Краткое содержание страницы № 1
Basic Useful
Introduction Quick Start Setup Connections Appendix
Operation Features
MULTIMEDIA PROJECTOR
MODEL
XR-40X
XR-30X
XR-30S
OPERATION MANUAL
Краткое содержание страницы № 2
IMPORTANT • For your assistance in reporting the loss Model No.: or theft of your Projector, please record the Model and Serial Number located on the bottom of the projector and retain this Serial No.: information. • Before recycling the packaging, please ensure that you have checked the con- tents of the carton thoroughly against the list of “Supplied accessories” on page 10. ii
Краткое содержание страницы № 3
SPECIAL NOTE FOR USERS IN THE U.K. The mains lead of this product is fitted with a non-rewireable (moulded) plug incorporat- ing a 10A fuse. Should the fuse need to be replaced, a BSI or ASTA approved BS 1362 fuse marked or and of the same rating as above, which is also indicated on the pin face of the plug, must be used. Always refit the fuse cover after replacing the fuse. Never use the plug without the fuse cover fitted. In the unlikely event of the socket outlet in your home not being comp
Краткое содержание страницы № 4
The supplied CD-ROM contains operation instructions in English, German, French, Swedish, Spanish, Italian, Dutch, Portuguese, Chinese and Korean. Carefully read through the operation instructions before operating the projector. Die mitgelieferte CD-ROM enthält Bedienungsanleitungen in Englisch, Deutsch, Französisch, Schwedisch, Spanisch, Italienisch, Niederländisch, Portugiesisch, Chinesisch und Koreanisch. Bitte lesen Sie die Bedienungsanleitung vor der Verwendung des Projektors sorgfältig durc
Краткое содержание страницы № 5
Introduction Before using the projector, please read this operation manual carefully. Introduction ENGLISH There are two important reasons for prompt warranty registration of your new SHARP Projector, using the REGISTRATION CARD packed with the projector. 1. WARRANTY This is to assure that you immediately receive the full benefit of the parts, service and labor warranty applicable to your purchase. 2. CONSUMER PRODUCT SAFETY ACT To ensure that you will promptly receive any safety notification of
Краткое содержание страницы № 6
INFORMATION This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the operation manual, may cause harmful interference to radio communications. However, there is no guarantee that
Краткое содержание страницы № 7
Introduction Useful Features How to Read this Operation Manual ■ The specifications are slightly different, depending on the model. However, you can connect and operate all models in the same manner. ••• In this operation manual, the illustration and the screen display are simplified for explanation, and •• may differ slightly from the actual display. Using the Menu Screen ENTER button Adjustment buttons (P/R/O/Q) MENU/HELP button ENTER button Adjustment buttons (P/R/O/Q) RETURN button Buttons u
Краткое содержание страницы № 8
Contents Preparing Introduction Setup How to Read this Operation Manual .... 3 Setting up the Projector ...................... 18 Contents ............................................... 4 Setting up the Projector ....................... 18 Standard Setup (Front Projection) ....... 18 IMPORTANT SAFEGUARDS ............... 6 Ceiling-mount Setup ............................ 18 How to Access the PDF Operation Projection (PRJ) Mode ......................... 19 Manuals ................................
Краткое содержание страницы № 9
Introduction Reference Connecting Pin Assignments ............. 53 Appendix RS-232C Specifications and Maintenance ....................................... 47 Command Settings ........................... 55 Maintenance Indicators ...................... 48 Computer Compatibility Chart ............ 60 Regarding the Lamp ........................... 50 Troubleshooting .................................. 61 Lamp ..................................................... 50 For SHARP Assistance .............
