Руководство по эксплуатации JVC DLA-RS55

Краткое содержание страницы № 1

Firmware Update Manual (Ver.1.1)
for DLA-RS55

This manual describes how to update the firmware for the DLA-RS55 model.
**CAUTION** Do not unplug unit while firmware is being updated.
Please carry out the update in the order shown below:
１. Install Software
２. Projector LAN Settings
３. Projector Software Update
１. Install Software
First download the projector update software from the JVC website to your desktop on your computer.
This example uses the DLA-X70R

Краткое содержание страницы № 2

(4) The dialog box shown on the right will appear. Click the [Next] button with the destination unchanged. （5 ）The dialog box shown on the right will appear. Click the [Next] button. （6) The dialog box shown on the right will appear. Click the [Install] button. Please wait until the installations is complete. (7) The dialog box shown on the right will appear. After installation is complete, click the [Finish] button to exit the wizard.

Краткое содержание страницы № 3

2. Projector LAN Settings (1) Connect the projector to a PC with a LAN cable. (2) Connect the power cord to the projector and turn on. (3) Set "Communication Terminal" under the "Function" tab in the menu to "LAN". (4) Open "Network" item under the "Function" tab in the menu. (5) Projector Network Settings Set the "DHCP Client" to "Off". Set the"IP Address" of projector to an address different from that of the PC. Recommended No. ： PC ［ 192 168 0 1 ］ 　 　 　 　 Projector 　 　

Краткое содержание страницы № 4

3. Projector Software Update The software is accepted when the projector in STAND-BY Mode. For example DLA-X70R (1) Click "Start" on PC →Select "ILA-FPJ X70R" from "ALL programs" This will start the ILA-FPJ Updater. Note: Press [Update Firmware] Set IP Address to projector's IP address if required. If a Windows Firewall warning message appears, please select "Unblock". (2) The software update will start. Please wait until it is finished. Caution: Do not unplug the cable while the update is

Краткое содержание страницы № 5

After the progress bar reaches 100%, the three LEDs will begin flashing. Please continue to wait. After a while, the STAND-BY light will light Red. The others will be off. Close Up LEDs (3) The update has been completed. Close the update program. (4) After updating, remove the power cable from the projector, wait until all lights go out, then reconnect power. Close Up LEDs Please check that the software version: 28.056 has been updated after finishing the update. The version number is availab