Краткое содержание страницы № 1
Radio-Sync, Constant Color
POWERLIGHT!
Operator’s Manual
Solair! Constant Color PLR500DR
Solair! Constant Color PLR1000DR
Voltage Smart" Solair! PLRX500DR
Voltage Smart" Solair! PLRX1000DR
&
Remote Studio Control Accessories
1
Краткое содержание страницы № 2
OPERATOR MANUAL FOR MONOLIGHTS Solair! Radio-Sync, Constant Color PLR500DR &PLR1000DR Voltage Smart#, Radio-Sync, Constant Color PLRX500DR & PLRX1000DR INFRARED ACCESSORIES PLCPTR-2 Computer Control Software. PLDIR-2 Side display & IR receiver. PLIRC-1 Hand held remote control. Thank you for selecting the Photogenic Professional PowerLight Solair brand, Radio-Sync, Constant-Color series. The Solair Radio-Sync, Constant-Color series incorporates the newest electronic technology provid
Краткое содержание страницы № 3
SAFETY PRECAUTIONS Despite the measures that have been taken to make electronic flash equipment safe, it must be recognized that high voltages and high temperatures do exist within the power supply / lighting unit. Certain precautions must be observed in handling the unit. Contact with internal high voltage may result in severe injury or death. 1. Before installing or removing the flashtube and modeling lamp, be sure this appliance is turned off, cooled and unplugged from AC power source. 2. Do
Краткое содержание страницы № 4
The unit is shipped with the modeling lamp and flashtube not installed. While installing the modeling lamp and flashtube (with glove or clean cloth to protect the hand and tube) be sure they are properly inserted and tight to avoid arcing and failure of the socket contacts during operation. Do not touch the glass tubes with bare hands, as normal body oils will shorten the bulb’s life. Always use a clean cloth or wear gloves to protect your hand from glass breakage and heat. The 7 _ inch reflec
Краткое содержание страницы № 5
DIGITAL CONTROL PANEL AND BASIC OPERATION: Power Input: The power required to operate the Solair Radio-Sync, Constant-Color PLR500DR or PLR1000DR is 105 to 125 volts AC, 60 Hz, 5 Amp. The power cord has a 125V, 15 Amp. rating. [The Voltage Smart Solair Radio-Sync, Constant-Color PLRX500DR or PLRX1000DR is rated 90 to 250 volts AC, 50/60 Hz, 3.5 Amp and has a 230V power cord with a German/European plug. These Voltage Smart units have no recharge line current surge.] Replacement cords or exten
Краткое содержание страницы № 6
Functional Operation Solair! Radio-Sync, Constant-Color PLR500DR & PLR1000DR Voltage Smart,# Radio-Sync, Constant-Color PLRX500DR & PLRX1000DR Power Switch: The power switch controls the AC power to both the modeling and flash circuits. You have the option to turn-off the modeling circuit independently. Flash Power: When the power is turned on the red LED is illuminated. You adjust the PowerLight Flash power settings by pressing the 1/2 or 1/10 f-stops UP/DOWN arrow buttons. The watt second se
Краткое содержание страницы № 7
The Solair Radio-Sync, Constant-Color PLR500DR & PLRX500DR models are fully charged when the READY lamp is on. Lowest power (3.9ws) charge time is a maximum of .5 seconds and at full power charge (500 ws) time is a maximum of 1.5 seconds. The unit may be flashed before fully charged. When adjusting flash power settings downward the units will bleed stored power until the lowered setting is reached, the green READY light will then be re-illuminated. Audible READY: The Solair models also have a
Краткое содержание страницы № 8
After the trigger cord is properly connected, check the synchronization with a film camera. Adjust the lighting unit to same height as the camera lens and face the lights into the lens. The lens aperture should be open to its fullest extent and set on “X” or “zero” delay. Remove the camera back. It is best to perform this test with the modeling lamps turned off. While looking at the lens through the back of a film camera, operate the shutter. A few sheets of white paper in front of the lens
Краткое содержание страницы № 9
Photocell/Photo Slave: The sensor is built-in and can be shut off by plugging in the sync cord. Flash Power Bracketing: Bracketing refers to taking up to three (3) exposures in a sequence with different flash intensities, either additional watt seconds or fewer watt seconds, from the displayed or selected “primary” base intensity. The Solair units enable you to set the base flash power and then one high and one low bracketing values. Once the setting(s) have been pre-set, a sequence of power l
Краткое содержание страницы № 10
Color Temperature Consistent and Constant The problem: With the rare exception of units costing many thousands of dollars, flash lighting packs, up to now, do not control the color temperature of the light. The color temperature typically decreases by over 100 degrees Kelvin for every f-stop of power reduction. Over a 6-stop adjustment range, this results in a color temperature decrease of over 600K. Even units that have a small 3- stop range can produce significant color shifts of over 300 de
Краткое содержание страницы № 11
