Краткое содержание страницы № 1
Connections
Introduction Quick Start Setup Useful Features Appendix
Basic Operation
OPERATION MANUAL
MODEL
XG-PH70X
(Standard zoom lens attached)
XG-PH70X-N
(No lens attached)
MULTIMEDIA PROJECTOR
Краткое содержание страницы № 2
IMPORTANT ••••• For your assistance in reporting the loss or theft of your Projector, please record Model No.: the Model and Serial Numbers located on the bottom of the projector and retain this information. Serial No.: ••••• Before recycling the packaging, please ensure that you have checked the contents of the carton thoroughly against the list of “Supplied accessories” on page 11. SPECIAL NOTE FOR USERS IN THE U.K. The mains lead of this product is fitted with a non-rewireable (moulded) plug
Краткое содержание страницы № 3
Introduction Before using the projector, please read this operation manual carefully. Introduction ENGLISH There are two important reasons for prompt warranty registration of your new SHARP Projector, using the REGISTRATION CARD packed with the projector. 1. WARRANTY This is to assure that you immediately receive the full benefit of the parts, service and labor warranty applicable to your purchase. 2. CONSUMER PRODUCT SAFETY ACT To ensure that you will promptly receive any safety notification of
Краткое содержание страницы № 4
WARNING: The cooling fan in this projector continues to run for about 90 seconds after the projector enters the standby mode. During normal operation, when putting the projector into standby mode always use the STANDBY button on the projector or on the remote control. DURING NORMAL OPERATION, NEVER TURN THE PROJECTOR OFF BY DISCONNECTING THE POWER CORD. FAILURE TO OBSERVE THIS WILL RESULT IN PREMATURE LAMP FAILURE. PRODUCT DISPOSAL This projector utilizes tin-lead solder, and a pressurized lamp
Краткое содержание страницы № 5
Introduction How to Read This Operation Manual ••••• In this operation manual, the illustrations and on-screen displays are simplified for explana- tion. This may differ from the actual on-screen display. Using the Menu Screen The menu can be operated to achieve two functions, adjustments and settings. (For setting the menu items, see pages 58 and 59. ) Mouse/ adjustment ENTER button button ('/"/\/|) MENU button Buttons used in this MENU button ENTER Buttons used in this button UNDO button ope
Краткое содержание страницы № 6
Contents Preparing Introduction How to Read This Operation Manual ............ 3 Using the Remote Control ........................... 17 Usable Range .................................................... 17 Contents.......................................................... 4 Inserting the Batteries ....................................... 17 How to Access the PDF Operation Manuals..... 7 Using the Remote Control with a Signal Cable .. 18 IMPORTANT SAFEGUARDS .......................... 8 Switching
Краткое содержание страницы № 7
Introduction Using Basic Operation Adjusting the Volume ......................................... 46 Turning the Projector On/Off ....................... 37 Turning Off the Sound Temporarily .................... 46 Image Projection .......................................... 38 Displaying an Enlarged Portion of an Image ....... 46 Shifting the Lens… ............................................ 38 Freezing a Moving Image .................................. 47 Using the Adjustment Feet .............
Краткое содержание страницы № 8
Contents Reference Appendix Maintenance ................................................. 93 Specifications ............................................. 105 Maintenance Indicators ............................... 94 Glossary ...................................................... 106 Regarding the Lamp .................................... 96 Index ............................................................ 107 Lamp ................................................................. 96 Caution Conc
Краткое содержание страницы № 9
Introduction How to Access the PDF Operation Manuals PDF operation manuals in several languages are included in the CD-ROM, so that you can ® ® work with the projector. To utilize these manuals, you need to install Adobe Reader on your ® ® computer (Windows or Macintosh ). ® ® Please download Adobe Reader from the Internet (http://www.adobe.com). Accessing the PDF manuals ® ® For Windows : For Macintosh : 1 Insert the CD-ROM in the CD-ROM drive. 1 Insert the CD-ROM in the CD-ROM drive. 2 Double
Краткое содержание страницы № 10
IMPORTANT SAFEGUARDS CAUTION: Please read all of these instructions before you operate this product and save these instructions for later use. Electrical energy can perform many useful functions. This product has been engineered and manufactured to assure your personal safety. BUT IMPROPER USE CAN RESULT IN POTENTIAL ELECTRICAL SHOCK OR FIRE HAZARDS. In order not to defeat the safeguards incorporated in this product, observe the following basic rules for its installation, use and servicing. 1. R
Краткое содержание страницы № 11
Introduction Ensure that you read the following safeguards when setting up your projector. Caution concerning the lamp unit The projector may be safely tilted to a ■ Potential hazard of glass particles if lamp rup- maximum angle of 9 degrees. tures. In case of lamp rupture, contact your ■ Placement should be within 9 degrees of nearest Sharp Authorized Projector Dealer horizontal. or Service Center for replacement. See “Re- If you have application requiring tilt angle placing the Lamp” on page 9
Краткое содержание страницы № 12
IMPORTANT SAFEGUARDS Do not block the intake and exhaust Using the projector in other countries vents. ■ The power supply voltage and the shape of 13 ■ Allow at least 11 /16 inches (30 cm) of space the plug may vary depending on the region between the exhaust vent and the nearest or country you are using the projector in. wall or obstruction. When using the projector overseas, make ■ Ensure that the intake vents and the exhaust sure you use an appropriate power cord for vent are not obstructed.
