Краткое содержание страницы № 1
INSTALLATION
&
OPERATION MANUAL
Single Package
Vertical Air Conditioning System
B Series
18,000 24,000 30,000 36,000
42,000 49,000 60,000 Btuh
840-170-38
Краткое содержание страницы № 2
TABLE OF CONTENTS Vert-I-Pak B-Series Vertical Air Conditioning System Page Safety Considerations ....................................................................................................... 3 General Recommendations ............................................................................................... 3 Unpacking and Inspecting the Unit .................................................................................... 3 Supplies Needed for Installation ....................
Краткое содержание страницы № 3
SAFETY CONSIDERATIONS Improper installation, adjustment, alteration, service, maintenance, or use can cause explosion, fire, electrical shock, or other conditions which may cause personal injury or property damage. Consult a qualified installer, service agency, or your distributor or dealer for information and assistance. The qualified installer or agency must use factory-authorized parts or accessories when modifying this product. Refer to the individual instructions packaged with the parts o
Краткое содержание страницы № 4
Section I General Specifications ® VERT-I-PAK MODEL IDENTIFICATION GUIDE MODEL NUMBER V H B 36 K 10 RT A SERIES ENGINEERING CODE V=Vertical Series OPTIONS E=Cooling with or without electric heat H=Heat Pump RT = Standard Remote Operation DESIGN SERIES A = 32" Cabinet ELECTRIC HEATER SIZE B = 68" Cabinet NOMINAL CAPACITY B-Series B-Series (Btu/h) 18 = 18,000 36 = 36,000 60 = 60,000 05 = 5.0 KW 24 = 24,000 42 = 42,000 10= 10.0 KW 30 = 30,000 49 = 49,000 15 = 15.0 KW VOLTAGE 20 = 20.0 KW K = 208/
Краткое содержание страницы № 5
+ Value in ( ) is for the unit MODELS: V(E,H)B42K10 V(E,H)B42K15 V(E,H)B49K15 V(E,H)B49K20 V(E,H)B60K20 V(E,H)B60K25 power. Value outside of ( ) COOLING DA T A : is for electric heat only. See Page 12. Cooling Cap. 42000 42000 48500 48500 58000 58000 Cooling Power (W) 4500 4500 5500 5500 6450 6450 SEER 9.8 9.8 9.8 9.8 9.9 9.9 Cooling SHR 0.72 0.72 0.69 0.69 0.72 0.72 ELECTRIC AL HEA T DA T A : Heater Size (KW) 10.0 15.0 15.0 20.0 20.0 25.0 Heating Cap. (Btu/h) 34100 51150 51150 68200 68200 852
Краткое содержание страницы № 6
Figure 2 V(E,H)B42, 49 Unit Dimensions (Inches) Figure 3 V(E,H)B60 Unit Dimensions (Inches) Section III Installation Section III Installation Section III Installation Section III Installation Section III Installation TheVert-I-Pak was designed for installation in residential and light commercial applications. These instructions detail a typical method of installation. Figure 4 shows the typical component location and airflow paths through the unit. Units are available in three retu
Краткое содержание страницы № 7
Figure 4 Unit Configuration 1) INDOOR AND OUTDOOR AIR REQUIREMENTS The indoor and outdoor air systems are designed to operate at specified airflow rates and external static pressures. The supply and return air duct system pressure losses (including filter, louver/grille and registers) must not exceed the listed external static pressures for either the indoor or outdoor air systems. CAUTION: Failure to adhere to indoor air and outdoor air requirements as listed in the following sections will
Краткое содержание страницы № 8
Figure 5 VPBWP3 8/14 Wall Plenum For Models • VE/VHB18 VE/VHB24 Figure 6 VPBWP4 8/14 Wall Plenum For Models VE/VHB18 VE/VHB24 VE/VHB30 VE/VHB36 8
Краткое содержание страницы № 9
Figure 7 VPBWP5 8/14 Wall Plenum For Models VE/VHB42 VE/VHB49 Figure 8 VPBWP6 8/14 Wall Plenum For Model VE/VHB60 9
Краткое содержание страницы № 10
. . B. . Ducted Condenser Air . For ducted outside air applications, the combined pressure losses of the intake and discharge air paths must not exceed the external static capabilities of the system at the design airflow (See Table 3). Outdoor Fan Performance Table 1 Model 0.1 0.2 0.3 0.4 0.5 VE/HB18 1300 1180 1100 950 790 VE/HB24 1300 1180 1100 950 790 VE/HB30 1300 1200 1100 1000 810 VE/HB36 1730 1660 1600 1560 1400 VE/HB42 2100 2000 1900 1800 1700 VE/HB49 2600 2500 2400 2300 2100 VE/HB60 299
Краткое содержание страницы № 11
C. Indoor-Air (Conditioned Supply Air) System The VEB/VHB series unit may be applied in either a free return air configuration or a ducted return air configuration. The supply air path is intended to be ducted. The design and construction of the indoor-air system must provide adequate air distribution to ensure comfort levels throughout the structure. The combined pressure losses of the return and supply air paths must not exceed the external static capabilities of the system at the design air