power point is commonly used in engineering and serves the purpose of reporting the bandwidth of the flash duration, but the graph below clearly shows that a power point measurement does not truly report the total flash duration. The clock doesn’t start running until the flash discharge reaches 50% of its peak, and stops when it falls below 50%. Since the color temperature of the flash varies over time (more blue in the beginning and more red towards the tail [pgs 48-60]), it is important that
Краткое содержание страницы № 12
Reciprocity Explained -Excerpts taken from Kodak TECHNICAL PUBLICATION DATA I FILM E31- July 2002 The reciprocity law states that the intensity of light falling on a photographic film multiplied by the exposure time equals the total amount of exposure. Intensity x Time = Exposure This means, for example, that an exposure of f 16 at 1/60 second is equivalent to an exposure of f 11 at 1/125 second. In either combination of settings, the same total amount of light reaches the film. The reciprocit
Краткое содержание страницы № 13
LONG-EXPOSURE EFFECTS Under low-light conditions, you may have to extend your exposure times to a point of significant speed loss. With black-and-white films, the effect of this speed loss is partially offset by wide exposure latitude. Most color films require more than the normally calculated exposure when the lighting is unusually low. Also, the sensitivity differences between the many layers of color films can cause a color-balance shift, which means that you will sometimes need to use colo
Краткое содержание страницы № 14
OPERATIONAL PARAMETERS Solair! Radio-Sync, Constant-Color PLR500DR Voltage Smart# Radio-Sync, Constant Color PLRX500DR Flashing Rate: The unit recharges quickly, as indicated by the READY light on the control panel. A quick series of flashes can be obtained within the limits of the recharge time. Continuous rapid flashing, however, can overheat and damage the flashtube and internal parts. The maximum recommended rate of flashing would depend upon the power level being used and the amount of o
Краткое содержание страницы № 15
SPECIFICATIONS Solair! Radio-Sync, Constant-Color PLR500DR Voltage Smart# Radio-Sync, Constant Color PLRX500DR General: Flash Power….........................................………...3.9 to 500 watt-seconds. Maximum (8 f-stops) Flash Duration….........................................……...1/280 second at Full 1/5800 second at 1/128 Reciprocity……………………………………….Excellent, no filters required Recycling time…..................
Краткое содержание страницы № 16
OPERATIONAL PARAMETERS Solair! Radio-Sync, Constant-Color PLR1000DR Voltage Smart# Radio-Sync, Constant Color PLRX1000DR Flashing Rate: The unit recharges quickly, as indicated by the READY light on the control panel. A quick series of flashes can be obtained within the limits of the recharge time. Continuous rapid flashing, however, can overheat and damage the flashtube and internal parts. The maximum recommended rate of flashing would depend upon the power level being used and the amount of
Краткое содержание страницы № 17
SPECIFICATIONS Solair! Radio-Sync, Constant-Color PLR1000DR Voltage Smart# Radio-Sync, Constant Color PLRX1000DR General: Flash Power............................................…………7.8 to 1000 watt-seconds maximum. (8 f-stops) Flash Duration........................................…………1/250 second at Full 1/4000 second at 1/128 Reciprocity………………………………….........Excellent, no filters required Recycling time..............................................……..0.8 to 3.0 seconds Power Control...........
Краткое содержание страницы № 18
ADVANCED POWERLIGHT FEATURES Solair! Radio-Sync, Constant-Color PLR500DR & PLR1000DR Voltage Smart# Radio-Sync, Constant Color PLRX500DR & PLRX1000DR Automatic Discharge Each time the AC line power is disconnected or switched off, the unit will automatically flash-dump most of the stored power, and then discharge by resistor the remainder of the stored power. This removes all of the flash capacitor charge to prolong the life of the unit and is a much safer condition for storage, for transporting
Краткое содержание страницы № 19
During the “ir” display if you then press either of the 1/10 buttons you will display “rado” pressing the 1/10 button again will display a studio “Su” and number 1 through 4. Studio numbers are assigned with 1/10 buttons. NOTE: the “rado” is currently an internal-only system and should not be used if you intend to use infrared controls. To close “rado”, press the 1/10 button again until the display reads “ir” then press the _ UP button again. The next display will be “Un 1” which is your ligh
Краткое содержание страницы № 20
Advanced Series Accessories Solair!, Voltage Smart# & PL2 series PLDIR-2 Remote digital display and Infrared receiver. (Must be used with PLIRC controller) The PLDIR-2 is a digital display to enhance visibility and to receive infrared signals to control the functions of the Solair Constant Color, Radio-Sync PowerLights. It displays Flash power, Modeling lamp power and unit number. It has a green READY indicator and a BI-color indicator for Flash or Model. Behind a small window is an infrared
