Краткое содержание страницы № 1
Basic Useful
Introduction Easy Start Setup Connections Appendix
Operation Features
DATA PROJECTOR
MODEL
PG-D3510X
PG-D3010X
PG-D2710X
OPERATION MANUAL
Краткое содержание страницы № 2
IMPORTANT � For your assistance in reporting the loss or theft of your Projector, please record Model No.: the Model and Serial Number located on the bottom of the projector and retain this Serial No.: information. � Before recycling the packag ing, please ensure that you have checked the con- tents of the carton thoroughly against the list of “Supplied accessories” on page 11. ii
Краткое содержание страницы № 3
SPECIAL NOTE FOR USERS IN THE U.K. The mains lead of this product is fi tted with a non-rewireable (moulded) plug incorporating a 10A fuse. Should the fuse need to be replaced, a BSI or ASTA approved BS 1362 fuse marked or and of the same rating as above, which is also indicated on the pin face of the plug, must be used. Always refi t the fuse cover after replacing the fuse. Never use the plug without the fuse cover fi tted. In the unlikely event of the socket outlet in your home not being co
Краткое содержание страницы № 4
The supplied CD-ROM contains operation instructions in English, German, French, Spanish, Italian, Dutch, Swedish, Portuguese, Chinese, Korean and Arabic. Carefully read through the operation instructions before operating the projector. Die mitgelieferte CD-ROM enthält Bedienungsanleitungen in Englisch, Deutsch, Französisch, Spanisch, Italienisch, Niederländisch, Schwedisch, Portugiesisch, Chinesisch, Koreanisch und Arabisch. Bitte lesen Sie die Bedienungsanleitung vor der Verwendung des Proj
Краткое содержание страницы № 5
Introduction Before using the projector, please read this operation manual carefully. Introduction ENGLISH There are two important reasons for prompt warranty registration of your new SHARP Project or, using the REGISTRATION CARD packed with the projector. 1. WARRANTY This is to assure that you immediately receive the full benefi t of the parts, service and labor warranty applicable to your purchase. 2. CONSUMER PRODUCT SAFETY ACT To ensure that you will promptl
Краткое содержание страницы № 6
INFORMATION This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the operation manual, may cause harmful interference to radio communications.
Краткое содержание страницы № 7
Introduction Useful Features How to Read this Operation Manual ■ The specifi cations are slightly different, depending on the model. However, you can connect and operate all models in the same manner. � In this operation manual, the illustration and the screen display are simplifi ed for explanation, and may differ slightly from the actual display. Using the Menu Screen Select from the Quick Start Menu, which is a collection of the most frequently used functions, or the Complete Menu, w
Краткое содержание страницы № 8
Contents Preparing Displaying the Black Screen and Introduction Turning Off the Sound Temporarily ....... 30 Resize Mode .......................................... 31 How to Read this Operation Manual ......3 Contents .................................................4 IMPORTANT SAFEGUARDS ..................6 Useful Features How to Access the PDF Operation Operating with the Remote Control......33 Manuals ..............................................10 Displaying and Setting the Accessories .
Краткое содержание страницы № 9
Introduction Adjusting the Projector Function (“PRJ - ADJ1/2” Menu) ......................50 Auto Sync (Auto Sync Adjustment) ......... 50 Auto Power Off Function ........................ 50 Auto Restart Function ............................. 50 Speaker Setting ...................................... 50 Selecting the Transmission Speed (RS-232C) ........................................... 50 Fan Mode Setting ................................... 51 System Lock Function ...........................
Краткое содержание страницы № 10
IMPORTANT SAFEGUARDS CAUTION: Please read all of these instructions before you operate this product and save these instructions for later use. Electrical energy can perform many useful functions. This product has been engineered and manufactured to assure your personal safety. BUT IMPROPER USE CAN RESULT IN POTENTIAL ELECTRICAL SHOCK OR FIRE HAZARDS. In order not to defeat the safeguards incorporated in this product, observe the following basic rules for its installation, use and servicing.