Краткое содержание страницы № 13
Introduction Accessories Supplied accessories Remote control Two R-6 batteries 9NK5041808700 (“AA” size, UM/SUM-3, HP-7 or similar) Power cord* (1) (4) (2) (3) For U.S., Canada, etc. For Europe, except U.K. For U.K., Hong Kong For Australia, New (6' (1.8 m)) (6' (1.8 m)) and Singapore Zealand and Oceania 9NK3090204900 9NK3090152700 (6' (1.8 m)) (6' (1.8 m)) 9NK3090152900 9NK3090152600 *Use the power cord that corresponds to the wall outlet in your country. RGB cable Remote mouse receiver Cap for
Краткое содержание страницы № 14
Accessories Optional lenses ■ Lens Projection distance for 100" screen size Fixed wide lens (× 0.8) AN-PH10EX 5'4" (1.6 m) Wide-zoom lens (× 1.5 – 1.8) AN-PH20EZ 10' – 12' (3.0 m – 3.7 m) Standard zoom lens (× 1.8 – 2.2) AN-PH31EZ 12' – 14'8" (3.7 m – 4.5 m) (attached to XG-PH70X) Tele-zoom lens (× 2.25 – 3.00) AN-PH40EZ 15' – 20' (4.6 m – 6.1 m) Tele-zoom lens (× 3.0 – 4.5) AN-PH50EZ 20' – 30' (6.1 m – 9.1 m) Tele-zoom lens (× 4.5 –7.0) AN-PH60EZ 30' – 46'8" (9.1 m – 14.2 m) No lens is attached
Краткое содержание страницы № 15
Introduction Part Names and Functions Numbers in refer to the main pages in this operation manual where the topic is explained. Projector Top View Power indicator 14 14·94 Lamp indicator 1 ON button 37 Lamp indicator 2 14·94 For turning the power on. Temperature warning 14·94 STANDBY button 37 indicator For putting the projector into standby mode. 46 Volume buttons For adjusting the speaker ZOOM button 40 sound level. For adjusting the projected 45 INPUT 1, 2, 3 button image size. For switc
Краткое содержание страницы № 16
Part Names and Functions About the Indicators on the Projector Power indicator ... Red on Normal (Standby) ... Green on Normal (Power on) ... Red blinks The intake vent cover is open. (See page 93.) Lamp indicators 1, 2 ... Green on Normal ... Green blinks The lamp is warming up. ... Red on The lamp has been shut down abnormally or needs to be changed. (See pages 94 and 95.) Temperature warning indicator ... Off Normal ... Red blinks/on The internal temperature is abnormally high. (See
Краткое содержание страницы № 17
Introduction Numbers in refer to the main pages in this operation manual where the topic is explained. Projector (Side View) Terminals Refer to “INPUT/OUTPUT Terminals and Connectable Main Equipment” on page 24. INPUT 1 terminal 27 29 INPUT 3 terminal Terminal for computer RGB Terminal for DVI digital RGB and component signals. and digital component signals. AUDIO input (1) terminal 27 OUTPUT (FOR INPUT 1, 2) 36 Audio input terminal for terminal INPUT 1. Output terminal for computer RGB an
Краткое содержание страницы № 18
Part Names and Functions Numbers in refer to the main pages in this operation manual where the topic is explained. Remote Control FOCUS buttons 40 ON button 37 For bringing the projected image For turning the power on. into focus. 18 ADJ./MOUSE switch STANDBY button For switching the remote control 37 For putting the projector into modes. standby mode. 39 H & V LENS SHIFT button For shifting the lens horizontally ZOOM buttons 40 and vertically. For adjusting the projected image size. MENU
Краткое содержание страницы № 19
Introduction Using the Remote Control Front View Remote control sensor Usable Range 30° The remote control can be used to control the projector within the ranges shown in the il- 30° lustration. Remote control signal transmitters 30° 23' (7 m) Note • The signal from the remote control can be re- Remote control flected off a screen for easy operation. How- ever, the effective distance of the signal may Rear View differ depending on the screen material. Remote control sensor 30° When using the rem
Краткое содержание страницы № 20
Using the Remote Control Using the Remote Control with a Signal Cable When the signals from the remote control cannot be reached due to the positioning of the projector, use a ø3.5 mm minijack cable to connect the remote control to the projector. Now you can control the projector with the remote control. Remote control Side view To WIRED REMOTE terminal To WIRED R/C JACK ø3.5 mm minijack cable (commercially available or available as Sharp service part QCNWGA038WJPZ) Note • The wireless remote f
