Краткое содержание страницы № 1
Installation, Service and User Instructions
FREESTANDING GAS RANGES
BERTAZZONI
DIMENSIONS: 36’’ (915 mm)(W) x 253/16’’ (640 mm)(D) x36’’ (915 mm)(H)
Models X365GGVX (X36 5 00 X) [M3W0GTU4X(2 or 5)A]
Models X366GGVX (X36 6 00 X) [M3Y0GTU4X(2 or 5)A]
IMPORTANT - PLEASE READ AND FOLLOW
-Before beginning installation, please read these instructions completely and carefully.
-Do not remove permanently affixed labels, warnings, or plates from the product. This may void the warranty. -Please
Краткое содержание страницы № 2
WARNING Read this instruction booklet before installing and using the appliance. The manufacturer will not be responsible for any damage to property or to persons caused by incorrect installation or improper use of the appliance. The manufacturer reserves the right to make changes to its products when considered necessary and useful, without affecting the essential safety and operating characteristics. This appliance has been designed for non-professional, domestic use only. Warning: do
Краткое содержание страницы № 3
WARNING: Do not use aerosol sprays in the vicinity of this appliance while it is in operation Requirements Room ventilation – Location and venting. ATTENTION: An exhaust fan may be used with the appliance; in each case it shall be installed in conformity with the appropriate national and local standards. ATTENTION: Exhaust hood operation may affect other vented appliances; in each case it shall be installed in conformity with the appropriate national and local standards. INSTALLATION MA
Краткое содержание страницы № 4
BACKGUARD INSTALLATION INSTRUCTION 1) Remove n°2 screws fixing worktop as shown in fig.1 2) Place front part of the backguard and attach it from bottom side with the two removed screws (point 2) as shown in fig .2 3) Fix the front part of the backguard with the screws supplied with the backguard kit (fig.3) 4) Assemble back part with front part of the backguard and fix them with a screws supplied with the backguard kit (fig.4) 1 2 3 4 WORKTOP FRONTGUARD INSTALLATION INSTRUCTIO
Краткое содержание страницы № 5
INSTALLATION SIDE-BY-SIDE TO KITCHEN CABINET 1. This range may be installed directly adjacent to existing 36" (91.5 cm) high cabinets. IMPORTANT: The top border of the worktop should be at the same level of the adjacent cabinet countertop. This can be accomplished by raising the unit using the adjustment spindles on the legs. 2. The range CANNOT be installed directly adjacent to sidewalls, tall cabinets, tall appliances, or other vertical surfaces above 36" (91.4 cm) high. There mus
Краткое содержание страницы № 6
COOKER HOOD INSTALLATION The bottom of the hood should be 25 1/2" (65 cm) min. to 31 1/2" (80 cm) above the countertop. This would typically result in the bottom of the hood being 61 1/2" (156.2 cm) to 67 1/2" (171.5 cm) above the floor. Check for other minimum clearance requirements mandated by specific local or regional installation codes. Refer to the rangehood installation instructions for additional information. These dimensions provide for safe and efficient operation of the hood.
Краткое содержание страницы № 7
Wiring diagram For freestanding gas range model X366GGVX (X36 6 00 X) M3Y0GTU4X(2 or 5)A CAUTION: label all wires prior to disconnection when servicing controls. Wiring errors can cause improper and dangerous operation. Verify proper operation after servicing. For freestanding gas range model X365GGVX (X36 5 00 X) M3W0GTU4X(2 or 5)A CAUTION: label all wires prior to disconnection when servicing controls. Wiring errors can cause improper and dangerous operation. Verify pro
Краткое содержание страницы № 8
GAS CONNECTION All gas connections must be made according to national and local codes. The gas supply (service) line must be the same size or greater than the inlet line of the appliance. This range uses a 1/2" NPT inlet (see fig. in this chapter for details of gas connections installations).On all pipe joints use sealant resistant to LP gas. 1. Manual Shut-off Valve: This installer-supplied valve must be installed in the gas service line ahead of the appliance in the gas flow and in a pos
Краткое содержание страницы № 9
and no less than 2”( 5 cm) and no more than 8”(20,3 cm) from the left side (facing product). To connect gas between shut-off valve and regulator, use agency-approved, properly sized flexible or rigid pipe. Check all local code requirements. PERFORMANCE CHECKLlST All burners are tested before leaving the factory. There are no adjustments for the burners if connected according to the information on the rating plate. Check each burner for proper operations. Flames should be blue in all setti
Краткое содержание страницы № 10
- CHANGING THE NOZZLES FOR USE WITH OTHER TYPES OF GAS: To change the nozzles of the burners use the following procedure: Lift up the burners and unscrew the nozzles ( Fig.) using an adjustable spanner of 7 mm and change the nozzles with those designed for the new gas supply according to the information given in TABLE shown below. Follow the instructions below to change the oven burner nozzle: 1) Remove the oven level (Fig. 9A-9B). 2) Loosen the screw V and pull out the burne