Краткое содержание страницы № 11
Introduction 15. Overloading 19. Replacement Parts Do not overload wall outlets, extension cords, When replacement parts are required, be or integral convenience receptacles as this sure the service technician has used can result in a risk of fi re or electric shock. replace ment parts specifi ed by the manufacturer or have the same 16. Object and Liquid Entry characteristics as the original part. Never push objects of any kind into this Unauthorized substitutions may result in product thro
Краткое содержание страницы № 12
Observe the following safeguards when setting up your projector. Caution concerning the lamp unit When using the projector in high- ■ Potential hazard of glass particles if lamp altitude areas such as mountains (at ruptures. In case of lamp rupture, contact altitudes of approximately 1,500 your nearest Sharp Authorized Projector meters (4,900 feet) or more) Dealer or Service Center ■ When you use the projector in high-altitude for replacement. areas with thin air, set “Fan Mode” to See
Краткое содержание страницы № 13
Introduction Caution regarding usage of the projector Using the projector in other countries ■ If you are not to use the projector for a long ■ The power supply voltage and the shape of time or before moving the projector, make the plug may vary depending on the region certain you unplug the power cord from the or country you are using the projector in. wall outlet, and disconnect any other When using the projector overseas, make cables connected to it. sure you use an appropriate power cord
Краткое содержание страницы № 14
How to Access the PDF Operation Manuals PDF operation manuals in several languages are included in the CD-ROM. To ® ® utilize these manuals, you need to install Adobe Reader on your computer ® ® (Windows or Macintosh ). ® ® Please download Adobe Reader from the Internet (http://www.adobe.com). Accessing the PDF Manuals ® ® For Windows : For Macintosh : 1 Insert the CD-ROM in the CD-ROM drive. 1 Insert the CD-ROM in the CD-ROM drive. 2 Double click the “My Computer” icon. 2 Double click the “CD
Краткое содержание страницы № 15
Introduction Accessories Supplied accessories Two R-6 batteries (“AA” size, UM/SUM-3, RGB cable HP-7 or similar) (10' (3.0 m)) Remote control DIN-D-sub RS-232C adaptor 57 (5 /64" (15 cm)) Storage case Power cord* (1) (2) (3) (4) For U.S. and For Europe, For U.K. and For Australia, New Canada, etc. except U.K. Singapore Zealand and Oceania (6' (1.8 m)) (6' (1.8 m)) (6' (1.8 m)) (6' (1.8 m))
Краткое содержание страницы № 16
Part Names and Functions Numbers in Z refer to the main pages in this operation manual where the topic is explained. 10 10 11 11 12 12 16 16 1 1 13 13 2 2 17 17 14 14 3 3 15 15 18 18 19 19 45 45 66 7 7 8 8 9 9 Front View Top View 1 Exhaust vent 57 10 Temperature warning indicator 58 2 Zoom ring 28 11 Lamp indicator 58 For enlarging/reducing the picture. 12 Power indicator 58 3 Focus ring 27 13 STANDBY/ON button 26 For adjusting the focus. Fo r turning the power on and puttin
Краткое содержание страницы № 17
Introduction 12 12 33 44 55 66 77 88 9 9 10 10 14 14 11 11 12 12 13 13 Rear View (Terminals) 6 AUDIO 1 input terminal 1 LAN terminal 25 23 Terminal for controlling the projector using a 7 COMPUTER/COMPONENT 1 input computer via network. terminal 21, 22 Terminal for computer RGB and 2 RS-232C terminal 24 component signals. Terminal for controlling the projector using a computer. 8 S-VIDEO input terminal 22 Terminal for connecting video equipment 3 USB terminal 35 with an S-vide
Краткое содержание страницы № 18
Part Names and Functions (Continued) Numbers in Z refer to the main pages in this operation manual where the topic is explained. 1 9 L-CLICK/EFFECT button 35, 33 � For the Left click when with the USB connection (using a USB cable or the optional 2 remote receiver). � For changing the pointer or spot area. 14 3 10 KEYSTONE button 29 For entering the Keystone Correction 4 15 mode. 34, 50 11 AUTO SYNC button 5 16 For automatically adjusting images when 6 connected to a computer. 17 7 12 FUNC
Краткое содержание страницы № 19
Introduction Inserting the Batteries Pull down the tab on the cover and remove the 1 1 cover towards the direction of the arrow. Inser t the batteries. 2 2 � Insert the batteries making sure the polarities correctly match the m and n marks inside the battery compartment. Insert the lower tab of the cover into the opening, 3 3 and lower the cover until it clicks in place. Incorrect use of the batteries may cause them to leak or explode. Please follow the precautions below Caution � Dange
Краткое содержание страницы № 20
Easy Start This section shows the basic operation (projector connecting with the computer). For details, see the page described below for each step. Setup and Projection In this section, connection of the projector and the computer is explained using one example. 3 STANDBY/ON STANDBY button button 8 8 ON button 3 O/Q buttons 6 INPUT buttons 6 INPUT buttons 6 Adjustment 5 buttons Zoom ring 4 6 (P/R/O/Q) Focus ring 4 KEYSTONE button 5 HEIGHT 4 ADJUST lever _P. 18 1. Place the projector facin
