOOKLET
Please read this instruction booklet before using the appliance
Mod. EGG 690
GB
35685-4801
Краткое содержание страницы № 2
Important Safety Information You MUST read these warnings carefully before installing or using the hob. If you need assistance, contact our Customer Care Department on 08705 950950 Installation Service This hob must be installed by qualified personnel, This hob should only be repaired or serviced by an according to the manufacturer’s instructions and to authorised Service Engineer and only genuine the relevant British Standards. approved spare parts should be used. Any gas installation must b
Краткое содержание страницы № 3
Contents For the User For the Installer Important Safety Information 2 Instructions for the Installer 7 Description of the Hob 3 Important safety requirements 8 Operation 4 Installation 8 Maintenance and Cleaning 4 Building In 9 Something Not Working? 5 Electrical connections 10 Service and Spare Parts 5 Wiring Diagram 11 Guarantee Conditions 6 Fault Finding 11 Commissioning 13 Conversion from Natural Gas to LPG 14 Description of the Hob 3 1 3 5 4 2 1. Hob top 2. Rapid Burner 3. Semi-rapid Burne
Краткое содержание страницы № 4
Operation Hob burners To light a burner: To ensure maximum burner efficiency, you should only push in the relevant control and turn it to maximum use pots and pans with a flat bottom fitting the size of position; the burner used (see table). then adjust the flame as required. If the burner does not ignite, turn the control knob to Burner minimum maximum zero, and try again. diameter diameter If you use a saucepan which is smaller than the recommended size, the flame will spread beyond Large
Краткое содержание страницы № 5
Something Not Working? If the hob is not working correctly, please carry out the following checks before contacting your local Service Force Centre. IMPORTANT: If you call out an engineer to a fault listed below, or to repair a fault caused by incorrect use or installation, a charge will be made even if the appliance is under guarantee. SYMPTOM SOLUTION There is no spark when lighting the gas Check that the unit is plugged in and the electrical supply is switched on Check that the RCCB h
Краткое содержание страницы № 6
Customer Care Department For general enquiries concerning your Electrolux appliance or for further information on Electrolux products, please contact our Customer Care Department by letter or telephone at the address below or visit our website at www.electrolux.co.uk Customer Care Department ELECTROLUX 55-77 High Street Slough Berkshire SL1 1DZ Tel. 08705 950950 (*) * calls to this number may be recorded for training purposes. Guarantee Conditions * Appliances found to be in use within a commerc
Краткое содержание страницы № 7
Instructions for the Installer Engineers technical data Ignition HT Spark Overall dimensions Spark Generator Ispra Control's BF 50046 Width: 615,5 mm (front edge) 230-240V 0.6 YA T 120 580 mm (rear edge) Spark Gap Fixed Depth: 510 mm Semi-rapid Burner Heat Input 1.9 kW (6483 BTU/HR) Cut out dimensions Width: 550 mm Rapid Burner Depth: 470 mm Heat Input 2.9 kW Natural Gas (9895 BTU/HR) 2.7 kW L.P.G. (9212 BTU/HR) Supply connections Auxiliary Burner Gas: Heat Input 1.0 kW (3412 BTU
Краткое содержание страницы № 8
50 mm 100 mm 50 mm 100 mm 50 mm 50 mm 600 mm Important safety requirements This hob must be installed in accordance with the Gas Safety (Installation and FITTING THE GAS HOB WITHOUT A COOKER HOOD ABOVE Use) Regulations (Current Edition) and the IEE Wiring Regulations (Current Edition). Detailed recommendations are contained in the following British Standards Codes Of Practice: B.S. 6172/ B.S. 5440, Part 2 and B.S. 6891 Current Editions. The hob should not be installed in a bed sitting room with
Краткое содержание страницы № 9
Cut Out Size The dimensions of the cut-out are given in the diagram. 1 ON/OFF SWITCH FLEX OUTLET FO 2098 FO 0763 Building In ON/OFF SWITCH 3 2 Building over a cupboard or drawer If the hob is to be installed above a cupboard or drawer a 60 it will be necessary to fit a heat resistant board below the base of the hob on the underside of the work b FLEX surface. OUTLET It is also recommended to carry out the electrical connection to the hob as shown in diagrams 1 and 2. Building over a kitchen
Краткое содержание страницы № 10
Electrical connections Any electrical work required to install this hob Permanent Connection should be carried out by a qualified electrician or In the case of a permanent connection, it is necessary competent person, in accordance with the current that you install a double pole switch between the hob regulations. and the electricity supply (mains), with a minimum gap THIS APPLIANCE MUST BE EARTHED. of 3 mm. between the switch contacts and of a type The manufacturer declines any liability should
Краткое содержание страницы № 11
Wiring Diagram N 1 220 240 2 3 0 4 2 A. IGNITOR SWITCH 1 Brown B. IGNITOR UNIT L Fault Finding SOCKET PLUG (with cover Preliminary Electrical Systems (face view) removed) Check ( ) Earth Wire ( ) E Green/Yellow Blue Green START Yellow Isolate appliance and carry out: A: Earth Continuity Neutral Wire N L Blue check. Blue Green Brown Yellow Carry out: Electricity supply NO YES Carry out: D: Resistance to should now be C: Polarity check. Earth check. satisfactory. Has inlet fuse blown? A. EART
Краткое содержание страницы № 12
Ignition System / Gas Ignition YES Check gas supply at Ignitor does not spark burner NO Check plug top fuse and replace if necessary Light burner manually Check polarity and earth Check by pass simmer continuity of supply point adjusted Check position of the Check earth continuity electrode of appliance Check continuity from the tip of Check fitting of burners Check continuity from 'N' on the each electrode to the terminals 1 mains connector block and "O" on to 4 on the ignitor unit the ignitor
Краткое содержание страницы № 13
Commissioning When the hob has been fully installed it will be necessary to check the minimum flame setting. To do this, follow the procedure below. - Turn the gas tap to the MAX position and ignite. - Set the gas tap to the MIN flame position then turn the control knob from MIN to MAX several times. If the flame is unstable or is extinguished follow the procedure below. Procedure: Re-ignite the burner and set to MIN. Remove the control knob. To adjust, use a thin bladed screwdriver and turn th
Краткое содержание страницы № 14
Conversion from Natural Gas to LPG It is important to note that this model is designed for To adjust the gas rate use with natural gas but can be converted for use with With the aid of a thin bladed screwdriver completely butane or propane gas providing the correct injectors tighten down the by pass adjustment screw, see the are fitted. The gas rate is adjusted to suit. illustration under the heading ‘Commissioning’. Upon completion affix the replacement rating plate on Method the under side of
Краткое содержание страницы № 15
15
Краткое содержание страницы № 16
CUSTOMER CARE Electrolux 55-77 High Street Slough Berkshire, SL1 1DZ Tel: 08705-950950 © Electrolux plc 2003 The Electrolux Group. The world’s No.1 choice. The Electrolux Group is the world’s largest producer of powered appliances for kitchen, cleaning and outdoor use. More than 55 million Electrolux Group products (such as refrigerators, cookers, washing machines, vacuum cleaners, chain saws and lawn mowers) are sold each year to a value of approx. USD 14 billion in more than 150 count
