Краткое содержание страницы № 1
OWNER’S MANUAL
Pro-1200W, Pro-1600W
Pro-2000W, Pro-2500W
Pro-3000W
POWER INVERTERS
Краткое содержание страницы № 2
FEATURES FEATURES 1. Three 110 AC Outlets • Overload Protection. The inverter will turn itself off when the continuous draw or the surge draw of the 2. Remote Operation Jack equipment being operated exceeds the maximum The inverter is designed to be operated from a power rating for the inverter. remote location via a WHISTLER Remote Control • Thermal Protection. The inverter will turn itself off Switch (P/N Pro-RS01) which plugs into this socket. when the internal temperature exceeds safe de
Краткое содержание страницы № 3
IMPORTANT INFORMATION INVERTER INFORMATION Getting Started Power equipment and appliances which operate with motors or tubes require an initial surge of power to get them up About Your New Whistler Inverter. and running. This power surge is referred to as the "starting This manual will provide you with directions for the safe load" or "peak load." (By comparison, electrical devices such and efficient operation of your Whistle Power Inverter. as standard light bulbs do not require a large start
Краткое содержание страницы № 4
INVERTER INFORMATION INVERTER INFORMATION Don’t Push It. power overload. Testing appliances and equipment with start up load ratings comparable to your inverter wattage Although your Whistler power inverter has the capacity to rating will not damage it. provide power output (excess current) equal to approximately two times its rated wattage capacity for a very brief period, If a piece of equipment or an appliance will not operate, it is designed to operate equipment and appliances with first con
Краткое содержание страницы № 5
BATTERY/CABLE INFORMATION BATTERY INFORMATION 1. To calculate the Ah of the battery, first determine its • It may be advisable to operate the inverter from a bank "reserve minutes" rating. (Deep cycle marine batteries of batteries of the same type in a "parallel" configuration. generally have the highest reserve minute ratings). This Two such batteries will generate twice the Ah of a rating typically is marked on the battery along with the single battery; three batteries will generate three "Col
Краткое содержание страницы № 6
OPERATION CABLE INFORMATION Making the Connection. Pro-2000W and Pro-2500W When the inverter and the battery are set up within three 1. Make certain that the Power switch is in the OFF (O) position. feet of each other, use a minimum of #2 gauge wire to make 2. Connect the cables to the power input terminals at the the connections. Within four to six feet, use a #0 gauge wire rear of the inverter and tighten the screws to make a (Pro-2000W), #00 gauge for Pro-2500W. At distances secure connectio
Краткое содержание страницы № 7
OPERATION OPERATION Note: 7. Confirm that the equipment or appliance to be • Loose connections can result in a severe decrease in operated is turned off. Plug the equipment or voltage which may cause damage to the wires and insulation. appliance into one of the AC receptacles on the front panel of the the inverter. • Failure to make proper connection between the inverter and the power source will result in reverse polarity. 8. Turn the inverter to the ON (I) position. Turn on the Reverse polari
Краткое содержание страницы № 8
OPERATION OPERATION The Power Source. • Check frequently to ensure that the input and output connections are secure. Loose connections When the engine is off, most batteries will provide ample power may damage the inverter, the power source, or to the inverter for one to two hours. The actual length of time may generate excessive heat. is a function of several variables including the age and condition of the battery, the number of batteries and the power demand being placed on it by the equip
Краткое содержание страницы № 9
OPERATION OPERATION Some Powerful Advice. 2. Change the relative positions of the inverter, antenna cables and television power cord. When driving with the inverter in operation, make certain that neither the inverter nor the power cords will impede safe 3. Isolate the television, its power cord and antenna cables operation of your vehicle. Keep the unit and all cords clear from the 12 volt power source by running an extension of the steering wheel, gas, brake and clutch pedals and gear shif
Краткое содержание страницы № 10
OPERATION OPERATING PRINCIPALS For You Technical Types. The modified sine wave produced by your Whistler inverter has a root mean square (RMS) voltage of 110 volts. The majority 1. Basic Operating Principles: of AC voltmeters measure RMS voltage and assume that the measured waveform will be a pure sine wave. Whistler inverters work in two stages. During the first stage, the DC to DC converter increases the DC input voltage from Consequently, these meters will not read the RMS modified the power
Краткое содержание страницы № 11
OPERATING PRINCIPALS/SUMMARY OPERATION SUMMARY • In the event of automatic shut down, turn the inverter In Review. OFF (O) immediately. Do not restart the inverter until the • Never attempt to operate your Whistler inverter from source of the problem has been identified and corrected. any power source other than a 12 volt battery or a • To avoid battery drain, always disconnect the inverter group of batteries that total 12 volts. when the vehicle is not in use for long periods. • Always make ce
Краткое содержание страницы № 12
TROUBLESHOOTING TROUBLESHOOTING PROBLEM: TV Interference Overload LED on Problem Solution Problem Solution Equipment has a high Turn inverter power switch Electrical interference from Add a Ferrite data line start up surge. OFF (O) and then ON (l) filter inverter. on to the TV power cord. again until the inverter This filter is available at powers your appliance. electronic supply stores. Repeat as necessary to get your appliance "started". Battery voltage below Recharge or replace PRO
Краткое содержание страницы № 13
SPECIFICATION SPECIFICATION Pro-1200W WATT INVERTER SPECIFICATIONS Pro-2500W WATT INVERTER SPECIFICATIONS Maximum Continuous Power . . . . . . . . . . . . . . . . . . . .1200 Watts Maximum Continuous Power . . . . . . . . . . . . . . . . . . . .2500 Watts Maximum Surge Capability (Peak Power) . . . . . . . . . .2400 Watts Maximum Surge Capability (Peak Power) . . . . . . . . . .5000 Watts No Load Current Draw . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .< 1.0A No Load Current Draw