Краткое содержание страницы № 12
2) Electrical DANGER: Electrical shock hazard. Turn OFF electric power at the fuse box or service panel before making any electrical connections and ensure a proper ground connection is made before connecting line voltage. Failure to do so can result in property damage, personal injury and/or death. A. Grounding CAUTION: The unit must be electrically wired and grounded in accordance with all state and local codes, national electric code, and NFPA 70. Unit and controls will NOT operate un
Краткое содержание страницы № 13
3) THERMOST 3) THERMOST 3) THERMOST 3) THERMOST 3) THERMOSTA A A A AT MOUNTING AND WIRING T MOUNTING AND WIRING T MOUNTING AND WIRING T MOUNTING AND WIRING T MOUNTING AND WIRING A. Thermostat Location Locate the thermostat about 5 ft. above the floor in an area with good circulation at average indoor temperature. Do not mount the thermostat where it may be affected by: Drafts or dead-air spots behind doors and in corners. Hot or cold air flow from ducts. Radiant heat from sun or appliances
Краткое содержание страницы № 14
4) CONDENSA 4) CONDENSATE DRAIN LINE TE DRAIN LINE 4) CONDENSA 4) CONDENSA 4) CONDENSATE DRAIN LINE TE DRAIN LINE TE DRAIN LINE The condensate drain exits the unit 2" above floor level at the right side front corner of the unit. The condensate drain line is already internally trapped therefore, no external condensate trap is required. Install a condensate drain line of the same size as the drain fitting on the unit. PVC plastic pipe (3/4 in. I.D.) makes an ideal condensate line (if local
Краткое содержание страницы № 15
Section IV OWNER'S MANUAL AND OPERATING INFORMATION IDENTIFYING YOUR SYSTEM Take the time to familiarize yourself with the type of system you have. This knowledge will be of use in understanding the basic operation of your unit. A self-contained unit, like the Vert-I-Pak, has all of its major components in one cabinet located inside your home. The unit does not have a separate outdoor unit like a traditional “split-system” air conditioner or heat pump. Figure 4 shows the location of the majo
Краткое содержание страницы № 16
to run for extended periods of time and may be assisted by the auxiliary electric resistance heating elements. Once you understand the operation of your new heat pump, you will appreciate its constant, even heat and lower energy consumption. Heat Mode Operation During the heat mode of operation, frost or ice may build up on the outdoor-air coil after operating for extended periods during particularly cool and humid weather. When this occurs, your heat pump senses this condition and goes through
Краткое содержание страницы № 17
System Control The SYSTEM or MODE control on your thermostat offers the following selections: COOL, OFF, HEAT, and EM HEAT. Neither the cooling nor heating equipment will operate when the SYSTEM or MODE control is set to OFF. With the SYSTEM or MODE control set to COOL, your unit will operate in cooling mode. With the SYSTEM or MODE control set to HEAT, your unit will operate in heating mode. Auxiliary Heating Your system also includes an auxiliary electric heating source. The SYSTEM or MODE con
Краткое содержание страницы № 18
PERFORMING ROUTINE MAINTENANCE With the proper maintenance and care, your system will operate economically and dependably. Maintenance can be accomplished easily by referring to the following directions. However, before performing any maintenance, consider these important safety precautions: WARNING: Electrical Shock Hazard. Before attempting any service work or routine maintenance, turn off all electrical connections to the unit. Failure to do so may result in property damage, personal injury
Краткое содержание страницы № 19
INSPECT AND CLEAN INDOOR-AIR COIL Eventually, minor amounts of lint and dirt may pass through the filter and collect on the indoor-air coil. These minor accumulations can be carefully vacuumed away with a brush attachment on a vacuum cleaner. Care must be taken to avoid bending the aluminum fins on the coil. Bent fins should be straightened using a special fin tool available from most HVAC service technicians. INSPECT OUTDOOR-AIR INTAKE AND EXHAUST The unit’s outdoor-air intake and outdoor-air e
Краткое содержание страницы № 20
Use Factory-Certified Parts FRIEDRICH AIR CONDITIONING CO FRIEDRICH AIR CONDITIONING CO.. FRIEDRICH AIR CONDITIONING CO FRIEDRICH AIR CONDITIONING CO FRIEDRICH AIR CONDITIONING CO... Post Office Box 1540 • San Antonio, Texas 78295-1540 4200 N. Pan Am Expressway • San Antonio, Texas 78218-5212 (210) 357-4400 • FAX (210) 357-4480 www.friedrich.com Printed in the U.S.A. 20