Краткое содержание страницы № 10
IMPORTANT SAFEGUARDS CAUTION: Please read all of these instructions before you operate this product and save these instructions for later use. Electrical energy can perform many useful functions. This product has been engineered and manufactured to assure your personal safety. BUT IMPROPER USE CAN RESULT IN POTENTIAL ELECTRICAL SHOCK OR FIRE HAZARDS. In order not to defeat the safeguards incorporated in this product, observe the following basic rules for its installation, use and servicing. 1. R
Краткое содержание страницы № 11
Introduction 15. Overloading 19. Replacement Parts Do not overload wall outlets, extension cords, or When replacement parts are required, be sure integral convenience receptacles as this can the service technician has used replacement result in a risk of fire or electric shock. parts specified by the manufacturer or have the same characteristics as the original part. 16. Object and Liquid Entry Unauthorized substitutions may result in fire, Never push objects of any kind into this product electr
Краткое содержание страницы № 12
Observe the following safeguards when setting up your projector. Caution concerning the lamp unit When using the projector in high-altitude ■ Potential hazard of glass par- areas such as mountains (at altitudes of ticles if lamp ruptures. In case approximately 1,500 meters (4,900 feet) of lamp rupture, contact your or more) nearest Sharp Authorized ■ When you use the projector in high-altitude Projector Dealer or Service areas with thin air, set “Fan Mode” to “High”. Center for replacement. Negl
Краткое содержание страницы № 13
Introduction Caution regarding usage of the projector Using the projector in other countries ■ If you are not to use the projector for a long ■ The power supply voltage and the shape of time or before moving the projector, make the plug may vary depending on the region certain you unplug the power cord from the or country you are using the projector in. wall outlet, and disconnect any other cables When using the projector overseas, make connected to it. sure you use an appropriate power cord for
Краткое содержание страницы № 14
Accessories Supplied accessories Two R-6 batteries RGB cable Lens cap (attached) (“AA” size, UM/SUM-3, (10' (3.0 m)) HP-7 or similar) Remote control Power cord* (1) (2) (3) (4) For U.S. and For Europe, For U.K. and For Australia, New Canada, etc. except U.K. Singapore Zealand and Oceania (6' (1.8 m)) (6' (1.8 m)) (6' (1.8 m)) (6' (1.8 m)) * Use the power cord that corresponds to the w
Краткое содержание страницы № 15
Introduction Part Names and Functions Numbers in Z refer to the main pages in this operation manual where the topic is explained. Projector Top View Power Lamp indicator 25, 48 25, 48 indicator Temperature warning 48 indicator STANDBY/ON ECO+QUIET button 25 32 button For lowering the noise For turning the of the cooling fan and power on and extending the lamp life. putting the VOL (Volume) buttons projector into 29 (–O/Q+) standby mode. For adjusting the ENTER button speaker sound level. 37 For
Краткое содержание страницы № 16
Part Names and Functions (Continued) Numbers in Z refer to the main pages in this operation manual where the topic is explained. Rear View Terminals AUDIO 1 input terminal S-VIDEO input terminal 22 23 Terminal for connecting video equipment with an DVI-D input terminal 21 S-video terminal. Terminal for DVI 22 digital RGB and RS-232C terminal 24 digital component Terminal for signals. controlling the projector using a COMPUTER/ 21 computer. COMPONENT 22 input terminal USB terminal 34 Terminal for
Краткое содержание страницы № 17
Introduction STANDBY button ON button 25 25 For putting the For turning the projector into the power on. standby mode. FREEZE button 33 COMPUTER, DVI, 29 For freezing images. S-VIDEO, VIDEO buttons 29 AV MUTE button For switching to the For temporarily respective input displaying a black modes. screen and turning off the sound. BREAK TIMER 32 button VOL +/– (Volume) 29 For displaying the buttons break time. For adjusting the speaker sound level. PAGE UP/PAGE 34 DOWN buttons 32 SPOT button Same a
Краткое содержание страницы № 18
Part Names and Functions (Continued) Inserting the Batteries Pull down the tab on the cover and remove the cover 1 towards the direction of the arrow. Insert the batteries. 2 • Insert the batteries making sure the polarities correctly match the m and n marks inside the battery compartment. Insert the lower tab of the cover into the opening, 3 and lower the cover until it clicks in place. Incorrect use of the batteries may cause them to leak or explode. Please follow the precautions below. Cautio
Краткое содержание страницы № 19
Introduction Usable Range Remote control sensor The remote control can be used to control the projector within the ranges shown in the illustration. Note • The signal from the remote control can be re- flected off a screen for easy operation. How- ever, the effective distance of the signal may 30° differ depending on the screen material. When using the remote control • Ensure that you do not drop it or expose it to moisture or high temperature. 23n (7 m) 30° • The remote control may malfunction
Краткое содержание страницы № 20
Quick Start This section shows the basic operation (projector connecting with the computer). For details, see the page described below for each step. Setup and Projection In this section, connection of the projector and the computer is explained using one example. 3 STANDBY/ON 8 STANDBY button 8 button INPUT buttons 6 ON button 3 ENTER button 4 COMPUTER button 6 Adjustment buttons 5 (P/R/O/Q) KEYSTONE 5 button Zoom ring 4 ENTER button 4 Focus ring 4 Adjustment buttons 5 (P/R/O/Q) KEYSTONE button