Краткое содержание страницы № 11
Models X366GGVX (X36 6 00 X) [M3Y0GTU4X(2 or 5)A] Adapting to different types of gas Burner Position Injector Gas Pressure Max Rate Min Rate By-pass diam. [mm.] Type [i.w.c.] [BTU/h] [W] [BTU/h] [W] diam. [mm] Auxiliary Front R 0,90 NG 4” 3400 996 900 264 Regulated 0,54 LP (Propane) 11” 3400 996 900 264 0,29 Semi-Rapid Rear L & C 1,18 NG 4” 6100 1787 1500 439 Regulated Front C 0,70 LP (Propane) 11” 6100 17871500 439 0,36 Rapid Rear L 1,55 NG 4” 10400 30472500 732 Regulated
Краткое содержание страницы № 12
Work surface burner adjustment: follow the instructions below to adjust the work surface burner minimum: 1) Light the burner and set the knob to the MINIMUM position (small flame). 2) Remove the knob of the valve that is press fit on the rod of that valve. 3) The cooker is equipped with safety valves, use a small slotted screwdriver the choke valve located on the valve body and turn the choke screw to the right or left until the burner flame is adjusted to minimum 4) Make sure that the fl
Краткое содержание страницы № 13
USER MANUAL WARNINGS: Keeping appliance area clear and free from combustible materials, gasoline and other flammable vapors and liquid. Do not store dangerous or flammable material in the cabinet areas above appliance; store them in a safe place in order to avoid potential hazards. For safe use of appliance, do not use it for space heating. Do not use aerosol sprays in the vicinity of this appliance while it is in operation Do not use oven doors as support or for sit-down. Do not us
Краткое содержание страницы № 14
USING BURNERS A diagram is etched on the control panel above each knob which indicates which burner corresponds to that knob. (flame) Manual ignition: Manual ignition is always possible even when the power is cut off or in the event of prolonged power failure. Turn the knob that corresponds to the burner selected counterclockwise to the MAXIMUM position at the etched star (large flame) and place a lit match up to the burner. Automatic electric ignition: Turn the knob that correspond
Краткое содержание страницы № 15
USING THE GAS OVEN All the gas oven cookers are equipped with a thermostat and safety device to adjust the cooking temperature. The oven temperature is set by turning the knob counterclockwise to match the indicator with the temperature selected. The gas oven is combined with a gas broiler. See the specific pages for use information. WARNING: If the burner flames are extinguished accidentally, turn off the control knob and do not try to relight the oven until after at least 1 minute.
Краткое содержание страницы № 16
The convection system partially changes the various notions about traditional cooking. Meat no longer needs to be turned while it is cooking and the rotisserie is no longer needed to cook a roast on the spit. Just put the meat directly on the shelf. GAS OVEN COOKING TABLE TEMP °F/ °C HEIGHT MINUTES MEAT PORK ROAST 430/220 4 60-70 BEEF ROAST (YOUNG STEER) 480/250 4 50-60 BEEF ROAST 465/240 4 60-70 VEAL ROAST 430/220 4 60-70 LAMB ROAST 430/220 4 45-55 ROAST BEEF 445/230 4 55-65 R
Краткое содержание страницы № 17
USING THE GAS BROILER The gas broiler is controlled with the same gas oven knob, but turning it clockwise instead of counterclockwise (see the gas oven use instructions), matching the symbol with the indicator. The broiler burner always operates at maximum and therefore there is no minimum position. In addition, it is equipped with a safety device to prevent the flame from going out. The gas broiler can also be ignited in different ways: - Manual lighting: Just completely open t
Краткое содержание страницы № 18
AFTER SALE SERVICE: Please note here below details for after save service. Refer to warranty certificate for warranty condiftions Dealer /Importer: Name, address, phone SERVICE CENTERS Name Phone MANUFACTURER: BERTAZZONI SPA VIA PALAZZINA, 8 – 42016 – GUASTALLA (
Краткое содержание страницы № 19
SPARE PART LIST Quantity Number Drawing Code Description 1 601736 CIRCUIT DIAGRAM 1 1 11 202317 PART FOR BURNER FIXING 3 3 11 202386 PART FOR DUAL WOK AND SEMI RAPID BURNERS 1 1 13 510507 SMALL BURNER 1 1 13 510508 SEMI RAPID BURNER 1 3 13 510509 RAPID BURNER 1 1 13 510511 DUAL BURNER 1 1 14 504128 SMALL FLAME SPREADER 1 1 14 504129 MEDIUM FLAME SPREADER 2 3 14 504130 RAPID FLAME SPREADER 1 1 14 504189 ULTRA RAPID FLAME SPREADER 1 1
Краткое содержание страницы № 20
478 410558 FLAP DOOR 1 1 544 504163 OVEN BURNER +BAFFLE+ SPARK PLUG +THERMOC 1 1 546 505013 SUPPORT FOR BROILER BURNER NOZZLE 1 1 583 508021 TERMOCOUPLE MM600 2 2 583 508025 TERMOCOUPLE MM300 1 2 583 508026 THERMOCOUPLE OVEN BURNER 1 1 583 508027 TERMOCOUPLE MM800 1 1 583 508032 TERMOCOUPLE FOR DUAL BURNER 2 2 611 603020 MOTOVENTILATOR 1 1 612 603019 COOLING FAN 1 1 620 602039 COMMUTATOR 1 1 623 608046 OVEN BULB WITH HOLDER 2 2 648 601991 TERMINAL SEPARATOR 1 1 649 608044 SMALL WA
